查询词典 excess load

The results of its 1D test demonstrate that the MARED code is suitable for simulating implosions on different devices and with a wide range of load parameters. Combination of the wire-array Z-pinch experiment simulation and analysis shows that under the same load conditions, the X-ray radiation power produced by the tungsten wire-array implosion is much greater than the power generated by the aluminum wire array. With the same load current, the greater load mass gains the lower X-ray power.

结合丝阵Z箍缩实验的数值模拟和分析表明：相同负载质量条件下，钨丝阵内爆产生的X光辐射功率远大于铝丝阵产生的X光功率；相同负载电流条件下，负载质量越大，计算得到X光功率越低；X光功率随着负载电流增加而增加。

For the condition where both outlet states of cold plate are at superheated states, the mass flowrate for the fixed heating load is marginally higher than that of the smaller heating load, and the difference is insensitive to the rise of heating load. For this situation, the effect of accelerational pressure is negligible, and it is mainly attributed to two-phase/single-phase distribution pertaining to the effect of heating load.

若两冷板的出口均为过热状态下，固定热负载一端的流量会略多於施加瓦数较高的一端，且其差异量会随热负载不同而缓慢增加，在此一状况下，则加速度压降可以忽略不计，其原因在於单相／两相流在热负载下单相区与两相区所占的比重不同所致。

First, CLBAC, a central load balance mechanism based on AC is proposed in this paper to increase security. Second, a distributed load balance mechanism is proposed. In DLB, each user can pre-estimate the actual load of each cell by means of virtual distributed coordination function, and then access the cell whose load is the lightest.

本文首先提出基于接入控制器的集中式负载均衡策略以提高网络安全性，然后提出分布式负载均衡策略：各用户在接入网络的时侯，首先采用虚拟的分布式协调功能预测各小区的实时负载，然后接入负载最轻的小区。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 4 4.2 7.6 0.13 0.8 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR...Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 2 1.5 2.9 0.045 0.47 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 35.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无。。。

As to load model, it contains unbalance dynamic load, wheel flaw, abrasive load and rail gap exciting load.

在车辆的响应分析中，对于载荷模型可以分为：动不平衡载荷；轮缺陷及其擦伤载荷以及直轨道轨缝、接头处引起的激振载荷。

Self-balanced loading test is a static load test method, in which load cell is embedded in the pile exerts load. Double load cell technique refers to meeting different designing needs.

摘要］自平衡试桩法是通过埋置于桩身中的荷载箱施加荷载的一种新型静载试验方法。

Journal bearing vibration on turbine units of peak load regulation often occur obvious changing in short time because of its load change. if this change excess some standards, it might lead to abnormal shutdown of the the unit.

调峰机组由于经常需要在变负荷状态下运行，机组轴系振动往往会在短时间内产生变化，如果这种变化超过允许标准，将导致机组非正常停机，不能完成调峰任务。

Erection parameters in the literature [9] nonlinear analysis method used to calculate some of the variables erection capacity limit, but no major erection of some other variables, such as the level of the top-Ligan excess of the limit load length the impact of, and the top model Ligan more displacement constraints, and the actual situation of access to a certain extent; literature [7] space will be just as Falsework framework erection of the main parameters of the critical load, and The literature [10] scaffold for the ultimate strength estimation method for calculating the results of the amendment.

在搭设参数方面，文献[9]采用非线性分析方法，计算了部分搭设变量下的极限承载力，但是没有分析另外一些主要搭设变量如立杆超出顶层水平杆长度对极限承载力的影响，而且计算模型的顶部立杆位移约束较多，和实际情况有一定的出入；文献[7]将模板支架视为空间刚框架，分析了主要搭设参数下的临界荷载，并采用文献[10]提出的用于外脚手架极限承载力的估算方法对计算结果进行了修正。

Uses the biggest strength training method (80%～100% biggest strength) adding 30% biggest strength load training method; the load combination method to make the acclivity to lie pushes the barbell training, good in uses; the biggest strength training method to the upper limb shot fast strength training effect (80%～100% biggest strength) adding the unarmed quickest speed training method and the biggest strength training method (80%～100% biggest strength) adding 60% biggest strength shoulders the training method the load combination method.

用"最大力量训练(80％～100％最大力量)+30％最大力量负荷最快速度训练法"负荷组合方法做上斜卧推杠铃训练，对推铅球上肢快速力量的训练效果好于用"最大力量(训练80％～100％最大力量)+徒手最快速度训练法"与"最大力量训练(80％～1 00％最大力量)+60％最大力量负荷最快速度训练法"负荷组合方法。

The method which is used to measure and compute moment, yield and turning angle by steel bar gauge is introduced in detail. According to the measuring results, the horizontal critical load of the testing pile is 120 kN. The steel bar gauge measuring results show that the largest moment is located in the depth from 2 m to 3 m under the horizontal load, it transfers to the deeper location with the increase of the horizontal load, and the bend distortion only occurs in the upper of 1/3 pile length.

结合实际工程详细地介绍了利用钢筋计测试水平荷载作用下桩身弯矩、挠度和转角分布的方法，根据桩顶位移和钢筋内力测试结果判定试验桩的水平临界荷载为120 kN；根据钢筋计测试结果可知，在水平荷载作用下，桩身最大弯矩截面位于在地面以下2～3 m处，且随着荷载的增大最大弯矩截面逐渐向深部转移；发生弯曲变形的部分主要是桩长1/3以上的桩体，而其下的桩体几乎不发生变形。

There are two types of gold deposits in this area, namely altered rock type and quartz vein type.

本区金矿床包括两种类型：柴胡栏子金矿床为蚀变岩型金矿；莲花山和红花沟金矿床属石英脉型。

You were home and it was two weeks ago.

你回到了家里。当时是两周前。