查询词典 equal angles

The formulae were derived to calculate the spherical coordinates of any vector after the specimen was rotated any angles around any axis based on the homogenous coordinate theory.

摘 要：在利用同步辐射进行晶体缺陷的形貌研究时，为了获得晶体缺陷的三维分布信息，在实验中样品要在样品台上沿不同方向旋转轴进行多次旋转，因而需要计算样品经过多次旋转后任意矢量的空间坐标以及缺陷的取向坐标。

But the differences are the corresponding bond lengths and bond angles.

但在两个分子中相应的键长和键角是不同的。

This requires the loads in the clamps connecting the body to the table, and the corresponding tilt angles to be measured.

这需要测量连接刚性体和平台的夹具负载和相应的倾斜角度。

Then, Combining competitive environment and competition current situation of textile enterprises in our country, it provides upgrading strategic choices and corresponding administration measures from two angles of enterprises and the government.

并结合我国纺织企业所处的竞争环境及其竞争现状，给出了我国纺织企业基于全球价值链的升级战略选择，并从企业和政府两个角度给出了相应的治理措施。

The corresponding mean kyphotic angles at 3 days and 3, 6, and 12 months after surgery were 15.5°,15.6°, 17.2°, and 17.1°, respectively.

患者术后3天、3个月、6个月、12个月的平均后凸角为15.5°、15.6°、17.2°、17.1°。

This article first briefed the mechanical and electrical products export development present situation; Then has carried on the analysis on TBT to the mechanical and electrical products export's influence and the origin; Finally from the enterprise, the government two wide angles proposed the corresponding countermeasure separately

本文首先介绍了机电产品出口的发展现状；然后就TBT对机电产品出口的影响和成因进行了分析；最后分别从企业、政府两大角度提出了相应的对策。

Critical load and relevant crack length and displacement data from these experiments were used in a finite element model to calculate the crack tip mode angles, and corresponding critical energy release rate.

以试验测得的临界载荷及对应位移、裂纹扩展长度为条件，建立与测试装置对应的有限元模型，计算裂纹尖端模式角及在此模式角下的临界能量释放率。

The above parameters and their corresponding crank angles show the higher inter-dependency with the increase of hydrogen fraction at lean mixture operation.

在化学计量比或浓燃时，掺混氢气可以维持平均指示压力的循环变动系数在较低的水平。

Consequently, when initializing individual shapes for rendering, the corresponding start and sweep angles have to be transformed by the following method

因此，当初始化渲染单个形状，相应的启动和扫描角度，必须由以下方法转化："/页"保护浮动TransformAngle

Differential equations of the corresponding deformations, turning angles and bending moments are deduced and the solutions of these models are given.

分析表明，管棚的最大挠度和最大剪力出现在掌子面附近已开挖未支护的部分，掌子面前方1.5~2.0倍开挖高度范围内的围岩有变形和松动。

I hope that this success is just the first in a long series.

我希望这只是成功的开始。

Three dimensional stresses on the interface of tire and soil, tire deflection and soil sinkage are measured.

测试轮胎——沙土界面上的三向应力、轮胎变形和沙土沉陷；建立考虑剪切应力对沙土承载特性产生影响的车轮牵引性能预测模型；分析车轮作用下土壤的纵向稳定性。