查询词典 dynamic friction

In order to reduce ships when the plate between the equipment and the plate friction, has used the roller transmission, causes between the equipment and the plate friction way becomes the rolling friction, maximum limit reduced in the equipment work to the plate attrition.

为了减少在板材运送时设备与板材之间的摩擦，采用了辊传动，使设备与板材之间的摩擦方式变为滚动摩擦，最大限度的减小了设备工作中对板材的磨损。

The results indicate that when soil and pile are same, the shear stresses between pile and soil under the ultimate situations of different modes are different; the negative friction on pile induced by surcharge is maximum; and the negative friction of uplift pile is minimum; the friction of pile top induced by pressing pile and bottom-loaded pile is between them.

结果表明，同种土体和桩体条件下，各种模式达到极限状态时桩－土间剪切应力不同，堆载作用下负摩擦力值最大，抗拔桩负摩阻力值最小，桩顶受压桩、托桩的摩阻力值介于其间；桩材泊松比在0.15~0.35范围内时，桩侧摩阻力随泊松比的增大而增大。

Taking the friction into account and based on the empirical relation for flow friction in circular tube, the paper developed a correlation for the friction factor of gas-solid flow in riser.

参照圆管中的单相流动，考虑提升管几何参数和操作参数的影响，通过定量分析提升管内气固悬浮物与管壁间的摩擦，提出了对表观颗粒浓度的修正式，修正浓度与实际浓度吻合良好。

The tests showed that the tension of each hoop cable and radial cable distributed unevenly under various working conditions,because of the friction between hoop cable and joints.Compared with the traditional joints,using new joints in structure could make the friction between hoop cable and joints reduce obviously,and friction loss on hoop cable at joints was small.

试验表明，由于环索与节点间存在摩擦，使得各工况下结构各圈环索和斜索张力分布不均匀；与传统节点相比，采用新型节点的结构环索与节点间的摩擦大幅降低，环索预应力损失较小，预应力传递效率更高。

Next, in ADAMS, friction coefficient database is set up, and dialog box for defining joint friction is extended based on analyzing joint friction in mechanical system, and the method of parametric analysis is discussed for analyzing manufacture errors influence on mechanism performance.

然后，建立了受电弓虚拟样机模型，基于该模型主要研究了运动副摩擦引起的升弓轨迹和升弓扭矩的运行误差；在ADAMS环境下建立受电弓的三维参数化模型，讨论了制造误差对受电弓升弓轨迹的影响。

The needle would stop rolling to maintain the friction effect between the needle and tested tissue when this friction moment come to the driving moment of the friction coupler.

二、在驱动电机和刺激针之间设计一个摩擦耦合器，当刺激针和组织之间的摩擦力矩达到摩擦耦合器的驱动力矩后，刺激针就会停止转动并能保持住对组织的摩擦。

Experimental results show that: bearing capacity of JPP is thirty percent higher than that of cast-in-place pile which has the same length and diameter with JPP. The deformation of JPP is controlled by core pile; axial force distribution of PHC is different with soil-cement; and their axial force ratio in same section is their elastic modulus ratio. Distribution of inner and outer friction resistance is similar; and the inner friction is about 1.62 times of the outer one; it is about the ratio of JPP diameter and PHC diameter. Furthermore, the relation between friction resistance and relative displacement is similarly hyperbolic; and the relation between dip resistance and displacement is also hyperbolic.

试验结果表明，JPP桩与同桩长、同桩经灌注桩相比承载力高30%以上；JPP桩变形由芯桩控制，管桩轴力分布与水泥土轴力分布规律不一致，但同一截面上管桩和水泥土的轴力比值约为其弹性模量的比值；内外摩阻沿桩身的分布规律类似，内摩阻是外摩阻的1.62倍左右，约为JPP桩直径和管桩直径的比值；桩侧摩阻力与桩土相对位移近似双曲线分布，桩端阻力和桩端位移也近似双曲线分布。

Typically service brakes are concerned with dynamic coefficient of friction, or the coefficient of friction measured while the vehicle is moving.

典型工作条件下的刹车与动摩擦因数，即当车辆行驶时测出的摩擦因数有关。

Because of the small difference between the static friction coefficient and the dynamic friction coefficient of DF-5S slide, it avoids the squirming phenomenon in the restarting-up process efficiently and lowers the severe wear in the restarting-up process.

由于DF-5S铜基镶嵌滑块的动静摩擦系数的差值小，有效地避免了启动过程中的蠕动爬行现象的发生，降低了启动过程中的剧烈磨损。

My main production TSF Academy Soft Machine Tool belt and matching adhesive used primarily for machine tool guideways, abrasion resistance, static and dynamic friction coefficient of the difference small, not crawling, positioning accuracy, and has enough anti-aging and physical properties of mechanical is to improve the machining precision, extended service life Guide the best choice, the products applicable to all types of machinery and equipment manufacturing friction vice and maintenance.

我院主要生产TSF机床导轨软带与配套使用的胶粘剂，主要用于机床导轨，抗磨损，静动磨擦系数差值小，不爬行，定位准确，并具有耐老化和足够的机械物理性能，是提高机床加工精度，，延长导轨副使用寿命的最好选择，本产品适用于各类机械设备磨擦副的制造与维修。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"