查询词典 drying loft

A series of radio frequency/vacuum drying tests were conducted on boxed-heart lumber of Japanese plantation species, sugi, and its drying characteristics and corresponding RF/V conditions were investigated.

该文对日本人工林柳杉髓心方材进行系列高频真空干燥试验，掌握不同高频真空干燥条件下柳杉髓心方材的干燥特性并对干燥缺陷进行分析。

The results showed that, though the sugi square lumbers were difficult to dry, we can better the drying quality especially with less checks if adopting some special pre-treatment methods before the RF/V drying, such as, steaming and superheated-steaming on sugi lumbers, and making a kerf along the...

结果表明，柳杉髓心方材虽难干燥，但在高频真空干燥前对木材进行合理的处理，如蒸汽和过热蒸汽预处理、沿木材长度方向制作一定深度和宽度的切口等，可有效地提高干燥质量，尤其是可减少开裂的产生。

After a series of radio frequency/vacuum drying tests were conducted by using boxed-heart lumber of Japanese plantation species, Sugi, the drying characteristics and corresponding RF/V conditions were investigated.

对日本人工林木材柳杉髓心方材进行系列高频真空干燥试验，掌握不同高频真空干燥条件下柳杉髓心方材的干燥特性并对干燥缺陷进行分析。

No relationship between this and the sun, but too much exposure a child's face would turn red, skin tanning and even sunburn, so do not directly face the sun, the general drying drying hands, feet, buttocks and other places on the list, as we choose the time at 4 , 5 o'clock the sun is not particularly powerful time out for good.

这个和晒太阳没什么关系，但过分曝晒会使孩子的脸变红，皮肤晒黑甚至晒伤，所以别直接晒脸，一般晒晒手，脚，屁股等地方就行了，时间也尽量选择下午4、5点钟太阳不特别厉害的时间出去为好。

After drying at low temperature, sintering, acid-washing, water-washing,filtration and drying at high temperature. Tantalate or Niobate compound was got finally. As compared with traditional proce...

用新工艺生产的钽或铌酸盐化合物用于制备钽或铌酸盐晶体时，从根本上克服了传统方法固体粉末混料不均匀等缺点所造成的质量不稳定的问题。

Bond strength may be an easy way to test: If the cover page with a coating material or fabric, and so on and Board bond, of post-drying in bond over time, will cover material on jeyang to pull apart, should be able to bring push-out of cardboard surface tear tape, books and cover bond tore post-drying reached does not open or a leaf out of another layer of still being bonded on it, you can achieve the requirements.

黏结强度可用下述简单方法测试：如封面用涂布类材料或织品等与纸板黏结，在黏结干燥后的一定时间，将封面料揭撕开时，应能把被黏结的纸板表面也撕带下一层，书册与封面黏结干燥后达到撕不开或撕下一层，而另一层仍被黏结在上面，即可达到要求。

According to the observation of the microstructure of small diameter lumber with scan electron microscope, there are many bordered pits of the radial trancheidal wall in the small-diameter Larch, and most of them have pit film. The resin is not only in resin canal, but also in some trancheid and ray parenchyma cells. The drying defects of small-diameter Larch lumbers were the most severe in consecution heating, fluctuating-heats 2h in between, and drying defects were nearly not observed in fluctuating-heats 6h. There is tylosis in the vessel of the heartwood of small-diameter Cathay poplar. The bordered pits of the radial trancheidal wall are dense, and the pits between vessels are alternate, most of them have pit film. Different collapse happened in all the small-diameter Cathay poplar lumbers. The collapse of small-diameter Larch lumbers was the most severe with consecution heating, fluctuating-heats 2h in between, the least with fluctuating-heating 6h.

通过扫描电镜观察发现，小径木落叶松的径壁具缘纹孔数目较多，且多具纹孔膜，小径木落叶松除在树脂道中含有树脂外，在一部分管胞胞腔内以及一些木射线细胞中也含有树脂，在产生缺陷的小径木落叶松锯材中，连续加热方式下锯材的开裂缺陷最为严重，波动2时次之，波动6时几乎没有开裂现象；小径木大青杨心材导管中的层状浸填体含量较多，且径壁具缘纹孔较为密集，管间纹孔呈互列方式，绝大多数纹孔具有纹孔膜，干燥后的小径木大青杨锯材均有不同程度的皱缩现象产生，其中连续加热干燥试验锯材的皱缩现象最严重，波动2时次之，波动6时干燥试验锯材的皱缩缺陷最小。

Based on the raw material conditions of pelletizing process at Ma Steel the process parameters, such as bed depth of grate, temperatures of updraught drying , downdraught drying, preheating and roasting in oxidized pellet production were studied with a grate-kiln simulator.

基于马钢球团原料条件，在模拟试验装置中研究了链箅机—回转窑氧化球团生产的料层高度、鼓风干燥热风温度、抽风干燥热风温度、预热热风温度和回转窑焙烧等工艺参数。

From the "" to wet-membrane "" viscostty dry film evolves, you can see any of the oils or gloss drying or curing process must go through the process of viscosimetry products, that is solid oils or varnish, mostly due to its own power, but was decoratine adhensive in coated packaging business card printing and membership card making products surface, it is not possible to immediately contiguous becomes solid continuous gloss films, only up to a certain conditions in order to complete all of the varnish coating to the drying process of prefilming.

从"湿膜"到"干膜"的粘度变化过程中，可以看到：任何一种的底油或光油的干燥或固化过程必然都要经历该产品粘度的变化过程，即是固体的底油或光油，由于其本身多为粉末状，但在装饰粘附在被涂布的包装制卡和会员卡制作制品表面后，还不可能立即就形成连续进行变成为固体连续光油薄膜的过程，只有达到一定条件才能完成全部的由光油涂布到干燥成膜的过程。

Natural volatilization drying, needs at least 30 minutes surface drying,weather condition and printing condition.

自然挥发干燥，表干约需30分钟，实干24小时以上(因气候及印刷环境不同有差异)。

Yet, Edith says, there was always money in the bank.

但是Edith说，她的银行户口里面总是有钱。

We have created a series of files that resolve this problem--one for each day of the 40 days of purpose.

我们制作一系列的档案去解决这问题---一个为标竿40天中的每一天。