查询词典 depth charge

The maximal depth model for single-pass milling process, the depth and surface roughness for plane surface are established. The milled profile of a single-pass milling of the jet can be modeled as a cosine curve of the form. Therefore, the maximal depth model for single-pass milling is established which indicates the quantitative relationship between the AWJ single-pass milling depth and the milling parameters.

假设磨料水射流单次铣削时的工件横截面形状为余弦曲线，建立了磨料水射流单次铣削的最大深度模型，分析了水射流压力、磨料流量、靶距、喷嘴横移速度、横向进给量和喷嘴直径及材料性能参数对单次铣削最大深度的影响规律。

The results indicate that multiple reflections are favorable to the increase of depth. When the focal position is above the surface, the absorptive intensity on the front decreases, so the cutting depth decreases. When the focal position is below the surface, the position on the front with the maximum power intensity is downward. The intensity distribution is toward the deeper position, the cutting depth increases. But if the negative focal distance is extremely big, the intensity of the deeper position attenuates sharply with the increase of focal radius and light distances, so the depth deceases.

正离焦切割时，前沿吸收的总激光功率密度减小，切割深度减小；负离焦切割时，最大激光功率密度值的位置下移，使得前沿功率密度分布朝着深部推进，切割深度增加，若负离焦量过大，表面光斑直径和光程增加，更深位置的功率密度减小，切割深度减小；随着激光功率增加、切割速度减小，则前沿弯曲程度减小，被激光直接照射的前沿部位增长，前沿吸收激光功率密度增加，切割深度增加。

In this paper, Newton iteration formula for computing normal depth and critical depth was put forward by mathematical transformation of uniform flow equation and critical flow equation of circular section tunnel. Then, the relationship between the corresponding central angle and the introduced parameters was analyzed. An approximate formula for angle was obtained according to optimal uniform approximation principle. Using this approximate formula as initial value of iteration formula, a direct formula for calculating normal depth and critical depth of circular section tunnel was established after its first iterative.

该文通过对圆形断面均匀流方程与临界流方程的数学变换，分别得到其正常水深与临界水深的牛顿迭代公式，同时，通过对正常水深与临界水深对应的中心角与引入参数之间关系的分析及数值计算，利用最优一致逼近原理分别得到了正常水深与临界水深对应中心角的近似计算式，并以此近似计算式为初值，用迭代方程进行一次迭代得到了圆形断面均匀流水深与临界流水深的直接计算公式。

To analyze the pseudo phenomena caused by migration velocity error, the paper firstly studied the depth error between post-stack migration and prestack migration caused by same velocity error, and found the depth error was only relative to velocity error and had no direct matter with methods of depth migration (post-stack migration or prestack migration). Then the paper did numerical simulation of a complex lenticular body model with wave-equation modeling and migration, and found that the velocity error could not only induce depth error, but also could change the modality of construction and the event of subjacent layers. Furthermore, it could change the frequency of reflective event. They are the pseudo phenomena caused by migration.

从分析偏移速度误差带来的各种假象出发，本文首先对比分析了速度误差对叠后深度偏移和叠前深度偏移的影响，发现偏移剖面的深度误差仅与速度模型的误差有关系，与具体的偏移方法没有直接的关系；然后对一个复杂的透镜体模型进行了波动方程叠后正演和偏移计算，详细地讨论了不同的速度误差带来的各种假象，发现速度误差不仅会带来深度误差，而且会造成构造体的形态变化，下覆地层同向轴的扭曲，还可能引起地层同向轴的频率发生变化，给资料解释带来一定的假象。

The experimental values of resistance force and power for the biomimetic furrow opener surface with UHMWPE tubular section ridges at 100 mm depth and 0.28 m/sec speed were 0.60 kN and 0.16 kW, while at 100 mm depth and 0.92 m/sec speed, the values were 0.80 kN and 0.72 kW. At 135 mm depth and 0.28 m/sec speed, the biomimetic furrow opener surface with UHMWPE tubular section ridges recorded 0.76 kN and 0.21 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 0.95 kN and 0.85 kW. The predicted and experimental values of resistance force and power for the conventional surface furrow opener were higher than predicted and experimental values for the biomimetic furrow opener surface with UHMWPE tubular section ridges.

对于超高分子量聚乙烯材料仿生脊型非光滑结构表面，当耕深100 mm和耕作速度0.28 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.6kN和0.16kW；当耕深100 mm和耕作速度0.92 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.8kN和0.72kW；当耕深135 mm和耕作速度0.28 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.76kN和0.21kW；而当耕深135 mm和耕作速度0.92 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.95kN和0.85kW。

The first case is the variable depth with a fixed notch-width and the second case is variable width with a fixed notch-depth. It can be observed fromthe moment-curvature curve of the first case that the magnitude of the moment is larger for the deeper depth than that for the shallow depth.

由有限元素ANSYS 分析结果可以观察出，在控制固定曲度做循环弯曲负载时，弯矩－曲度曲线图显示出，在固定凹槽的宽度，当深度较浅时，达到设定的控制曲度所需施加的弯矩相对於凹槽深度较大的圆管要大的多。

For the first time spud drilling: at 22:00 on the December 31, 2009 using the 26 " drills, earth-moving polymer drilling fluid depth of 16.40m for the first time since the Park, the drilling, at 06:00 on January 4, 2010 to the depth of drilling 262.5m, horizons Upper.fars Group at its first drilled, January 5 Electrical Measurement finished, at 04:00 on the 6th, under 20 " cementing casing to the depth of 261.50m, water, mud back to the ground, the cement plug surface depth of 248.50 m, casing pressure test with water 10.0MPa qualified, January 8 cementing electrical measuring the quality of finish, drill cement plug at 20 o'clock on the 10th end, the end of a job opening.

下面这段中文，希望网友帮忙译为英语：第一次开钻钻进：2009年12月31日22：00使用26&钻头、搬土聚合物钻井液自园井深16.40m第一次开钻，2010年1月4日06：00钻进至井深262.5m，层位Upper.fars组第一次完钻，1月5日电测完，6日04：00下20&套管至井深261.50m固井，水泥浆返至地面，水泥塞面井深248.50m，套管清水试压10.0MPa合格，1月8日电测固井质量完，10日20：00钻水泥塞完，结束一开工作。

Attention to the depth of the charge must not be re-depth of discharge, it will greatly reduce the battery life, because the depth of discharge will reduce the number of battery electric red.

深度的充电后注意一定不要再深度的放电，这样会极大的减少电池的寿命，因为深度的放电会减少电池的冲电次数。

In this paper,a new concept of the depth charge with projectiles is put forward from the cargo projectiles used in the ground guns,in order to improve the interception probability of the depth charge.

火箭深弹是水面舰艇拦截鱼雷的常用武器，为提高火箭深弹拦截鱼雷的概率，提出了子母深弹的概念，将地面火炮中常用的子母弹技术应用于深弹反鱼雷攻击中，通过分析子母弹的散布特性，来比较子母深弹和火箭深弹毁伤鱼雷的效能，并通过Monte-Carlo法仿真了这一过程，分析了影响子母深弹的毁伤概率的因素。

Now the fire range and fire precision of rocket depth charge has been improved,and it will make the source of the rocket depth charge s wasted and affect the hit probability raised if we still use the old fire strategy.

火箭深弹射程与射击精度提高后，如再沿用以固定发射间隔，对同一瞄准点齐射的方法对潜射击会造成资源的浪费，影响毁伤概率的提高。

I had a lovely dog named PiPi, he was one of my best friends.

我曾经有过一只小狗，它的名字叫皮皮，它很善良，它是我最忠实的朋友。

Newly ovulated mouse oocytes were cultured in the CZB medium supplemented with different concentrations of pyruvate before treated for activation or assayed for MPF activity.

我们猜测卵母细胞在不含丙酮酸的条件下老化的更快，并且卵丘细胞可能通过消耗不含葡萄糖的CZB中的丙酮酸从而促进卵母细胞老化。