查询词典 density matrix

objective to investigate whether hypoxia preconditioning exist in adipose tissue,and construct the hypoxemic model of adipose tissue.methods after injected different density cocl2 to rat's subcutaneously of groin,use immunohistochemical method detect hif-1α protein,and use rt-pcr detect hif-1α mrna.results after injected different density cocl2,the adipose tissue of rat's groin express different degree of hif-1αprotein and hif-1αmrna.,and reach the peak when the density is 20-40 mg/kg and the time is 3 h.conclusion hypoxia preconditioning exist in adipose tissue,and the effect of preconditioning is most evidence when the density is 20-40 mg/kg and the time is 3 h.

目的 探讨脂肪组织中是否存在缺氧预适应现象，构建cocl2致缺氧的缺氧模型。方法不同浓度的cocl2大鼠腹股沟区皮下层浸润注射，分别用免疫组织化学法和rt-pcr法检测该区脂肪hif-1α蛋白和hif-1α mrna的表达情况。结果用不同浓度的cocl2行化学缺氧后在不同时间点观察有不同程度的hif-1α蛋白和hif-1α mrna表达，其中，在浓度为20～40 mg/kg，时间为3 h时脂肪组织中hif-1α表达达高峰。结论脂肪组织存在缺氧预适应现象；cocl2的浓度选择20～40 mg/kg，时间选择3 h时缺氧预适应效果较佳。

The results were as follows the airdried density ( moisture content of wood is 12%), the basic density and the ovendry density were 0.583 g·cm-3, 0.462 g·cm-3 and 0.507 g·cm-3 respectively, the airdried density was at the medium level in domestic wood species;the shrinkage coefficient of radial, tangential and volumetric were 0.099%, 0.183% and 0.296% respectively, the maximum swelling were 4.106%, 7.958% and 12.627% respectively;the ratio of tangential shrinkages to radial shrinkages was 1.5-1.9;the toughness was 52.12 kJ·m-2;the hardness of cross, radial and tangential section were 41.53 MPa, 31.41 MPa and 35.51 MPa respectively;the compressive strength parallel to grain was 44.50 MPa ;the modulus of elasticity in static bending and the bending strength were 12.63GPa and 127.31 MPa respectively;the shearing strength parallel to grain of radial and tangential were 8.76 MPa and 10.54 MPa respectively;the cleavage strength to grain of radial and tangential were 124.3 N·mm-1 and 138.6 N·mm-1 respectively.

结果表明大叶栎木材的气干密度（含水率为12％）、基本密度和全干密度分别为0.583 g·cm-3、0.462 g·cm-3和0.507 g·cm-3，气干密度属于国产木材的中等级水平；径向、弦向和体积干缩系数分别为0.099%、0.183%、0.296%，湿胀率依次为4.106%、7.958%和12.627%，差异干缩为1.5-1.9，其尺寸稳定性较好；冲击韧性为52.12 kJ·m-2，端面、径面和弦面硬度分别为41.53 MPa、31.41 MPa和35.51 MPa，顺纹抗压强度为44.50 MPa，抗弯弹性模量和抗弯强度分别为12.63 GPa和127.31 MPa，径面和弦面顺纹抗剪强度分别为8.76 MPa和10.54 MPa，抗劈强度依次为124.3 N·mm-1和138.6 N·mm-1。

The results were as follows: the air-dried density(moisture content of wood is 12%),the basic density and the oven-dry density were 0.583 g·cm-3,0.462 g·cm-3 and 0.507 g·cm-3 respectively,the air-dried density was at the medium level in domestic wood species;the shrinkage coefficient of radial,tangential and volumetric were 0.099%,0.183% and 0.296% respectively,the maximum s...

结果表明：大叶栎木材的气干密度(含水率为12%)、基本密度和全干密度分别为0.583 g.cm-3、0.462 g.cm-3和0.507 g.cm-3，气干密度属于国产木材的中等级水平；径向、弦向和体积干缩系数分别为0.099%、0.183%、0.296%，湿胀率依次为4.106%、7.958%和12.627%，差异干缩为1.5-1.9，其尺寸稳定性较好；冲击韧性为52.12 kJ.m-2，端面、径面和弦面硬度分别为41.53 MPa、31.41 MPa和35.51 MPa，顺纹抗压强度为44.50 MPa，抗弯弹性模量和抗弯强度分别为12.63 GPa和127.31 MPa，径面和弦面顺纹抗剪强度分别为8.76 MPa和10.54MPa，抗劈强度依次为124.3 N.mm-1和138.6 N.mm-1。

Currently in a surface warship of the our country everyplace all provided with the sail coal gas body to report to the police the instrument on the boat, gas density that sensor adopt to convey gas density value traditional 4-20mA mode of analog signal, have to each measure passway allocate one is it is it report to the police to measure to have and density value show measuring board of function, as the density of gas measures the passway board of the different quantities of different outfit of the figure of the passway, but there is many figure of the large-scale naval vessel passway, so the volume of warning system will become very huge , unfavorable to attenbants to use, and traditional 4-20mA electric current ring transmits the signal, unfavorable to transmitting at a long distance, easy to bring and interfere.

核心提示：摘要目前在我国各地型水面舰船上都配备了航煤气体报警仪，气体浓度传感器采用的是传统的4-20mA模拟信号的模式传送气体浓度值，只好每个检测通道配备一块具有检测报警及浓度值显示功能的检测板，随着气体浓度检测通道数目的不同配备不同数量的通道板，但大型舰船通道的数目比较多，因此报警系统体积会变得十分庞大，不利于操作人员使用，而且传统的4-20mA电流环传输信号，不利于长距离传输，容易带来干扰。为了巡检的需要，需要将其改造成现场智能仪表，通过将传感器检测结果

With analysing the the fatigue mechanism, the general mode of interply fatigue damage propagation is denoted by delamination length and crack density. Based on the power-law, the relationship between number of cycles and delamination length and crack density are established. The specimen is modeled as an equivalent six-ply material system. Starting with the analysis of interply stress, the interply shear stress under cyclic loading is calculated by using nonlinear three-demension FEA. According to the stage regularity of fatigue damage propagation, such models as average strain, effective modulus, ratio of delamination length and crack density, experimental relationship between crack density and effective modulus, are proposed by introducing subsection coefficient.

通过对疲劳机理的分析，确定了以脱层长度和裂纹密度表示的层间疲劳损伤演化的一般模式，利用指数法则建立了脱层长度和裂纹密度随疲劳循环周次变化的关系；从层间应力分析入手，以等效六层的材料模型对循环载荷下的层间剪切应力进行了三维非线性有限元分析；根据疲劳损伤扩展的阶段性，引入分段系数，分别建立了平均应变与载荷循环周次的分段线性模拟模型、有效刚度随载荷循环周次的变化关系模型、裂纹密度变化和脱层长度变化关系随载荷循环周次变化的分段线性模型以及疲劳裂纹密度和有效刚度关系的经验模型。

The traditional distinction based on the matrix attribute reduction algorithm analysis, for distinction in the matrix "repeat" Too many elements, these "duplicate" elements not only in solving attribute reduction in the process does not work, But also reduce the time efficiency by improving the shortcomings that distinction in the matrix structure in the process of using Proposition calculus in the absorption of the law removed the distinction between the functions of the non-functional "repeat"element, a property Reduction of improved algorithm RADM, improve the efficiency of the attribute reduction.

通过对传统的基于区分矩阵的属性约简算法进行分析后，针对区分矩阵中"重复"元素过多，同时这些"重复"元素非但在求解属性约简的过程中不起作用，而且还降低时间效率这一缺点进行了改进，即在构造区分矩阵的过程中，利用命题演算中的吸收律去掉了在区分函数中不起作用的"重复"元素，提出了一种属性约简的改进算法RADM，提高了属性约简效率。

Adjoint matrix of matrix plays an important part during the matrix theory.

矩阵的伴随矩阵在矩阵理论中有着重要地位。

Linear algebra's adjoint matrix calculation of C language accompanying matrix definition : Matrix put...

线性代数之伴随矩阵计算C语言实现伴随矩阵定义：把矩阵所有位置上的元素替换为元素的代数余子式，即得原矩阵的伴随矩阵。

Linear algebra's adjoint matrix calculation of C language accompanying matrix definition : Matrix p...

线性代数之伴随矩阵计算C语言实现伴随矩阵定义：把矩阵所有位置上的元素替换为元素的代数余子式，即得原矩阵的伴随矩阵。

On the basis of the conversion relation of inverse matrix and adjoint matrix, by using 1/ω instead of |B'(xBx(subscript k|, a new Landweber iteration formula x(superscript δ subscript k+1)=x(superscript δ subscript k)-ωB'(x(superscript δ subscript k)Bx(superscript δ subscript kB'x(superscript δ kf(x(superscript δ subscript k)-y(superscript δ)is constructed for solving rank deficiency nonlinear least squares problem, with which the phenomenon that leads to ill-posed problem because the iteration matrix is rank-deficient and very ill-conditioned in numerical iterative process is avoided.

基于逆矩阵和矩阵伴随算子的换算关系，并用1/ω代替|B′(xBx(下标k|，构造出一个新的求解秩亏非线性最小二乘问题的Landweber迭代格式，x(上标δ下标 k+1)=x-ωB'(xBx(上标δ下标 k*B'x(上标δ下标 kf(x-y，从而避免了在迭代过程中由于迭代矩阵的秩亏和病态而产生的不适定现象。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"