查询词典 delamination

Controller in package carton should be placed in delamination, and delaminations should be comparted by plastic air bladder.

7.2.2 包装箱内的控制器分层放置，每层用气泡塑料膜分隔

The acid volcanic rocks of the Early Cretaceous Shangkuli Formation belong to continental crust anatexis type ones (S-type volcanic rocks) and may have formed by compression and migration of the Indian-Australia plate toward the NNE and delamination of the lower crust caused by the lithospheric extension in eastern China.

早白垩世上库力组酸性火山岩属陆壳重熔型火山岩，其形成可能与印度澳大利亚板块朝北偏东方向推挤运移、中国东部岩石圈拉张引起的下地壳拆沉作用有关。

Failure mechanics method is applied to analyze the effect of micro-cracks of matrix parallel to the fibres on delamination.

采用破坏力学的方法，深入地研究了分层尖端区内平行纤维的基体微裂纹损伤的演化及其对分层的影响。

The method (700) and circuit board panel (600) of the present invention substantially eliminate assembly-line delamination and sagging for circuit board manufacturing.

本发明的方法（700）和电路板板料（600），在电路板制造中基本上消除了装配线的脱层和下垂。

While it existed a fettle with social delamination which rooted adhere relation and number of fortune,the standard of costate and normal social delamination was potency、 education and morality that social unit had hold,it also decided personal position in the society.

其实质是社会过程中存在的社会利益关系及其不平等的利益分配格局在认知主体观念中的反映，与我们知识背景场中的阶级、阶层的概念意义相同。

It is found that, besides the delamination failure due to the interlaminar stresses, the main cause of the unduly-soon failure of the laminate lies in the fact that the strength of the delamination laminate is lower than that of the original laminate A method of modification is also given to allow for the edge-effect produced by using a specimen of finite width to measure ...

发现导致层合板过早破坏的原因，除了由于层间应力引起分层破坏外，主要是分层后的叠合铺层强度低于层合板强度；并给出了一般均衡对称的π/4层合板用有限宽试样测试拉伸强度时由于边界效应影响的修正方法。这是一种基于试验结果的经验方法。

In the FWT test, not the interfacial debonding, but the interlaminar delamination was observed. So the test results show that the interfacial peel strength is higher than the interlaminar peel strength. From the results of DCB experiment, a different fracture mode, namely IKP (initiation of interlaminar delamination, kinking into facesheet and propagation of interlaminar delamination), was found.

在平面拉伸试验中，发现的破坏模式不是预期的面芯界面脱胶破坏而是面板层间分层破坏；在双悬臂梁试验中，发现了一种与以往文献报导中不同的破坏模式(面板层间分层，预制裂纹偏转和面板分层扩展依次出现)。

By some typical numerical examples , the effects of delamination , hygrothermal and the progressive failure on the stability behaviors of the AGS plate and shell are discussed. The numerical results indicate that the effects of delamination , hygrothermal and progressive failure on the stability of composite AGS structures can not be neglected when the above factors result in a jump of the buckling mode.

通过典型算例讨论了湿热环境、累积失效及分层损伤等因素对复合材料 AGS结构稳定性的影响，数值结果表明当上述因素导致结构的屈曲模式发生突变时，其对 A GS结构稳定性能的影响是不容忽视的。

Following conclusions are concerning the strength of filament wound solid rocket motor case:(1) The inter-delamination is important for the strength of the case, and there are many factors, such as, the matrix, the interface, the fiber volume fraction, the fiber arrange pattern, to influence on the delamination.

最终结合宏观、细观两方面的研究和分析，并联系到纤维缠绕固体火箭发动机壳体的强度，可以得到如下结论：（1）壳体的内部脱层是导致壳体强度下降的重要原因，而影响壳体内部脱层的因素除了基体材料外还有界面，纤维的排列阵列、体积分数，壳体的铺层次序等。

With analysing the the fatigue mechanism, the general mode of interply fatigue damage propagation is denoted by delamination length and crack density. Based on the power-law, the relationship between number of cycles and delamination length and crack density are established. The specimen is modeled as an equivalent six-ply material system. Starting with the analysis of interply stress, the interply shear stress under cyclic loading is calculated by using nonlinear three-demension FEA. According to the stage regularity of fatigue damage propagation, such models as average strain, effective modulus, ratio of delamination length and crack density, experimental relationship between crack density and effective modulus, are proposed by introducing subsection coefficient.

通过对疲劳机理的分析，确定了以脱层长度和裂纹密度表示的层间疲劳损伤演化的一般模式，利用指数法则建立了脱层长度和裂纹密度随疲劳循环周次变化的关系；从层间应力分析入手，以等效六层的材料模型对循环载荷下的层间剪切应力进行了三维非线性有限元分析；根据疲劳损伤扩展的阶段性，引入分段系数，分别建立了平均应变与载荷循环周次的分段线性模拟模型、有效刚度随载荷循环周次的变化关系模型、裂纹密度变化和脱层长度变化关系随载荷循环周次变化的分段线性模型以及疲劳裂纹密度和有效刚度关系的经验模型。

This is not an ordinary box, which is used as a background picture of the dialog box, very pretty.

详细说明：这可不是一个一般的对话框，它是用图片作为背景的对话框，非常好看。

Conceal me what I am,and be my aid for such disguise as haply shall become the form of my intent.

遮掩我的身份，帮助我，我的面具将成为我的目的。