查询词典 deformation

We obtained the nasal deformation with three-dimensional reconstruction images and adjusted to separate the images of nasal cartilage, defined the form and structure of nasal deformation. Then we measured 10 cases of adult cadavers nasal alar, lateral and septal cartilage through modern mechanical measuring instruments, to obtain the elastic modulus of above three part structure of nasal cartilage, then to obtain more accurate nasal cartilage elastic modulus data through statistical analysis. At the same time, according to the relevant literature, we obtained nasal soft tissue biomechanical properties, mainly were elastic modulus and Poisson\'s ratio. Finally we established three-dimensional finite element analysis model of unilateral cleft lip nasal deformation, defined the model\'s constraint conditions and carried out biomechanical measurement and analysis of unilateral cleft lip nasal deformation.

将唇裂鼻畸形患者鼻部进行三维重建并调校，分离出外鼻软骨的影像，并对鼻部组织进行分层和重建，确定畸形鼻的形态和组织结构；通过现代力学测量仪器，对10例成人尸体鼻部的大翼、侧鼻和中隔软骨进行弹性模量的测量，获得上述三部分鼻部软骨结构的弹性模量数据，并通过统计学分析来获得较为准确的鼻部软骨结构的弹性模量数据，同时查阅相关文献，得到鼻部软组织的相关生物力学性质，主要为弹性模量和泊松比；建立单侧唇裂鼻畸形的畸形鼻部三维有限元分析模型，确定有限元分析的边界条件等，进行单侧唇裂鼻畸形的鼻部生物力学的测量和分析。

Such parameters as the percentage of ordinary reinforcment, amounts and configuration of unbonded prestressed tendons, the ratio of span to depth and the loading patterns were considered. Based on the results, the fomula for the eqivalent length of deformation zone on the beams at ultimate were developed. A simple formula was developed for the ultimate mid-span deflection of concrete beams with concept of equivalent length of deformation zone, and the deformation of beam before internal reinforcement yielding was predicted by the traditional formula for the deformation of partically prestressed concrete beam. Then an analytical model was deduced for analyzing the ultimate stress increment in those concrete beams prestressed with external or internal unbonded tendons based on the mid-span deflection.(4) Testes were carried out on a thin-walled concrete box beam presressed with external CFRP tendons to study its short-term performances under uniform load, long-term behaviors under uniform load, and full-time performance under four-point load in turn.

3以体内非预应力钢筋配筋率、体外预应力筋配筋率、体外预应力筋布置形式、预应力度、跨高比、荷载形式等为参数，用非线性分析程序对体预应力筋混凝土梁进行了参数分析，依据分析结果提出了以综合配筋指标和预应力度为参数的等效变形区长度的计算公式，进而提出了基于等效变形区长度的极限挠度计算公式；体内非预应力钢筋屈服前的挠度计算采用常用的部分预应力混凝土梁挠度计算公式；依据试验和非线性数值计算结果，将不同转向块布置形式的体外预应力混凝土梁简化为跨中一个转向块的体外预应力混凝土梁，推导了基于跨中挠度的体外预应力筋应力增量的简化计算公式。

Such parameters as the percentage of ordinary reinforcment, amounts and configuration of unbonded prestressed tendons, the ratio of span to depth and the loading patterns were considered. Based on the results, the fomula for the eqivalent length of deformation zone on the beams at ultimate were developed. A simple formula was developed for the ultimate mid-span deflection of concrete beams with concept of equivalent length of deformation zone, and the deformation of beam before internal reinforcement yielding was predicted by the traditional formula for the deformation of partically prestressed concrete beam. Then an analytical model was deduced for analyzing the ultimate stress increment in those concrete beams prestressed with external or internal unbonded tendons based on the mid-span deflection.(4) Testes were carried out on a thin-walled concrete box beam presressed with external CFRP tendons to study its short-term performances under uniform load, long-term behaviors under uniform load, and full-time performance under four-point load in turn.

3以体内非预应力钢筋配筋率、体外预应力筋配筋率、体外预应力筋布置形式、预应力度、跨高比、荷载形式等为参数，用非线性分析程序对体预应力筋混凝土梁进行了参数分析，依据分析结果提出了以综合配筋指标和预应力度为参数的等活动房效变形区长度的计算公式，进而提出了基于等效变形区长度的极限挠度计算公式；体内非预应力钢筋屈服前的挠度计算采用常用的部分预应力混凝土梁挠度计算公式；依据试验和非线性数值计算结果，将不同转向块布置形式的体外预应力混凝土梁简化为跨中一个转向块的体外预应力混凝土梁，推导了基于跨中挠度的体外预应力筋应力增量的简化计算公式。

Temperature deformation and autogenous deformation are the two major forms of deformation of hardening concrete in early age.

温度变形和自生变形是硬化混凝土在初龄期两种最主要的变形。

The instructive conclusion was: 1 under the vertical loading, the shear-lag effect was produced badly, more severer under concentrated loading than under uniform loading .2 the longitudinal bending deformation of the beam flange was true of the imitating plane assumption of deformation . 3 the width length ratio was confirmed as the first factor working on the shear-lag effect among all the geometric parameters;4 the shear-lag coefficient of simple-supported box-girder was severer than the continuous box-girder, the shear-lag effect in the inner supported section of continuous beam was much more severer, we need paying more attention for it in designing. 5 the non-liner characteristics of material deformation have littlie influence on shear-lag effect in BGCW. 6 the experiential calculating formulation and calculating diagram for the effective flange width was raised with the only factor of the width-span ratio., but the primary location of axis of bending moments should not be changed while calculating the inertial moment .

研究认为：1室内模型试验和空间有限元分析结果均表明波形钢腹板组合箱梁在竖向荷载作用下，翼板出现了典型的纵向应力剪滞效应。2在竖向荷载作用下，截面高度上各点纵向正应变分布认为可符合"拟平截面假定"，以此作为波形钢腹板组合箱梁抗弯计算的基本假定。3箱梁宽跨比是影响波形钢腹板组合箱梁翼板剪滞效应的主要因素。4连续波形钢腹板组合箱梁的翼板剪滞系数大于简支梁，且连续箱梁内支点截面翼板剪滞效应相当严重，对此需十分重视。5当混凝土翼板受力由弹性阶段进入弹塑性阶段时，材料的非线性特性对翼板的剪滞效应影响甚微。6提出了根据组合箱梁的宽跨比参数来计算翼板有效宽度比的经验公式和计算图表，但箱梁截面抗弯惯性矩的计算不应改变原先的截面中和轴位置。

The results showed that plastic deformation at both -70℃ and 180℃ made the dislocation density of AISI304 stainless steel increase with the increase of deformation. Martensite phase transformation was induced for deformation at -70℃, whereas it was not at 180℃. As the dislocation density increased, the breakdown potential of AISI304 stainless steel's passive film became a little more positive. As martensite phase content increased, it became more negative and pitting corrosion resistance decreased.

结果表明：加热180℃和低温-70℃条件下塑性变形均使AISI304不锈钢中位错密度随变形量增大而增加，AISI304不锈钢在-70℃条件下塑性变形时部分奥氏体相转变为马氏体相，而在180℃条件下塑性变形时不发生马氏体相变；位错密度的增加使AISI304不锈钢钝化膜的击穿电位略微正移，而马氏体相的增加使击穿电位呈负移趋势，材料耐孔蚀性能降低。

In this paper,Laterite soil adjacent to some stake of the highway in Chenzhou, Hunan section from Xiamen to Chengdu was used to investigate the deformation characteristics and protection methods of the Laterite soil subgrade under the influence of environment factors.Properties like water-holding capacity,capillary rise, coupled heat-moisture transfer and wetting deformation of samples under different compactness were studied through a series of laboratory tests.In addition,by using meteorological data of two consecutive years in Chenzhou,coupled process of moisture transfer and subgrade deformation was stimulated under the impacts of groundwater and the atmosphere.Specific work done in this paper is as follows:(1) Samples under different compactness were subjected to a series of conventional laboratory tests,such as permeability,consolidation,contraction,shear test and etc.

论文以厦门至成都高速公路湖南郴州段的红粘土为研究对象，以环境因素作用下红粘土路基的变形特征与防护方法为研究目的，通过室内试验研究了不同压实度红粘土的持水性能、毛细上升、湿热耦合迁移及湿化变形等特征，借助郴州地区连续两年的气象数据，模拟在地下水和大气的共同作用下路基内部红粘土水分迁移与路基变形的耦合过程，主要研究内容及结论如下：(1)针对不同压实度的红粘土，系统开展了其渗透、固结、收缩、剪切等试验研究。

New data of structural styles and geochronometry in the Dulong-Song Chay metamorphic dome indicate at least two epoches of major extensional tectonics: the D, deformation of the rising and exhumation of the dome occurred at 237-228 Ma; and the D2 deformation overprinted and re-deformed on the dome at 86-78 Ma. Of them, the D, deformation shows a consistent forming time, extensional direction and tectonic regime amongst the Dulong-Song Chay dome, South China block and the north margin of the South China Sea basin.

对位于华南地块西南缘的都龙－Song Chay变质穹隆体的研究表明，在中生代至新生代时期，至少经历了2期重要的伸展构造：D1期(237~228 Ma)穹隆的隆升与表露阶段，代表了印支期造山作用前的伸展构造；D2期(86~78 Ma)叠加和改造阶段，并有可能始于176~146 Ma，致使穹隆进一步隆升和表露。D2期构造在发育时间、伸展方向及变形方式等上既与华南地块同时期区域伸展构造特征相一致，也与南海盆地北缘早期扩张特征相一致。

Collected patients with unilateral cleft lip nasal deformation mainly expressed in the affected side of the alar collapse deformation, or simultaneously with the deflection nasal columella, nasal tip separation deformation, etc.

采集患者的单侧唇裂鼻畸形主要表现为患侧的鼻翼塌陷畸形，同时或伴有鼻小柱的偏斜、鼻尖的分离等畸形。

Texture is obtained by hot-pressing deformation at 700℃ with a deformation rate of 10－4～10－3/s and, with the increment of deformation ratio,(006) texture is further strengthened. In addition, the initial texture of Nd-Fe-B

在700℃，形变速率为10－4～10－3/s的热压变形工艺下，得到以(006)晶面的衍射峰为主峰的织构，即(006)织构，随形变量的增大，(006)织构进一步增强。

Pradeep Indulkar, a senior official at the Maharashtra state Home Ministry say 101 human were killed and 287 injured.

马哈拉施特拉邦内政部高级官员Pradeep Indulkar称，有101人在冲突中丧生，287人受伤。

Mark Frei, a senior vice president of West, says 80% of West's homeagents have some college education, compared with 30% of those whowork in office-based call centers.

Frei说，该公司80%在家办公的人员都拥有本科学位，而在公司电话中心工作的人中只有30%拥有本科学位。