查询词典 deflection ancle

When inertia force ofa transmission shaftdoesnotchange, itsmaximum transversaldisplacement is equal to the sum of the static deflection produced by inertia force and gravity and the amplitude ofdeflection induced by eccentric mass, and when inertia force of a transmission shaft changes, dynamic deflection is produced.

惯性力不变时，传动轴的最大横向位移等于惯性力和重力产生的静挠度与质量偏心产生的动挠度幅值之和；惯性力变化时，传动轴产生动挠度。

Based on the crack control criterion, the deflection control criterion in ultimate state of service and the strength control in the ultimate state of load-carrying capacity and the nominal steel percentage of section of beam, the formulas for the calculation of the control moment capacity of T-beam and bridge under the limiting deflection condition、the limiting cracking condition and the ultimate strength state were given, respectively.

在提出名义配筋率概念的基础上，基于结构正常使用极限状态的变形控制、裂缝控制，承载能力极限状态下的强度控制，推算不同极限状态下被预测梁的控制弯矩，并建立了桥梁结构承载能力预测方程，从而完成桥梁结构实用动力预测全过程。

Testing subgrade surface deflection with Beckman Beam has been used extensively at highway engineering,but owing to the impaction of strickling diversification;pivot and dial indicator bracket position of Beckman Beam flexure instrument;as well as the unconformity of computation theory and practice,revising the deflection value gotten by surveying is needed.

用贝克曼梁法测试路基表面弯沉在公路工程中得到广泛应用，测试中由于受车型多样化、贝克曼梁弯沉仪支点和百分表支架位置以及计算理论与实际不符等影响，测得的弯沉值需要进行修正。

Standard clean room processing was used to prepare the paddle sample. The experiment can be operated by using the electrostatic deflection on the "paddle"cantilever beam and then measure the deposited thin metal film materials on top of it. The optical interference technique was used to measure the deflection of beam with the force.

此微桨型试件是藉由标准的黄光制作流程所完成，悬臂梁设计成梯形主要是为了提供均匀平面应力，以避免传统平行梁应力分布不均匀的缺点，实验时沉积金属薄膜材料於微桨型试件上后，再使用静电力驱动微桨型结构使其产生偏移量，并且搭配光学干涉仪器，用於量测试件受到外力作用下之平面偏移的数据。

This is taken as either of the following, whichever is exceeded first; deflection of L/20 rate of deflection = L2/(9000d) mm/min where L is the clear span of the specimen and d is the distance from the top of the structural section to the bottom of the design tension zone.

下面任意一项无论哪一项先超出限制： L/20 形变 L2/(9000d) mm/min的形变率，这里L是样品的净跨而&d&是设计的张力区域结构型面上下之间的距离。

Such parameters as the percentage of ordinary reinforcment, amounts and configuration of unbonded prestressed tendons, the ratio of span to depth and the loading patterns were considered. Based on the results, the fomula for the eqivalent length of deformation zone on the beams at ultimate were developed. A simple formula was developed for the ultimate mid-span deflection of concrete beams with concept of equivalent length of deformation zone, and the deformation of beam before internal reinforcement yielding was predicted by the traditional formula for the deformation of partically prestressed concrete beam. Then an analytical model was deduced for analyzing the ultimate stress increment in those concrete beams prestressed with external or internal unbonded tendons based on the mid-span deflection.(4) Testes were carried out on a thin-walled concrete box beam presressed with external CFRP tendons to study its short-term performances under uniform load, long-term behaviors under uniform load, and full-time performance under four-point load in turn.

3以体内非预应力钢筋配筋率、体外预应力筋配筋率、体外预应力筋布置形式、预应力度、跨高比、荷载形式等为参数，用非线性分析程序对体预应力筋混凝土梁进行了参数分析，依据分析结果提出了以综合配筋指标和预应力度为参数的等效变形区长度的计算公式，进而提出了基于等效变形区长度的极限挠度计算公式；体内非预应力钢筋屈服前的挠度计算采用常用的部分预应力混凝土梁挠度计算公式；依据试验和非线性数值计算结果，将不同转向块布置形式的体外预应力混凝土梁简化为跨中一个转向块的体外预应力混凝土梁，推导了基于跨中挠度的体外预应力筋应力增量的简化计算公式。

Such parameters as the percentage of ordinary reinforcment, amounts and configuration of unbonded prestressed tendons, the ratio of span to depth and the loading patterns were considered. Based on the results, the fomula for the eqivalent length of deformation zone on the beams at ultimate were developed. A simple formula was developed for the ultimate mid-span deflection of concrete beams with concept of equivalent length of deformation zone, and the deformation of beam before internal reinforcement yielding was predicted by the traditional formula for the deformation of partically prestressed concrete beam. Then an analytical model was deduced for analyzing the ultimate stress increment in those concrete beams prestressed with external or internal unbonded tendons based on the mid-span deflection.(4) Testes were carried out on a thin-walled concrete box beam presressed with external CFRP tendons to study its short-term performances under uniform load, long-term behaviors under uniform load, and full-time performance under four-point load in turn.

3以体内非预应力钢筋配筋率、体外预应力筋配筋率、体外预应力筋布置形式、预应力度、跨高比、荷载形式等为参数，用非线性分析程序对体预应力筋混凝土梁进行了参数分析，依据分析结果提出了以综合配筋指标和预应力度为参数的等活动房效变形区长度的计算公式，进而提出了基于等效变形区长度的极限挠度计算公式；体内非预应力钢筋屈服前的挠度计算采用常用的部分预应力混凝土梁挠度计算公式；依据试验和非线性数值计算结果，将不同转向块布置形式的体外预应力混凝土梁简化为跨中一个转向块的体外预应力混凝土梁，推导了基于跨中挠度的体外预应力筋应力增量的简化计算公式。

This paper first presents the variation regularity of active seeking range along with the change of relative bearing ,and then derives out the equations of deflection firing angle considering the variation of seeking range. A method for the calculation of optimal deflection firing angle of snake search torpedo is provided at last.

本文根据主动自导作用距离随舷角变化规律，推导了考虑到自导作用距离随舷角变化时求解最优提前角的迭代公式系，最后提出了蛇行搜索鱼雷射击的最优提前角求解方法，并给出了有关结论。

It has plenty of aileron deflection and will rotate quite quickly in both directions while hovering.

飞机的副翼有很大的行程，所以飞机在悬停时，向左向右的滚转都很容易。

And the new allowable values of deflection are also given.

提出了新的容许挠度建议值。

Connectors are lines that can be anchored to particular places, called glue points , on the graphic object.

连接符，可固定在图形对象的特定的地方的线条。

Another way of putting it, too many agents have a say in each other's work, and bureaucratic rigor mortis sets in.

另一种表达是，太多的作用物在彼此的工作里都有话语权，官僚的僵尸开始抬头。