查询词典 coring bit

Pinout: C High-performance 32-bit RISC Architecture C High-density 16-bit Instruction Set C Leader in MIPS/Watt C Little-endian C Embedded ICE (In-circuit Emulation) 8-, 16- and 32-bit Read and Write Support 256K Bytes of On-chip SRAM C 32-bit Data Bus C Single-clock Cycle Access Fully Programmable External Bus Interface C Maximum External Address Space of 64M Bytes C Up to Eight Chip Selects C Software Programmable 8/16-bit External Data Bus Eight-level Priority, Individually Maskable, Vectored Interrupt Controller C Four External Interrupts, including a High-priority, Low-latency Interrupt Request 32 Programmable I/O Lines Three-channel 16-bit Timer/Counter C Three External Clock Inputs C Two Multi-purpose I/O Pins per Channel Two USARTs C Two Dedicated Peripheral Data Controller Channels per USART Programmable Watchdog Timer Advanced Power-saving Features C CPU and Peripheral Can be Deactivated Individually Fully Static Operation: C 0 Hz to 75 MHz Internal Frequency Range at VDDCORE = 1.8V, 85C 2.7V to 3.6V I/O Operating Range 1.65V to 1.95V Core Operating Range -40C to +85C Temperature Range Available in 100-lead TQFP Package

M5L8253P-5引脚说明： C型高性能32位RISC架构C高密度以MIPS /瓦C小端C十六位指令集C领袖嵌入式冰8 - 16 -位和32位的读写支持256K的片上SRAM的 32位数据总线C单时钟周期存取字节完全可编程的外部总线接口C最大的外部地址空间的64M字节多达8个C芯片选择C软件可编程8位外部数据总线8级优先级，独立可屏蔽，向量中断控制器C四外部中断，其中包括一个高优先级，低延迟中断要求32个可编程I / O口线三通道16位定时器/计数器C三个外部时钟输入C两多用途I / O引脚每通道2个通用同步C两专用外设数据控制器通道每个USART可编程看门狗定时器先进的节能特性 CPU和外设可停用独立全静态工作中：C 0 Hz至75 MHz的频率范围内的VDDCORE = 1.8，85℃2.7V到3.6VI / O的操作1.65V到1.95V范围核心工作电压范围在- 40C至+85 C温度范围内使用的100引脚TQFP封装

Drill tools, coring bit and casing bit have been designed and a complete set of equipments and tools have been formed. Rules of operation have been made to operate these equipments more proficiently.

完成了空气潜孔锤跟管取心钻具、取心钻头、套管钻头的研制，并配套了合理的设备和器具，制订了实用、操作性强的空气潜孔捶跟管取心钻进技术规程。

Coring bit ['k3ti8 bit]n.

取芯钻头。。

In addition to four nmerac place position,there are three zone bit positions in a 7-bit code,and four zone bit in an 8-bit code.The 7-bit American Standard Code for Information Interchange is widelu used in data communication work and is bu far the most popular code used to represent data internally in personal computers.

除了4位数字位之外，在7位编码中有3个标志位，而在8位编码中则有4个标志位。7位美国信息交换标准代码广泛地用于数据通信，而且是目前个人计算机内部数据表示中最为流行的代码。

In addition to the four numeric place positions, there are three zone bit positions in a 7-bit code, and four zone bit positions in an 8-bit code: The 7-bit American Standard Code for Information Interchange is widely used in data communications work and is by far the most popular code used to represent data internally in personal computers.

因为64种可能的位排列仍不能满足十进制数（10个）、小写字母（26个）、大写字母（26个）和大量的其它字符（26个以上）编码的需要，所以设计者将6位BCD码扩充到7位和8位。7位二进制数可以提供128种不I司的排列(2 ')；8位二进制数可以有256种排列（2）。

In theory, it can have an unlimited bit depth, that is, each sample point 1-8-bit, 24-bit, 32-bit or 48-bit.

在理论上它能够有无限位深，即：每样本点1-8位、 24位、32位或48位。

To the same kind of rocks, the penetration rate increases with the increases of electric bit thermal power. When electric bit thermal power keeps fixedness, the penetration rate increases in various degrees with the increases of bit load in difference rocks. Increasing the bit load is beneficial to improve the quality of glass hole wall, but the bit load should not be too big.

对于同一种岩石，钻进速度随钻头电热功率的增大而增大；当钻头电热功率不变时，根据所钻岩石岩性的不同，钻进速度随钻头轴载的增大而不同程度地增大，增加钻头轴载有利于提高玻璃状孔壁的质量，但不宜过大。

For each data bit sent or received,the high order bit of the current remainder is XORed with the data bit and then the remainder is shifted left one bit and the low-order bit set to zero.

对于每个被发送或者被收到的数据位，当前余项的最高一位和数据位进行异或，然后，余项是左移1位，并且，最低一位置零。

We improve the protocol for signing contract based on the research result of secure multiparty computation. In this protocol, the parties obliviously transfer the signed bit and the committed bit; the other parties can prove the validity of this bit based on the confirming sub-protocol, but he can't gain more information about the whole signature by accumulating the more signed bit or the committed bit. After the parties exchange the whole signed information, they declare the commitment about the signature respectively, and gain the whole signature of the other party. At this moment, the party doesn't care about the advance quit of the other party, because he has gained the whole signed information.

在协议执行过程中，参与者将合同的签名位以及他对签名位的承诺不经意传输给对方，对方可以利用验证子协议证明该位的有效性，但是他却不能通过位交换次数的增加获取更多的完整签名的信息；在完成签名位的交换之后，参与者分别公开承诺，并得到对方对合同的完整签名；在公开承诺时，协议参与者已经获得全部的签名内容，要么是签名位，要么是对方对该位的承诺，因此参与者并不需要担心对方提前终止协议，同时本文也利用多方安全计算的结论证明了该协议满足终止公平性。

If two parties want to sign a contract C over a communication network, they must "simultaneously" exchange their commitments to C Since simultaneous exchange is usually impossible in practice, protocols are needed to approximate simultaneity by exchange partial commitments in a piece by piece manner The party of secondly sending commitments may have a slight advantage; a "fair" protocol must keep this advantage within acceptable limits The protocol for signing a contract is improved based on the research result of secure multiparty computation In this protocol, the parties obliviously transfer the signed bit and the committed bit; the other parties can prove the validity of this bit based on the confirming sub protocol, but he can't gain more information about the whole signature by accumulating the signed bit or the committed bit After the parties exchange the whole signed information, they declare the commitment about the signature respectively, and gain the whole signature of the other party At this moment, the party doesn't care about the advance quit of the other party, because he has gained the whole signed information Finally, it is proved that this protocol is quit fairness

作者中文名：曲亚东；侯紫峰；韦卫摘要：在网络环境中解决合同签订问题需要保证信息交换的同时性，以前提出的协议都会给第2个发送者部分计算特权，利用不经意传输协议则可以解决这个问题。在协议执行过程中，参与者将合同的签名位以及他对签名位的承诺不经意传输给对方，对方可以利用验证子协议证明该位的有效性，但是他却不能通过位交换次数的增加获取更多的完整签名的信息；在完成签名位的交换之后，参与者分别宣布承诺，并得到对方对合同的完整签名；在宣布承诺时，协议参与者已经获得全部的签名内容，要么是签名位，要么是对方对该位的承诺，因此参与者并不需要担心对方提前终止协议。在文章的最后利用多方安全计算的结论证明了该协议满足终止公平性。

Must have Coordination and negotiation skill, flexible ideas, and be punctilious person.

必须具备较好的协调与谈判能力，头脑灵活，工作认真仔细

Result: 18 patients are all with simple eye.The pigment mole lies in nasal and temple sides of the ball conjunctiva,in which 2 lie in lacrimal caruncle and semilunar plica.

结果：18例患者均为单眼，色素痣大多数位于内外侧睑裂部球结膜面，2例位于泪阜及半月皱襞，经激光治疗后，10例色素痣消失，有5例行再次激光后消失，2例行第三次激光后消失，1例第四次激光后消失。