查询词典 control chart method

This design is the Guangzhou lan west 100 markets summer the central air-conditioning system design, the primary mission completes one, two, three, four buildings load computation; Air-conditioning system plan efficient analysis and water unit's shaping; The air-conditioning system freezing stands design; Four buildings shopping area air conditioning unit's shaping, wind system and aqueous system design; Four buildings work area air blower plate tube system design; And has drawn up four winds tubes floor-plan, the wind side chart, the engine room floor-plan, the aqueous system axis side chart.

该下载资料由本站会员上传，如果侵犯了您的权力，请通知我们，将立即删除！摘要本次设计课题是广州市蘭西一百商场夏季中央空调系统设计，主要任务是完成一、二、三、四楼的冷负荷计算；空调系统方案的经济性分析和制冷机组的选型；空调系统冷冻站的设计；四楼购物区空调机组的选型，风系统和水系统的设计；四楼办公区风机盘管系统的设计；并绘制了四层风管平面布置图、风管轴侧图、机房平面布置图，水系统轴侧图。

On the one hand, the component method is introduced into flowchart design, which can not only enlarge the depth and the connotation of the flowchart, but also extend the traditional concepts of the flowchart. By combining the component method and the objectoriented method, it will be easy to illustrate the industry flow and meet with the future requirements of the industry control software. On the other hand, the trajectory concepts in plane moving, the method of using Bezier Curve to approach the 1/4 arc to implement the arc circumrotation, the method of using graphic elements' combination to extend the expression capability, and the method of combining the graphic elements'combination, three-dimensional graphic elements and bitmaps to realize the three-dimensional effects to express the industry flow more realistic are brought forward in this dissertation.

工控软件中最能够体现人机接口设计创造性的画面当属流程图，本文对流程图设计进行了深入研究，提出了一种工控软件流程图设计的新方法：一方面在流程图设计中引入部件化方法，扩展流程图的深度与内涵，延伸了流程图的传统概念与意义，将部件化技术与面向对象技术相结合，能够更好地实现对工艺过程的描述并适应工控软件的未来发展要求；另一方面对流程图中动画关联和三维化这些新兴领域进行了研究，提出了平移动画中的&轨道&概念，以实现图元的沿曲线平移，提出了在圆弧旋转动画中用Bezier曲线逼近〓圆弧的工程化方法，并用最小二乘法进行了验证和工程化参数的获取，实现了利用图元组合来扩展流程图的表达能力，采用了图元组合、三维图元和位图相结合的方法来实现逼真的三维效果，以使工控软件更加符合人机工学，更能形象地反映工艺流程。

Authors designed four mixtures of dense-graded asphalt stabilized macadam base with the method recommended by Technical Specifications for Construction of Highway Asphalt Pavement, Superpave design method, coarse aggregate voids filling method and Bailey method separately, and determined the pavement performances of asphalt stabilized macadam base mixture under the optimal oil-stone rate which include resistance capacity to vertical deformation and fatigue. Then, four design methods were compared and appraised. Based on the above study, a new asphalt-stabilized macadam base mixture gradation design method-five control sieve design method was put forward.

分别采用现行规范推荐法、Superpave法、主骨架空隙体积填充法和贝雷法设计了4种密级配沥青稳定碎石基层混合料，然后采用力学指标设计法确定了所设计的4种级配沥青稳定碎石基层混合料的最佳油石比，并对最佳油石比下的沥青稳定碎石基层混合料进行了抗永久变形性能和抗疲劳性能等路用性能的研究；根据设计过程和设计结果对4种级配设计方法进行了比较评价，在此基础上提出了新的密级配沥青稳定碎石基层混合料的级配设计方法－五控制点级配设计方法。

This paper precisely conducts the special topic research in view of some important technologies of the digitized control module.(1) AC motor control circuit of PAN/TILT is designed ,which speed is controlled by AT89C51 MCU. DC motor control circuit of LENS is designed too.(2) The hardware and software of automatic temperature control is designed, which used in camera protect box without A/D IC. A kind of single wire communication IC is used in the circuit. So, the program is given.(3) A method of video switch without picture shock is discussed in this paper, and 16x8 video switch circuit is designed. AT89C51 can carry out time sequence logical control with the sync signals by request..(4) The module of real-time clock is designed, in which, LCM is used, a kind of three-wire communication IC is used too.

1给出了一种由89C51单片机控制的简单易行的交流云台转动变速控制电路，实现了云台及其电动三可变镜头的控制；(2)给出了无需外加A/D、单线通信的防护罩自动温度控制电路，完成了单片机温度控制软件的设计；(3)提出了"无抖动"视频切换的设计思想，给出了16×8的视频切换电路，利用单片机在视频信号的场消隐期控制切换，从而实现了"无抖动"切换；(4)给出了一种三线接口通信的液晶显示实时时钟电路，完成了程序设计；(5)提出了在视频监控系统数字控制模块中，用CAN总线取代传统的RS-485总线，实现PELCO-P协议传输的方案。

Based on the needs of system control strategy and the output of the active inverter, a switch function method was adopted to build the average model of switch cycle for the active inverter in order to accurately analyze operation characteristic of active inverter, a feed forward and double loop control strategy is put forward, its double control includes a inductor current inner loop control and instantaneous voltage outer loop control.

中文摘要：为准确分析有源逆变器的运行特点，根据系统控制策略的需要，在考虑了有源逆变器输出的基础上采用开关函数法建立了有源逆变器的开关周期平均模型。提出一种前馈加双环控制的控制策略，它的双环控制包括一个电感电流内环控制和一个瞬时电压外环控制。

Presents the design of longitudinal control for ASTOVL lift-fan aircraft, a multi-variable, strong-coupling, complicated nonlinear system to make the system nonlinear offset and decouple, and the method used for linear system in designing the system to gain expectant flying qualities and the combination of aerodynamic control surfaces with thrust vectors to delay the control surfaces getting into saturation, and the minimum N-norm generalized inverse theorem of weighted generalized inverse adopted to apportion the moments commands, which make the control surfaces gain appropriate deflection and the simulation results to verify the dynamic inverse control laws designed really make the system nonlinear offset and decouple; when one command is given, only this output will response, and others do not response; when all commands are given together, the responses will be just the linear superpose of the response of each command, therefore the operation of the pilot will be simplified greatly.

摘 要： ASTOVL升力风扇飞机是多变量、强耦合、复杂的非线性系统，采用非线性动态逆理论设计控制律以实现系统的非线性对消及解耦，然后，采用线性系统的设计方法对系统进行设计，以使系统获得期望的飞行品质。同时，考虑到ASTOVL升力风扇飞机是由气动舵面和推力矢量融合作用的，为了延缓各舵面进入饱和的时间，采用加权广义逆中的极小N-范数广义逆定理分配力矩指令，从而使各舵面达到适当的偏转角。并将所设计的控制律进行了仿真，结果验证了所设计的动态逆控制律使系统实现了非线性对消和解耦，单个指令作用时，只有该项响应，其余不受影响；所有指令作用时，其结果就等于单个指令作用时的线性叠加，这样使驾驶员的操纵大大简化而易于控制，从而大大降低了飞行事故率。

Linear Fractional Transformation is adopted to translate the control of perturbation to the control of disturbance, then cost index is augmented, and with the min-max method, a robust receding horizon control law is derived. The sufficient conditions for the existence of the control law and closed-loop stability are also presented. The result is extended to time-invariant system with an infinite horizon, and its consistence with the robust control based on the concept of Quadratic Stability is verified.

首先利用线性分式变换，将摄动系统的鲁棒控制问题转化为对扰动系统的鲁棒控制问题；然后通过对性能指标的扩展，利用min-max方法，得到了鲁棒滚动时域控制律，并给出了其存在和使闭环系统渐近稳定的充分条件，并将结果扩展到对定常系统时域无穷的的情况，指出其与现有的基于二次型稳定概念提出的鲁棒控制的一致性。

The major contributions of this thesis include:(1) proposing a new kind of optimal feedback control, followed by its application to chaos targeting and stabilization of high period unstable periodic orbits ;(2) stabilization of unstable fixed point in chaotic systems using some kind of nonlinear feedback control, and giving sufficient condition for the existence of the controller as well as the synthesis procedure;(3) analyzing the robustness of optimal control in chaotic Lur'e systems under the help of H〓 control theory;(4) finally and most importantly, introducing a novel method of information storage based on discrete time chaotic systems as the application of chaos control, and systematically studying different schemata for implementation, providing a theoretic basis for the design of such new kind of information storage devices with large capacity.

本文的主要工作包括，提出一种新的最优反馈控制，并将之应用于混沌引导控制及混沌系统高周期不稳定周期轨道的镇定控制；针对不动点镇定控制的一类非线性反馈控制器，文中给出该类反馈控制存在的充分条件及设计步骤；文中还利用非线性H〓鲁棒控制理论对Lur'e混沌系统中的最优线性反馈控制进行鲁棒性分析；最后，也是最重要的，作为混沌控制的应用，文中提出一种基于离散时间混沌系统的信息存储方法，系统地分析、研究了实现这种信息存储的不同方案，为以后进行这种新型大容量存储器设计提供了一定的理论依据。

Vector control is the foundation of high performance PMSM control system Every vector control is analyzed and compared and several system characteristic are studied with special screw propeller load in this thesis, and then it is put forward that optimal torque control is the best control method of PMSM propulsion system.

本文对现有的几种矢量控制进行了深入的分析和比较，并结合推进系统特殊的螺旋桨负载研究了系统的各种特性，提出把转矩最优控制方案应用到舰船永磁同步电动机推进系统中。

On control method, develop under the control of from hand movement to autocontrol; On the control function, arrive at intellectualized under the control of from developing simplely under the control of; Develop on the busy, from scheme weight to informatization treatment; On controlling principle, touch the relay logic navar working a telephone switchboard stiffly from unitary ......

因而，受到各工业国家的重视，并投入大量的人力、物力加以研究和应用。在我国，近几年来也有较快的发展，并取得一定的成果，受到各工业部门的重视。通过此设计，可以使大家了解到X62W万能铣床的电气控制系统的结构和PLC控制的原理，简单工作原理。目录一。绪论

I was just taking her hand, to help her out of a car, and I knew it.

我只是握着她的手，扶她下车，但我知道这一切。

China and South Korea have excoriated Japan over its approval of new school books which they say whitewash the atrocities committed during Japanese occupation, and anti-Japanese protests have been held in Chinese cities. The lingering bitterness over Japan's past imperialism still threatens to mar relations between the big East Asian powers

中国和韩国强烈谴责日本通过新的中学历史教科书，他们认为这一教科书掩盖了日本在其占领期间所犯下的残酷暴行，反日抗议活动在中国数座城市发生，历史上日本帝国主义制造的痛楚无法被忘却，这有可能破坏东亚强国间的关系。