查询词典 complementary angle

In addition,the effects of louver angle and the exchange zone length on the pressure drop and the heat transfer coefficient are studied for louvered fin optimization design.The results show that the louvered angle has distinct effect on th...

在深入揭示百叶窗翅片流动机理的基础上，进一步比较了百叶窗翅片开窗角度La和换向区长度S对其传热和流动阻力的影响，分析结果为百叶窗翅片的模具制作及其优化设计提供了依据。

The result manifest that characteristic of chin soft tissue profile of bony malocclusion of class I had bigger angle of chin-lip, shallower mentolabial furrow,smaller radian and larger convexity compared to that of bony malocclusion of class II, and smaller angle of chin-lip, deeper mentolabial furrow,larger radian and smaller convexity compared to that of bony malocclusion of class III.

测量结果显示：骨性II类错牙合颏部相对于正常牙合发育不足，颏唇角小，颏唇沟深，弧度较大，突度较小。而骨性III类错牙合相对于正常牙合颏部发育过度，颏唇角大，颏唇沟浅，弧度较小，突度较大。

The STM image is shown the surface structure of the single atomic height step for miscut angle of 0.5°,and the surface structure of the double atomic height step for miscut angle of 4.5°.

观察到错切角为0.5°时STM像为单原子高度台阶表面结构，错切角为4.5°时STM像为双原子高度台阶结构。

The average angle between the nasopalatine duct and the anterior nasal floor is 114.80 , so in front of the nasopalatine duct, implants should be implanted parallel to the nasopalatine duct with an angle about 115 ?

1.2、尖牙根尖与前鼻底(前缘后方2-6mm区域)最小距离均值为：8.12mm，6.21mm，因此，当侧切牙根尖距前鼻底过近时，可在梨状孔侧下方斜向植入长度为4-6mm和4mm的种植体。

The geometry model formular is used to deduce the length of yarns, the oridentation angle of the nodulated yarns and the fiber volume content on some typical 2.5-D woven composites, such as shallow curve-linking structures, shallow straight-linking ones, and depp angle-linking ones, and tensile strength and compress strength of the composites are forecated.

借助模型推导出纱线在几种典型结构（浅交弯联、浅交直联、深角联）的单元体结构内的纱线长度、接结经的取向角和纤维体积分数，并对材料进行拉伸、压缩性能预测。

The general feature of deformation caused by the collision between two continents also reveals that, during the collision process, apart from a foreland basin and high mountains being formed, there is another compressive depression with an asymmetric structure developed on the side of the obducted plate, which is much easier to be formed when the dip angle of the collisional fracture zone is between 15° and 30° and is the deepest with a dip angle of 30°. This implies that the compressive depression is controlled by both subduction and obduction between two continents.

从大陆与大陆碰挂变形构造特征看，除发育前陆盆地－山脉系统外，在仰冲陆块一侧靠近造山带后缘还发育呈不对称结构的挤压性凹陷，当两个大陆板块碰撞断裂带倾角在15~30°时，该类型凹陷更容易形成，其中以30°倾角对应的凹陷最深，反映其形成可能是大陆碰撞过程中陆块之间相对俯冲和仰冲运动的综合结果。

Methods The operations of angle-splitting ostectomy have been performed on 13 patients (11 female, 2 male) who had large, squarish, or broad face with eversion mandibular angle.

对下面部宽大，下颌骨体肥厚，下颌角外翻明显的&四方脸&者(13例，其中男性2例，女性11例)进行了下颌骨体部的劈裂截骨术和部分咬肌去除术。

Objective The conventional simple angle ostectomy sometimes could not get good result for the cases of overwide facial appearance.To reduce the width of the lower face effectively,the angle-splitting ostectomy hasbeen performed.

目的 下面部过宽采取单纯下颌角截骨有时不能取得理想的效果，正确选择适应证进行下颌骨体劈裂截骨术可取得更好的手术效果。

The calculating results are compared with the test data in available literatures and FEM results. The research results show that the plastic hinge model is precise and correct, which can satisfy with the actual engineering demands. The collapse pressure of perforated liner casing decreases with phrase angle, initial ovalization and diameter-thickness ratio increasing, and increases with the yield stress. The phrase angle and initial ovalization have greatly influence on the collapse pressure. The collapse pressure of perforated liner casing is slightly changed with the diameter and density of perforation when the diameter and density are smaller than 12mm and 120 shots per meter, respectively.

计算结果表明：筛管抗挤强度的塑性铰模型具有很高的计算精度和准确度，可以满足工程实际需要；筛管抗挤强度随着射孔相位角、径厚比和初始椭圆度的增加而降低，随着屈服强度的增加而增加，相位角和椭圆度对筛管抗挤强度影响比较显著；在射孔直径小于12 mm、射孔密度小于120 孔/ m 时，筛管抗挤强度随射孔直径和射孔密度增加变化不明显。

Therefore, the uplink cross-pol interference that we meet is normally caused by the polarization angle mismatch of ground transmitting antennas, or serious overdriven of the uplink power at cross-polarization. And the downlink cross-pol interference is normally caused by the polarization angle mismatch of ground receiving antennas.

因此，常见的反极化干扰通常为，因反极化地面发送天线的极化角失配、或因反极化载波的上行功率严重超标而产生的上行反极化干扰，以及因地面接收天线的极化角失配而产生的下行反极化干扰。

Many will continue to choose to live in duality and in conflict.

许多人将继续选择活在二元对立性和冲突中。

I find that students of the University of Physical Education all wear sportswear at first sight.

我发现：体育大学的学生乍一看，都是穿运动衣，大家都一样