查询词典 compensation method

The revised Hargraves formula has the best result compared with Penman-Monteith formula, the average relative error is 6%, moreover, Hargaves method requiring the least data in calculating ETo, so this method has the high actual application value; The following are Radiation method and Blaney-Criddle method ; The worst is the Pan method, even after revised, the highest and average relative error is 36% and 10%, respectively. So, in this study, Penman-Monteith method, Radiation method, Blaney-Criddle method and Hargraves method are used except Pan method.

在这四种方法中，修正后的Hargraves方法与彭曼—蒙特斯方法的计算结果符合最好，其平均相对误差为6％，而Hargraves方法需要的气象数据只有计算时段的最高、最低温度，该方法具有较高的实际应用价值；辐射方法和布兰尼—克里德尔方法次之；蒸发皿方法最差，即使在修正后，E601型蒸发皿的最大误差也高达36％，平均为10％，所以在预报系统的研究设计中采用了除蒸发皿方法之外的四种方法。

The primary studying works and characteristics:1 To summarize reinforcing theory of cement mixing pile composite foundation2 To analyze the primary mechanics characters and changing rules of cement mixing pile, based on analysis of test data both indoor and outdoor.3 To discuss siding frictional resistance, ending resistance, ultimate bearing capacity of simple mixing pile and effectiveness factor of grouped piles, loading ratio of soil between piles under cushion cap of grouped piles and stress ratio of pile and soil and so on, and use many computation method and experimentation method to ensure bearing capacity of mixing piles composite foundation.4 To point out and analyze eight sides flaws and problems of the bearing capacity calculation method of mixing pile compositefoundation which ensured by national and normative method/ formula.5 To apply test results of loading tests and a few settlement observation data, use gray theory to predicate ultimate bearing capacity of deep mixing piles, actual example demonstrate engaging between theoretical predicted value and actual value.6 To apply groovy layerwise summation method to discuss entity piles method, double foundation method, equivalent layerwise summation method and consolidation theoretical method and so on, especially by combination of engineering example, use FEM to calculate or discuss the settlement and changing rules of composite foundation.7 To discuss problems of critical length of composite foundation by combination of engineering example and numerical analysis method, and analyze the contrast of critical length between simple pile load and most area load of composite foundation, not only critical length of composite foundation is relative to modulus ratio between piles and soil, but also upside load distribution area of composite foundation.

主要的研究工作与特色为：(1)总结了水泥搅拌桩复合地基的加固原理；(2)在对室内外试验资料进行统计分析的基础上，系统分析了搅拌桩水泥土的主要力学特性及其变化规律；(3)探讨了搅拌单桩的侧摩阻力、端阻力、极限承载力及群桩效率系数、群桩承台下桩间土荷载分担比及桩土应力比等，提出用多种计算方法并结合试验方法来综合确定搅拌桩复合地基的承载力；(4)明确指出和分析了按国家有关规范的方法确定搅拌桩复合地基承载力所存在的八个方面的缺陷与问题；(5)利用过去没有加载至破坏阶段的载荷试验成果和较少的沉降观测数据，尝试了用灰色理论预测深层搅拌桩的极限承载力，实例表明理论预测值与实测值吻合较好；(6)在常规分层总和法的基础上，探讨了复合地基沉降计算的实体墩基法、双层地基法、等效作用分层总和法、固结理论法等，特别是结合工程实例，用有限元数值计算等方法计算和讨论了搅拌桩复合地基的沉降及其变化规律；(7)结合工程实例，用数值分析方法探讨了复合地基临界桩长的问题，指出和分析了单桩荷载下的临界桩长与复合地基大面积荷载下的临界桩长存在很大的差别，复合地基的临界桩长不仅与桩土模量比有关，而且与复合地基上部荷载分布面积有关。

As we all know that the Law of State Compensation is lack of this part.So,the text will strart with the default in the lawmaking about violation as administrative omission in the Law of State Compensation,at the same time to make sure that the State should bear the compensation responsibility ...

本文将从该法有关行政不作为违法的立法缺失入手，肯定国家对此应当承担赔偿责任，浅析此举的意义，最后分析了如何将《国家赔偿法》中行政不作为违法纳入国家赔偿机制。

This paper applies managerial psychology labor -economics and operations research to analyze the compensation design,the motivation effect of CADI (Chengdu Aircraft Design and research Institute)synthetically on the basis of introducing the theories about human resource management,compensation and motivation. Some problems occurred in the compensation management of CADI and the causes are discussed.

本文综合运用管理心理学、劳动经济学、运筹学等分析方法，在对人力资源管理、薪酬、激励等基本理论概括介绍的基础上，论述了薪酬的分类、决定机制、设计准则及薪酬激励的模型，探索分析了611所工程技术人员薪酬设计及其激励效果，分析了现行体制下激励强度弱等弊端及原因。

Based on the reviewing researches of compensation change, the paper focuses on discussing the strategy-oriented problem of enterprise compensation change and how to build a system of strategy-oriented compensation change plan, when there is a discontinuously organization change.

本文在回顾了以往学者对薪酬变革相关研究的基础上，著重探讨了企业非连续性组织变革过程中，企业薪酬变革战略整合问题以及如何具体地建立薪酬变革方案。

But the early emphasis on victim compensation changed and the right to compensation was denied under the feudality. With the realization on crime Victims especially the promotion of the victim rights movement in 20th century, most countries today have provided compensation to crime victims.

随着人类对犯罪被害人认识的不断深化，尤其是在20世纪被害人运动的推动下，被害人国家补偿制度终于在世界大多数国家得以重新确立。

Based on the analysis of the limitations of parity compensation,the article suggests that it is necessary and possible to involve the principal of punitive compensation in compensation for the damage of environmental pollution,so as to strengthen the function of civil re- lief,sanction and prevention,and eventually to create a fairer society of justice.

在各种俊权贵任形式中，损害赔偿是最基本的形式，原因在于侵权法的基本功能就是补偿受害人的损失。所以，损害赔偿在环境污染损害贵任形式中有着不可取代的地位，并且被广泛地适用。

Web-based application system of geometric error compensation aims to broaden error compensation technology by using network. SMART-CNC machine tool has been chosen as the object of experiment. Based on the kinematics of multi-body system, the movement equation for SMART-CNC machine tool has been built.Furthermore, web-based error compensation system has been implemented.

基于Web的数控曲面磨床几何误差补偿技术：以误差补偿技术的网络化应用为目的展开研究，选取SMART-CNC 数控曲面磨床为研究对象，运用多体理论，建立了磨床的运动模型，获得了与精密刀具轨迹相对应的逆变刀具路线或逆变数控指令的求解方法，在此基础开发了基于网络的误差补偿软件，构建了网络化误差补偿服务系统。

Compensation for medical malpractice should take these factors into consideration, the level of medical accident, the extent of responsibility for medical misfeasance in consequences of compensation for medical malpractice, relationship between consequences of compensation for medical malpractice and sufferer s original disease.

医疗事故赔偿，应当考虑医疗事故等级，医疗过失行为在医疗事故损害后果中的责任程度，医疗事故损害后果与患者原有疾病状况之间的关系这些因素，来确定具体的赔偿数额。

A new scheme for laser beam focus position error compensation is proposed, In this scheme, a decomposing compensation scheme, the compensation action along laser beam is decomposed to three orthogonal straight-line coordinates: X、Y、Z, without extra actuator.

论文提出了一种新的激光焦点位置误差补偿方案，该方案不需要专门的执行机构，而是将激光聚焦头沿着光轴方向的补偿运动分解到机床的X、Y、Z三个直线运动座标上，称为分解补偿方案。

Chinese traditional virtue is humility and wariness,the compliment and praise to the others should be declination

中国人的传统美德是谦虚谨慎，对别人的恭维和夸奖应是推辞。如

We bought this house on the never-never.

我们以分期付款的方式买下这座房子。