查询词典 bit error ratio

The complexity of bodywork decides variety of it's error. The station and primary factor which cause error is inconstant change and using correlation analysis can find out the primary factor. With an project given, the theory of correlation analysis for dimension variation of bodywork is discussed through correlation analysis and the layer structure of the bodywork,the state in which the error happened can be found out. How to use eigenva...

车体装焊的复杂性决定了误差产生的多因素性，车体制造过程中产生误差的工位和主要因素是不断变化的，采用相关性分析方法从众多的误差根源中准确地发现最主要的误差源；结合工程实践，论述了车体尺寸波动的相关性分析方法的原理，根据测量点的相关性分析和车体焊接工艺的层次结构，可准确地找到产生车体尺寸误差的工位；讨论了如何利用相关系数矩阵的特征值和相应的特征向量判断尺寸波动的模式，指出测量数据的波动主要按最大特征值所对应的特征向量方式波动，引起这种波动的原因是车体误差产生的主要原因，应重点采取措施加以控制；提出了应用计算机进行相关性分析的解决方案。

Firstly, we test that the error data are not normal distribution, and even the expectation is not zero. Then we analyze the possible type distribution of these error data. Finally, we use the stepwise method to fit the error data and obtain a function for some parameters of the SAIL model. As prior knowledge, the fitting function will be used to inverse these parameters ofthe SAIL model soon.

首先检验了误差数据不服从正态分布，甚至均值不为零；然后对误差数据可能服从的分布类型给予了解析，得到了指数分布和混合正态分布两种不同类型的可能分布；最后拟合了误差关于SAIL模型部分参数的函数表达式，以作为先验知识应用于反演之中。

Comparison of the synchronous measurement result of this receiver with that of a reference one shows the error trend is the same. The scatter plots of the horizontal error and vertical error distribution show that this measurement system is more stable and can reflect the position information exactly.

该接收机和参考接收机的同步测量结果表明，两个接收机对定位信息获取的误差趋势相同，通过接收机的水平误差散点图和时间序列垂直误差分布图可见，该测量系统较稳定，可准确地反映定位点的位置信息。

Simulation results show that in the image rotation and scale variation range resulted from the navigation system error and the measurement error of the wireless pressure altimeter, the proposed image matching algorithm can satisfy the accuracy demands of the scene aided navigation system and provide the location error-correcting information of the system.

仿真分析表明，在导航系统误差漂移所引起的图像旋转和气压高度表所引起的尺度变化范围内，该算法能满足匹配准确性的要求，并能有效给出系统的定位误差修正信息。

In the second chapter,I calculate the diffractive efficiency when there arealignment error,depth error of the step and the work was elength error,based on the theory ofthe fresnel lens.

第二部分文章在介绍菲涅耳透镜设计原理和衍射效率计算的基础上，重点分析了存在各种加工误差时候的衍射效率的计算情况。

The measurement error of phase shifting method is calculated.It is concluded that if 5 frames are used per time, in order to achieve 0.3° precision inphase measurement, phase shifting error must be limited in± 0.1° plus at least 60dBsignal to noise ratio.

同时，还进行了相移检测法的初步误差分析和模拟研究，结果表明：采用5幅图像的方法，要实现0.3°的检相精度，就要求相移误差在±0.1°以内，信噪比为60dB以上。

Firstly, the Signal Noise Ratio characteristic of matched filter despread symbol and the distribution of coherent phase estimation error are derived. Secondly, the exact integration formula of BER for fading channel is presented, moreover, by using the Maclaurin series expansion of MPSK conditional Symbol Error Rate, the simplified BER approximations for BPSK and QPSK are derived over AWGN, Nakagami-m fading and Rayleigh fading channel.

首先推导了匹配滤波解扩符号的信噪比特性和相干相位估计误差的分布；然后给出了衰落信道中误比特率的精确积分式，并利用MPSK条件误符号率的麦克劳林级数形式，推导了AWGN，Nakagami-m衰落和瑞利衰落信道中BPSK，QPSK误比特率的简化逼近式。

By measuring missile movement inertia with torsion pendulum, the influences of periodic measurement error, systemic damp, period of swing object and corporative period of t he measured object and swinging object were analyzed. The relation among measurement error of movement inertia, measureme nt period, the period of swing object,corporaˉ tive period of tested object and swing object was proved. The maxi mal ratio between movement inertia for swinging obˉ ject and the measured object under conditions of different errors w as given under typical measurement precision.

通过扭摆测量导弹转动惯量的方法，分析了周期测量误差、系统阻尼、摆动体周期以及被测件和摆动体共摆周期对转动惯量测量精度的影响，得出转动惯量测量误差和周期测量误差、摆动体摆动周期、被测件和摆动体共摆周期之间的关系，给出了在典型的测量精度要求，不同的周期测量误差情况下，摆动体转动惯量和被测件转动惯量之间的最大比值。

Based on Taylor decomposition and the principal of matrix turbulence,the measuring error of structured light and error from light-plane calibration were analyzed,in which cross-ratio invariant was used in calibration of structured light system.

本文针对交比不变原理的结构光光平面标定方法，利用泰勒展开和矩阵扰动原理分别对系统的测量误差和光平面标定误差进行分析，提出了结构光测量系统的误差传递模型。

The condition of the minimum relative error is theoretically given. That is the place of the balance point should be chosen according to the ratio of the measured resistance Rx to the internal resistance Rg of the galvanometer in order to get the minimum relative error.

并在此基础上讨论了滑线电桥的灵敏度及其对所测电阻Rx的影响，从理论上给出了滑线电桥最小相对误差的条件：要使滑线电桥灵敏度所引起的相对误差最小，电桥平衡点的位置应按待测电阻Rx与检流计内阻Rg的比值来确定。

These are places without aristocratic baggage; egalitarian places open to talent, self-improving, engaged in learning and innovation through networks that were at once competitive and cooperative.

这些地方没有贵族遗风作祟，而且对于那些有天分的人是开放的平等之地，这些人善于通过那些曾经很具有竞争力与合作精神的关系网进行自我提高以及学习创新。

Christine: You don't want to see me?

你不想见我？