查询词典 bi-rotation

The experimental results show that, by the process, 10 kg barium carbonate with 0.1 L hydrochloric acid (HCl 27%) as catalyst is added in 1 m3 copper electrolyte, 70% Bi can be removed from the electrolyte, and the Bi content in filter residue is more than 4%.

实验结果表明，采用碳酸钡脱铋新工艺， 1 m3铜电解液加入10 kg碳酸钡，用0.1 L盐酸(HCl 27%)作催化剂， Bi的脱除率可达70%，脱铋渣含Bi量大于4%。

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

With the increment of the Se mol ratio in the systems, the volume of unit cell is reduced , the energy of the system is increased, and the covalence bond component of Te(1)-Bi,Se(2)-Bi,Se(1)-Bi is gradually enhanced.

随着体系中Se原子摩尔比的增加，晶胞的体积减小，体系的能量增加，Te(1)-Bi键、Se(2)-Bi键、Se(1)-Bi键的共价键成份逐渐增强。

For the chemical bonding of the various layers of atoms, the covalence bond component of X(1)-Bi is stronger than that of X(2)-Bi.

层间原子成键，X(1)-Bi键比X(2)-Bi键的共价键成份较强。

It was also found that the film of smaller grains corresponded to a smaller lattice constant of the garnet structure, which implied that fewer Bi〓 ions substituted into the dodecahedral sites in the garnet, due to the fact that the smaller grains resulted in more grain boundaries, thus leading to more serious Bi segregation in the grain boundaries.

分析表明，细小的晶粒意味着薄膜中含有更多的晶界，这样将导致Bi组分在晶界上的偏析较显著，而进入石榴石结构中氧十二面体间隙的Bi〓较少，对于Bi，Al∶DyIG来说，石榴石相晶格常数与{Bi〓}〓呈正相关关系，由此可以解释具有细小晶粒的薄膜对应较小的石榴石相晶格常数。

Then, on the basis of above achieved constituent binary results, thermodynamic properties of 10 ternary liquid alioys (Cd-Bi-Pb, Cd-Pb-Sb, Cd-Pb-Sn, Mg-In-Cd, Zn-In- Cd, Cd-Bi-Sn, In-Bi-Pb, Sn-AgPb,Zn-In.Pb, Al-Cu-Zn), 3 quaternary ones (Cd-Bi-Pb-Sn, Zn-Sn-Cd-Bi, Zn-Sn-Cd-Pb) and 1 quinary. one (Zn-Sn-Pb-Cd-Bi) are predicted. For most of investigated multicomponent systems, the calculated activities are in good with the experimental ones, and in particular for multicompoment immiscible ones, the predicted results are satisfactory and exciting. At the same time, the comparison result between the three equations shows that Wilson equation and T-K-Wilson one are more stable than NRTL one, that maybe is because NRTL equation contains a third parameter, and so ,to some degree, Wilson model and T-K-Wilson model are superior to NRTL model. And also the comparison between local composition models and other models such as Pelton- Flengas?method, Krupkowski formalism, mass action concentration model and Hoch- Arpshofen model shows that local composition models are more convenient and credible.

在此基础之上应用局部组成型模型对10个三元液态合金（包括Cd-Bi-Pb、Cd-Pb-Sb、Cd-Pb-Sn、Mg-In-Cd、Zn-In-Cd、Cd-Bi-Sn、In-Bi-Pb、Sn-Ag-Pb、Zn-In-Pb、Al-Cu-Zn），3个四元液态合金（包括Cd-Bi-Pb-Sn、Zn-Sn-Cd-Bi、Zn-Sn-Cd-Pb）和1个五元液态合金（Zn-Sn-Pb-Cd-Bi）的活度进行了预测，预测效果良好，尤其对Zn-In-Pb系和Zn-Sn-Cd-Pb等多元液-液共存体系热力学性质的预测也取得了令人满意的结果；同时对三个方程的比较分析表明：Wilson方程和T-K-Wilson方程在多元系热力学性质的预测中表现稳定，而NRTL方程由于引入了物理意义不清楚的第三参数，使得其具有不确定性和不稳定性的特点，因此Wilson方程和T-K-Wilson方程较NRTL方程更为优越；此外对局部组成型模型与其它模型（如Pelton-Flengas方程、Krupkowski方程、作用浓度模型和Hoch-Arpshofen模型）的比较表明：局部组成型模型同样是优秀的，甚至在某些方面更为简便和可靠。

In this study the meadow brown soil in northeast China was picked up as the object, through the research of Sn, Hg, Sb, and Bi desorption kinetics behavior in single and combined polluted soils we explored the desorption characters and rules of Sn, Hg, Sb, and Bi in polluted soils.

文章以我国东北地区草甸棕壤作为研究对象，通过对Sn、Hg、Sb、Bi单一及复合污染土壤中Sn、Hg、Sb、Bi的解吸动力学行为的研究，探索污染土壤中重金属Sn、Hg、Sb、Bi的解吸特性与规律。

The results show that Bi and Sb are mainly distributed on grains and grainboundaries, and Bi on grainboundaries there are mainly simple substance Bi particles, Sb in grains are intermetallics containing stibium. The tensile strength, yield strength, elongation and variation of area of halfhard brass containing bismuth and stibium are 478.9 MPa, 295 MPa, 15.1% and 29.3% respectively. Corresponding to HPb59-1, the cutting property of brass containing bismuth and stibium is excellent. The brass containing bismuth and stibium shows excellent dezincification corrosion resistance, and the depth is 323 μm.

结果表明：添加的Bi和Sb主要以单质或化合物方式存在于无铅黄铜的相内和相界处，Bi以单质颗粒存在于相界处，Sb以化合物形式存在于相内，这对提高合金切削性能有利；添加Bi和Sb黄铜的抗拉强度为478.9 MPa，伸长率为15.1%，断面收缩率为29.3%，屈服强度大约为295 MPa；添加Bi和Sb黄铜的切削性能比HPb59-1铅黄铜的优，合金的脱锌腐蚀性能良好，脱锌层厚度约为323 μm。

The structure measurement indicates that only a small amount of Bi3+ ions can not enter the A-site of La2/3Ca1/3MnO3 lattice. Because of the low melting behavior of bismuth oxide, the superfluous Bi will segregate as insulating bismuth oxides and bismuthate. Because of the segregation of Bi, the surface of the main phase has different ferromagnetic property from that of the core, namely the magnetic inhomogeneity of the samples is enhanced, which results in the broader ferromagnetism-paramagnetism transition and magnetoresistance plateaus in samples with the high Bi content.

结构测试表明Bi并不能进入La2/3Ca1/3MnO3的晶格锰位，由于A位元素的过量和铋氧化物的低熔点特性，烧结过程中Bi元素析出形成了绝缘性的第二相；并且Bi的析出导致样品主相的表面存在与主相体心磁性质不同的铁磁相，即样品的磁不均匀性增强，使得高Bi含量的样品表现出宽的铁磁-顺磁转变和磁电阻平台效应。

A preparation method of the visible-light photocatalyst Bi2WO6 nano-powder is characterized by comprising the steps as follows:(1) the selection of raw materials;(2) bismuth nitrate Bi(NO33 question mark 5H2O is added into a citric acid solution to obtain the citric acid solution containing white sediment;(3) EDTA is added into ammonia water which is then added dropwise with the citric acid solution containing the Bi(NO3)3 question mark 5H2O so to obtain a solution of bismuth;(4) the solution of bismuth is added with (NH4)6W7O24 question mark 6H2O solution to form a precursor solution which is then stirred, dried, coked, cooled and ground to obtain decarburized powder;(5) the decarburized powder is roasted for 2h to 4h under 450 DEG C to 550 DEG C to obtain the visible-light photocatalyst Bi2WO6 nano-powder.

可见光催化剂Bi 2 WO 6 纳米粉体的制备方法，其特征在于它包括如下步骤：1原料的选取；2将Bi(NO 3 ) 3 5H 2 O加到柠檬酸溶液中，得到含有白色沉淀的柠檬酸溶液；3将乙二胺四乙酸加到氨水中，并缓慢滴加入含有Bi(NO 3 ) 3 5H 2 O的柠檬酸溶液中，得铋的溶液；4将(NH 4 ) 6 W 7 O 24 6H 2 O溶液加入上述铋的溶液中，组成前驱液；搅拌，干燥，焦化，冷却后，研磨，得去碳的粉体；5将去碳的粉体在450～550℃下焙烧2～4h后，得到可见光催化剂Bi 2 WO 6 纳米粉体。

Chrysanthemum of 10 thousand birthday is lax to edaphic requirement, with the arenaceous qualitative loam with fecund, good drainage had better.

万寿菊对土壤要求不严，以肥沃。排水良好的砂质壤土为好。

He unstepped the mast and furled the sail and tied it.

他拔下桅杆，把帆卷起，系住。