英语人>网络例句>bath coating 相关的网络例句
bath coating相关的网络例句

查询词典 bath coating

与 bath coating 相关的网络例句 [注:此内容来源于网络,仅供参考]

The painting process of plastic has strict requirement for coating quality. If coating quality can't achieve use requirement, the coating must be recoated. So the preparation of plastic paint remover is paid attention to.

塑料涂装要求严格,稍有不慎,涂层质量难以满足使用要求,必须退掉重涂,塑料退漆剂的研制引起了人们的重视。

Blade coating Paper coating method where a surplus of coating is applied to the web and then levelled and controlled by a flexible steel blade.

刮刀涂布一种涂布方法。把大量的涂剂放于纸卷上面,然后把多余的涂剂用软性刮刀刮去,同时平滑涂层表面。

Blade coating: Paper coating method where a surplus of coating is applied to the web and then leveled and controlled by a flexible steel blade .

刮刀涂布:一种涂布方法。把大量的涂剂放于纸卷上面,然后把多余的涂剂用软性刮刀刮去,同时平滑涂层表面。

The companies use the coating technology for the world's leading technology, quality filter cathodic vacuum arc as FCVA coating technology is an international advanced coating technology.

本公司所运用的镀膜技术为全球领先技术,采用滤质阴极真空电弧镀膜技术简称FCVA技术是一种国际上先进的镀膜技术。

Since this product can be used with the tin in order to melting the surface, however we did not acquire the technology skill to melt the tin, which was caused the existence of non-uniform thin coating on the phenomenon.Our engineering staffs have reviewed and this problem has been solved, it is no longer thin coating melts the surface coating.Eventually we led our products TKEKK with pased of current 50A, it has obtained to the minimum partial fuse time.

因为此产品所用可熔体其表面是镀锡,因当时我们公司掌握的可熔体镀锡技术不成熟,导致所生产出的可熔体表面镀层存在镀层偏薄不均匀的现象,最终导致给我们的TKEKK产品通50A电流时,熔断时间偏下限,对此,我公司的工程人员通过技术改良,现已解决了此问题,现生产出的可熔体表面镀层已不存在镀层偏薄,不均匀的现象。

Anticorrosive process of surface evaporation air cooler using LLSTD-1 as coating media,which solves two major difficult problems in large scale bundle anticorrosive techniques:performance requirements on coating materials (heat conduction,high temperature resistance,oil-proof and scale inhibition)and the coating method on surface evaporation air cooler bundles.

以LLSID-1涂料为涂层介质对大型表面蒸发空冷器管束进行防腐处理,解决了大型管束防腐的两大难题,一是对涂层材料的性能要求(耐腐、耐温、耐油、阻垢、传热效果好);二是解决了大型管束防腐工艺(用什么方法将涂料涂装在表面蒸发空冷器管束上)。

Main -cassava starch Hanmei special starch powder candy fillings wrapped with modified starch powder used cationic modified starch paper surface sizing starch paper coating starch dedicated Wet add starch layers dedicated spray starch dedicated plasterboard dedicated starch re-wet adhesive tape with exclusive -starch tapioca starch Hanmei dedicated powder candy fillings wrapped with modified starch powder used cationic modified starch paper surface sizing starch paper coating starch dedicated dedicated add in Wet starch layer dedicated inter-spray starch starch gypsum board dedicated re-wet adhesive tape with exclusive -starch tapioca starch Hanmei dedicated powder candy fillings wrapped with Modified Starch Modified Starch powder with cationic surface sizing starch paper coating special paper made of starch wet end of paper to add a dedicated starch

公司朝着管理严谨,经营有序的现代化企业的方向前进。

Polishing machine coated roll and roll and penetrated the metering rollers, directly affects the product iuster is good or bad, such as coating roll and roll of clearance too large, you can Polish paper and coated rolls off the paper bad contact so that the oil absorption corresponding regarding the reduction of roll coating rollers and penetrated the size determines the amount of finish coating the, should be based on the paper--absorption of strong or weak, adjustment and coated roll roll the size of the gap in order to ensure that products on the light intensity.

上光机的涂布辊与衬辊和计量辊之间的间隙是否合适,直接影响到产品上光亮度的好坏,如涂布辊与衬辊的间隙调得太大,就容易使上光的纸面与涂布辊接触不良,使纸面吸油量相应就减少涂布辊与计量辊之间的间隙大小,则决定着上光油涂布量的大小,所以,应根据纸面吸收性的强弱,调整涂布辊与计量辊间隙的大小,才能确保产品上光的亮度。

The results showed that when PA1010 was filled with 1.5% n- SiO2, the properties of the coating was best .The coating-substrate adhesion stress was 28.9 MPa . The self-strength of the coating was 69.8 MPa. DSC analysis shown that n- SiO2 could increase the crystallization speed of PA1010 coatings obviously.

结果表明:当复合涂层配比为m(PA1010):m(n- SiO2)=100.0: 1.5时,复合涂层综合性能较佳,涂层自拉伸强度为69.8 MPa,涂层与基体结合强度为28.9 MPa;纳米SiO2有明显的异质成核作用,使复合涂层的过冷度由27.0 ℃下降为24.0 ℃;纳米SiO2能够显著提高涂层的力学性能,有助于提高复合涂层的结晶速率,具有明显的成核作用。

Machine speed, coating self-leveling coatings is short, thick, in order to achieve the same effect of drying, dry time identifying, temperature is higher; machine speed slow, coating leveling, coating it thin, dry period may be shortened, appropriate drying temperature can be reduced.

机速快时,涂层流平时间短,涂层就厚,为获得同样的干燥效果,干燥的时间要认、温度要高;机速慢,涂层流平时间长,涂层就薄,干燥时间可缩短,干燥温度可适当降低。

第17/50页 首页 < ... 13 14 15 16 17 18 19 20 21 ... > 尾页
相关中文对照歌词
Tongue Bath
Birds Take A Bath
Love Bath
Bath Of Fire
Uncle Harry
Bath Salt
Sweat
To My Face
The Oil Slick
Bed, Bath & Beyond
推荐网络例句

There had been a moment during the breakfast meeting, though, after the backslapping and the small talk and when all of us were seated, with Vice President Cheney eating his eggs Benedict impassively and Karl Rove at the far end of the table discreetly checking his BlackBerry, that I witnessed a different side of the man.

那次早餐会期间,在表示过关心和寒暄以后,我们所有人坐了下来,我注意观察了一下,副总统切尼面无表情地吃着班尼迪克蛋(Eggs benedict,源自美国,以英式松饼、火腿、水煮蛋以及荷兰酱组合而成),卡尔。罗夫在餐桌的远端谨慎地经常查看他的黑莓手机,我目睹了他所不为人知的一面。

Talk Undelete failed; someone else may have undeleted the page first.

Talk 无法删除选定的页面或图像(它可能已经被其他人删除了)。

When you leave a part of my life.

当你离开了,我只是希望你能幸福在以后的日子里。