查询词典 arithmetic al function

Based on the simplified method for subsoils of building given by Men et al., a effective stress method is suggested, combined with the use of the static model of pore water pressure generation presented by Martin et al., so that the development of pore-water pressure under the building subsoils can be evaluated directly. Comparing with the total stress method it is easier and more direct to be used.

根据门福录等提出的建筑物地基液化判别简化分析法，本文进一步提出一个有效应力的简化分析法，此法采用Martin等人的孔隙水压力发展的静力模型，可以直接求出地基中的孔隙水压力发展情况，较总应力法更直观和便于应用。

Myonecrosis after revascularization procedures［J］. J Am Coll Cardiol,1998,31:241251.［3］Tardiff BE, Califf RM, Tcheng JE, et al. Clinical outcomes after detection of elevated cardiac enzymes in patients undergoing percutaneous intervention［J］. J Am Coll Cardiol,1999,33:8896.［4］Simoons ML, Van den Brand M, Lincoff M, et al. Minimal myocardial damage during coronary intervention is associated with impaired outcome［J］.

研究显示，PCI术后往往伴随一定的心肌损伤，发生率约为5%～40%，临床表现为心肌损伤标记物水平的升高［17］；这种心肌损伤在大部分患者并不产生明显的临床症状和心电图变化，对其心脏功能也无明显影响，但是对患者的预后却有不良影响，使死亡率及不良事件发生率升高［38］。

Al-Qaeda Allies Claim Bigger Base of Support in Iraq - Forces allied with al-Qaeda in Iraq claimed yesterday to have broadened their base of support among Iraqi Sunnis, saying that 70 percent of tribal sheiks and a number of previously independent insurgent groups have pledged allegiance to what has been called the Islamic State of Iraq under its emir,...

盖达盟友声称伊拉克更大的支持-盟军部队与盖达组织在伊拉克昨已扩大了基地的支持伊拉克逊尼派70%称部落族长和一些以前独立叛乱团体已承诺效忠那被称为伊拉克伊斯兰国埃米尔下

Rice said the United States has a normal an enormous stake in the survival battle of that administration and the " defeat of al-Shabaab " and other extremly scroops fill extremists groups affiliated with al-Qaida.

赖斯说美国对那个政府的幸存，打倒阿尔沙巴，和其他与阿尔奇达相关的极端主义组织有很大的功劳。

It is the filling material in argon arc welding and oxygen-acetylene gas welding for the aluminum alloy weldment expect the Al-Mg alloy, it can get the better effect in deal with the heat crack of the strengthening Al-alloy.

HS311 AWS ER4043 除铝镁合金以外的的铝合金工件和铸铁氩弧焊及氧-乙炔气焊时作为填充材料，特别对易产生热裂缝的热处理强化铝合金，可获得较好的效果。

These factors have seriously influenced the security and economical operation of the unit. This paper firstly summarizes the research background and the general situation of resarch about the overheating problem of boiler's high-temperature surface ,introduces the aspects and research findings in this field such as flux deviation、thermal deviation、flue gas velocity deviation at the exit of furnace and tee bends,et al.Then analyses the reason why high-temperature surfaces are overheated from such aspects as design、manufacture、operation, et al and points out one of the main factors that cause the overheating of reheaters is the flue gas velocity deviation caused by the remaining turning at the exit of furnace.

本文首先综合论述了课题的研究背景和目前电站锅炉高温受热面超温问题的研究概况，介绍了国内外流量偏差、热偏差、炉膛出口残余旋转、&三通&等研究方向和研究成果，然后从锅炉的设计、制造、运行等方面分析了高温再热器超温的原因，指出水平烟道内气流的残余旋转是造成再热器超温的主要原因之一。

But when Fe/D113 precursor is pyrolysed in the range of 400-700℃, the crystal structure of the iron particle is different. The products are mainly iron oxides andα-Fe as Fe/D113 precursor pyrolysed at 500℃, and as the pyrolytic temperature increases to the range of 600-700℃,α-Fe and Fe_3C are observed. Meanwhile, Al_2O_3、MgO、MgAl_2O_4 were observed in Al/C, Mg/C, Al-Mg/C which were prepared from D113 resin at 1000-1300℃.

而在同样的条件下热解载铁树脂(Fe／D113)，热解产物中铁的晶体结构与热解温度有关，400℃热解产物为铁的氧化物；500℃热解产物为体心立方结构的单质铁；600-700℃的热解产物为bcc单质铁和铁的碳化物(Fe_3C)。1000-1300℃热解含Al、Mg及Al-Mg的D113树脂制得的Al／C、Mg／C、Al-Mg／C材料中Al、Mg主要以Al_2O_3、MgO、MgAl_2O_4形式存在。

Electrochemical examination and corrosion test showed that the Al-Ti and Al-Mn alloy platings have excellent corrosion resistance.

电化学测试及腐蚀试验结果表明，所得到的Al－Ti和Al－Mn合金镀层具有优异的耐蚀性。

In order to fabricate high–silicon aluminum alloy electronic packaging materials, the oxidating processes in high temperature oxygenation was applied to the Al-30Si and Al-40Si high-silicon aluminum alloys which were prepared through extrusion process. Scanning electron microscope, optical microscopy, thermal physical tester and universal material testing machine were used to study the microstructure, density, hermeticity, coefficient of thermal expansion, thermal conductivity and compressive strength.

摘 要：针对应用广泛的高硅铝合金电子封装材料，采用高温充氧氧化工艺，对已挤压成形的Al-30Si及Al-40Si高硅铝合金材料进行后续处理，通过扫描电镜、金相显微镜、热物性测试仪及电子万能拉伸试验机等，对材料显微组织、密度、气密性、热膨胀系数、热导率及抗压强度进行了分析比较。

In order to fabricate high–silicon aluminum alloy electronic packaging materials,the oxidating processes in high temperature oxygenation was applied to the Al-30Si and Al-40Si high-silicon aluminum alloy s which were prepared through extrusion process.

针对应用广泛的高硅铝合金电子封装材料，采用高温充氧氧化工艺，对已挤压成形的Al-30Si及Al-40Si 高硅铝合金材料进行后续处理，通过扫描电镜、金相显微镜、热物性测试仪及电子万能拉伸试验机等，对材料显微组织、密度、气密性、热膨胀系数、热导率及抗压强度进行了分析比较。

For the head-teacher of the class said that I had seriously broken the school rules,which led me to a three-day suspend class.

为什么呢？因为我的班主任说我严重的违反了校规，于是让我停课三天。

Many of them believe that the conversion of thousands of working-class folk in England spared that nation from the mass carnage and the tyranny that came with the revolution in France.

他们之中有许多人相信，在英国数以千计的劳工阶级之悔改信主使英国免於遭受如法国大革命所造成的大屠杀和专制暴政。