查询词典 angular coefficient

Wavelet multi-resolution analysis is applied to decompose the signal into multiple-level and the wavelet coefficient modules of its high-frequency components are obtained. The wavelet coefficient modules of a broken signal can be extracted by software demising. The threshold of demising is decided by the difference between the wavelet coefficient modules of a broken signal and those of a noise. The wavelet coefficient modules of the broken signal were shown in different levels, then the faults can be detected and distinguished by the integrated features of the variant levels' wavelet coefficient modules.

利用小波多尺度分解技术，将信号进行多尺度的小波分解，得到不同尺度下的信号高频分量的小波系数模值，并根据奇变信号和噪声信号小波系数模值的差异，采用软阈值去噪法，对其高频分量小波系数进行去噪处理，获取不同尺度上突变信号的小波系数模值，实现对故障的检测，并可根据不同尺度上小波系数模值的对应关系，实现对多重并发故障的区分。

Furthermore, transfer coefficient between total content and variable speciation including acid-soluble/exchangeable, reducible, oxidisable fraction of heavy metals are different. Transfer coefficient of total Cr is 0.65 in tailings area, but that of variable speciation is 0.26. In contrast with Cr,transfer coefficient of total Ni is 0.26, but that of variable speciation is 0.67. The similar characteristics on Pb and Zn in cultivated soil, namely, transfer coefficient of total Zn is high, but low for variable speciation, which is reversed for Pb. Transfer coefficient of total content and variable speciation in abandoned soil are low compared with above two fields soil, especially, variable speciation of Cu and Ni are not transported almost down soil profile.

重金属总量和活性态（包括弱酸提取态、可还原态、可氧化态）迁移率也表现出很大差异，尾矿区土壤Cr总量迁移率较高为0.65，而其活性态迁移率较低为0.26，Ni与Cr迁移特征完全相反，总量迁移率为0.26，而活性态迁移率为0.67；农田土壤中Pb总量迁移率低而活性态迁移率高，Ni与Zn特征相似，总量迁移率高而活性态迁移率相对较低；大棚地土壤中重金属迁移率均较低，Cu和Ni活性态几乎未发生向下迁移。

Single factor experiments were done with the factors including the width of protrusion and the trolley's velocity, which showed that the surface frictional coefficient decreases with the width of protrusion increasing, and doesn't change with the trolley's velocity changing, which was consistent with the results of the orthogonal experiment. A theoretical model of the horizontal projection of a corrugated bionic surface's contact area was built, which showed that the contact area's horizontal projection decreases with width and interval increasing respectively and that the ratio of the contact area's horizontal projection and the vertical load decreases with the vertical load increasing. It indicated that the surface frictional coefficient decreases with the above three factors increasing respectively. Finite element modeling and analysis of interactions of a plate and soils was done using ANSYS, which showed that the plate frictional coefficient is little relative to soil elastic modulus and decreases with vertical surface pressure and that trolley's pull and vertical displacement of bionic surface's control pilot keep constant almost during the plate being pulled. Finite element modeling and analysis of interactions of a corrugated bionic surface and soils was done using ANSYS, which showed that surface frictional coefficient is little relative to soil elastic modulus and decreases with bionic surface's structural parameters and vertical pressure increasing. However, the three factors all didn't affect the surface frictional coefficient remarkably on the condition of 90% dependability. For the first time, bionic surfaces were applied to screw piles, which formed bionic screw piles, and the contrast experiments showed the bionic screw pile had certain resistance-decreasing effects.

建立了波纹型仿生曲面与土壤的接触面积的水平投影的理论模型，表明接触面积的水平投影A随着波纹型仿生曲面突起宽度、两相邻突起间距的增大而减小，接触面积的水平投影与波纹型仿生曲面表面垂直载荷之比随着波纹型仿生曲面表面垂直载荷的增大而减小，进而得出仿生曲面摩擦系数随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小；利用ANSYS软件对平板与土壤的相互作用进行了有限元建模与分析，表明平板摩擦系数与土壤弹性模量关系不大，而随着表面垂直载荷的增大而减小；平板牵引过程中台车牵引力和仿生曲面控制节点垂直方向位移基本保持不变；利用ANSYS软件对波纹型仿生曲面与土壤的相互作用进行了有限元建模与分析，表明波纹型仿生曲面系数在一定范围内基本不受土壤弹性模量的影响，随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小，但在可信度为90％的前提下，三个因素影响都不显著；首次将波纹型仿生曲面应用于与土壤作用方式以挤压为主的螺旋桩，形成仿生螺旋桩，并与普通螺旋桩进行了沉桩对比试验，表明波纹型仿生曲面应用于螺旋桩桩体表面具有明显的降阻作用。

Angular spectral is spectral value map formed by estimating semblable coefficients of fast and slow shear wave or the variation of amplitude ratio of fast and slow shear wave with times and angles at a specified space point based on semblable theory of fast and slow shear wave, the angle value of this space point at a given time can be got by picking the maximum of angular spectral; the study reveals that fast and slow shear wave with different polarization direction should be separated using different rotation formula, eight formulas of separating fast and slow shear wave using clockwise rotation and counterclockwise rotation have been derived, and gained energy assignment rule and phase coincidence rule, in real data estimation, the rotation formula used for separating fast and slow shear wave can be uniquely determined on the two discriminating rules. On the basis of semblable theory of fast and slow shear wave, the delay time corresponding to the maximum of semblable coefficients at a specified point in a given time window is the delay time of fast and slow shear wave, delay time section of fast and slow shear wave can be got by moving space point and smoothing time window. The vertical variation values of delay time of fast and slow shear wave reflect the effect degree of vertical fractured reservoir on fast and slow shear wave which is defined as anisotropic coefficient, and section map of anisotropic coefficient can be obtained.

角度谱就是利用快慢横波的相似性原理，在某一空间点求出快慢横波的相似系数或快慢横波的振幅比值随着时间和角度的变化而形成的谱值图，拾取其极大值就得到该空间点某一时间的角度值；在研究中发现分离不同偏振方向的快慢横波应该采用不同的旋转公式，推导出了利用顺时针旋转和逆时针旋转分离快慢横波的八个公式，并给出了能量分配准则和相位一致性准则两个判别准则，在实际计算中利用这两个判别准则能唯一地确定分离快慢横波的旋转公式；根据快慢横波的相似性原理，在某一给定点和给定时窗内最大相似系数对应的延迟时间就是快慢横波的延迟时间，随着空间点的移动和时窗的滑动就可以得到快慢横波延迟时间的剖面图；快慢横波延迟时间与慢横波传播时间的比值定义为裂缝密度，并求出了裂缝密度剖面图；快慢横波延迟时间纵向上的变化值的大小反映了纵向上裂隙层对快慢横波影响的大小，定义为各向异性系数，并求出了各向异性系数的剖面图。

In the analysis of the frequent spectrum and the reflection coefficients, based on Godas two-points method which fit to the normal incident wave, a modified two-points method is derived that can be used to calculate the frequent spectrum and reflection coefficient of the oblique waves from which the frequent spectra of incident waves and reflected waves incoming in arbitrary angular, the bulk reflection coefficient and the frequent spectrum of reflection coefficient could be computed, also from which in theory the waves could be measured in two wave gauges which is disposed at any direction.

为了分析单向不规则波入射波的频率谱和反射系数，本文在Goda用于分析正向不规则波的两点法的基础上，提出了可用于斜向不规则波频谱分离及其反射系数计算的改进两点法，该方法可用于计算任意波浪入射角的入、反射波谱、总体反射系数和反射系数的频率谱，并且测量波浪过程的两浪高仪可在较广的方向范围内布置。

In the analysis of the frequent spectrum and the reflection coefficients, based on Goda's two-points method which fit to the normal incident wave, a modified two-points method is derived that can be used to calculate the frequent spectrum and reflection coefficient of the oblique waves from which the frequent spectra of incident waves and reflected waves incoming in arbitrary angular, the bulk reflection coefficient and the frequent spectrum of reflection coefficient could be computed, also from which in theory the waves could be measured in two wave gauges which is disposed at any direction.

为了分析单向不规则波入射波的频率谱和反射系数，本文在Goda用于分析正向不规则波的两点法的基础上，提出了可用于斜向不规则波频谱分离及其反射系数计算的改进两点法，该方法可用于计算任意波浪入射角的入、反射波谱、总体反射系数和反射系数的频率谱，并且测量波浪过程的两浪高仪可在较广的方向范围内布置。

B Angular momentum is a vector quantity as are also angular velocity, angular acceleration and torque.

角动量是个矢量，角速度和角加速和转矩也都是矢量。

Angular momentum is a vector quantity as are also angular velocity, angular acceleration and torque.

角动量是个矢量，角速度和角加速和转矩也都是矢量。

The positions of cam and dial were analyzed accompanied with their angular position, angular velocity and angular acceleration.

分析了凸轮和转盘的位置、角速度、角加速度的变化规律，给出了直角式精密分度凸轮的设计算法，同时计算了数控加工的刀位轨迹，并给出了四坐标联动数控加工和编程方法。

First, a program which can be used to obtain the encoder values of each joint D. C. servomotor and then change them into angular position is developed. By means of cubic spline, the angular velocity and angular acceleration are calculated.

本文开发了实时采集和转换机器人各关节的码盘值为角位移的程序，并提出了以三次样条函数求各关节角速度和角加速度的方法，提高了计算精度。

Fostering the concept of multi-culture firmly and mastering the development of advanced culture correctly are conductive to resisting terrorism, separatism of nationalities and ultraism of religion, which is of great academic theoretical, immediate and profound historical si...

牢固树立多元文化的理念和正确把握先进文化的发展方向，有助于在世界范围内自觉地抵制恐怖主义，民族分裂主义和宗教极端主义。不仅具有重大的学术理论意义，而且也具有重大的现实意义和深远的历史意义。

But if anyone walks in the night, he stumbles, because the light is not in him.

11：10 若在黑夜行走，就必碰跌，因为那光不在他里面。