查询词典 Meridian Gate

Tunneling allows voltage to flow from the control gate to the floating gate through the dielectric layer of oxide which separates them.

允许从隧道流电压控制的浮动栅栅绝缘层氧化物通过分隔他们。

In derivations of these equations, the discharges which flow through the check gate are calculated with the orifice equation for building the relationship between upstream pool and downstream pool of the gate.

在公式的推导过程中，过闸流量采用的是大孔口出流公式，没有采用工程中常用的闸孔出流公式，这是为了便于建立上、下游渠池间的联系。

It reports the effect of water to the order frequencies of frame,and gained the relationship between stiffness ratio of the gate and the plane steel frame of the radial gate.

对弧形钢闸门主框架动力稳定性进行了分析，考虑了水深对框架固有频率的影响，并比较梁柱刚度比对弧门主框架动力稳定性的影响关系。

In order to solve those problems, this article adopts the energy method to analyze the stability of the major frame of steel arch gate to make up the weakness in the current standards and found the calculating models of the stability of the whole major frame of the steel arch gate.

本文主要采用能量法对弧形钢闸门主框架线弹性稳定性进行分析与研究，建立单柱概化弧形钢闸门主框架整体稳定的计算模型，并通过选择合适试解函数，应用能量法给出特征值方程及弧门框架稳定性计算长度系数精确解的公式，提出一个基于该模型方便工程设计的实用计算公式。

Base on ANSYS program, the Tianjin Cihai Bridge ferries wheel tower leg hoisting gate frame was analyzed, the computational results were compared with the experimental results, the fact indicates establishing the finite element model may be a good way to analyze gate stress situation, providing the theoretically basis for the construction control.

通过使用ANSYS有限元程序对天津市慈海桥摩天轮塔腿吊装门架进行分析，通过将实测结果和计算数据进行对比，事实表明所建立的有限元模型可以很好的分析门架受力情况，为施工控制提供理论上的依据。

It is mainly made up of frame, gate board, screw pole, nut etc. rotate the handwheel by hand, then the screw pole drives the nut and gate board move in horizontal to and fro to open or close the valve.

螺旋闸门工作原理 working principle 主要由框架、闸板、丝杆、螺母等零件构成，用手转动手轮使丝杆带着丝杆螺母和闸板沿水平方向往复运动，达到闸门的启闭目的。

It is mainly made up of frame, gate board, screw pole, nut etc. Rotate the hwheel by h, then the screw pole drives the nut gate board move in horizontal to fro to open or close the valve.

主要由框架、闸板、丝杆、螺母等零件构成，用手转动手轮使丝杆带着丝杆螺母和闸板沿水平方向往复运动，达到闸门的启闭目的。

It is mainly made up of frame, gate board, screw pole, nut etc.Rotate the handwheel by hand, then the screw pole drives the nutand gate board move in horizontal to and fro to open or close thevalve.

主要由框架、闸板、丝杆、螺母等零件构成，用手转动手轮使丝杆带着丝杆螺母和闸板沿水平方向往复运动，达到闸门的启闭目的。

It is mainly made up of frame, gate board, screw pole, nut etc. Rotate the handwheel by hand, then the screw pole drives the nut a nd gate board move in horizontal to a nd fro to open or close the valve.

主要由框架、闸板、丝杆、螺母等零件构成，用手转动手轮使丝杆带着丝杆螺母和闸板沿水平方向往复运动，达到闸门的启闭目的。

Traditionally,loads of the arc gate are applied on the support or gate frusta as a set of concentrated load,but the effect range of such load on the frusta cannot be solved by Material Mechanics and Structure Mechanics. Most of the load cases are fulfilled through optic-elastic test.

通常弧门荷载作为一组集中荷载作用于牛腿或闸墩上，而这组荷载对闸墩受力的影响范围材料力学方法和结构力学方法是不能解决的，受力状况大部分是通过光弹试验完成。

In the chapter 2, the theoretic knowledge about the photosensitive resin and the grinding tools was firstly introduced.

第二章阐述了光固化树脂结合剂磨具的相关理论研究。

Do not use the program's indenting or margin-setting features; these will be added during typesetting.

不要使用缩排，页面边缘设置之类的选项，偶看不大懂。