查询词典 Cook Inlet

The relevant steps have been put forward to solve the problems about the stability of the slopes of the spandrel groove and water inlet.

针对研究中发现的上述问题提出了相应的处理措施。

The system calculation and analysis on stress field, displacement field and failure zone indicate the high rock slope of spandrel groove and water inlet are stable if they are excavated in the designed slope ratio.

通过对拱肩槽及进水口边坡的应力场、位移场和破坏区域模拟计算表明：拱肩槽、进水口边坡在拟订的开挖坡比条件下整体均处于稳定状态。

The local stability analysis on the rock slope indicates there exist unstable rock-mass blocks in the rock slope of spandrel groove and water inlet which have different level threats to the excavation and operation of the slope.

边坡局部稳定性分析表明：拱肩槽、进水口边坡均存在不同程度的不稳定性块体，对边坡开挖施工和后期工程运行存在不同程度威胁。

Car flooded the water will enter the engine from the inlet resulting in engine flameout this time there will be water accumulation in the cylinder chamber and spark plugs in braving the water if the owner starts the engine the piston will Top connecting rod bend or even cylinder head roof leak causing irreparable damage.

车被淹后，水就会从进气道进入发动机，从而导致发动机熄火，这时候就会有水吞积在汽缸室，而火花塞在顶着水的情况下，如果车主启动发动机，就会把活塞连杆顶弯，甚至将缸盖顶漏，造成安全阀不可挽回的损失。

The groove type for the joint of inlet/outlet pipe and main pipe of nuclear reactor pressure vessel is J type, which intersect the spherical surface. And the space between inputlet and outlet is small, welding distortion is small required, so welding become more difficult.

核反应堆压力容器进出口接管与主管道相连接部位的坡口形式为J形，且与球面相交，进出口接管间距小，要求焊后变形小，焊接难度较大。

This is a high degree of water surface to pump impeller center of the vertical distance, it allows a high degree of vacuum suction, can not be confused with manual water pumps or marked on the nameplate on the vacuum suction to allow a high degree refers to pump inlet section on the value of the vacuum, and Is a standard atmospheric pressure, water temperature 20 degrees Celsius circumstances, a pilot and a determination.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵产品说明书或铭牌上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下、水温20摄氏度情况下，进行试验而测定得的。

The high is the water surface to pump impeller center line of the vertical distance, it allows a high degree of suction on the vacuum can not be mixed up, pump product specifications or nameplate allows a high degree of vacuum suction on the pump inlet section refers to the vacuum value, and Standard chemical pump is a standard atmospheric pressure, water temperature 20 degrees Celsius case, trial and determination to come by.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵产品说明书或铭牌上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下、水温20摄氏度情况下，进行试验而测定得的。

The high water means the water pump impeller to the center line of the vertical distance, which permit smoking should not be confused on a high vacuum pump nameplate on product label instructions or permit smoking on the high vacuum pump is the inlet of the vacuum on the value of cross-section, and are at one standard atmospheric pressure, water temperature 20 degrees Celsius, the determination to carry out a test.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵产品说明书或铭牌上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下、水温20摄氏度情况下，进行试验而测定得的。

The high water means the water pump impeller to the center line of the vertical distance, which permit smoking should not be confused on a high vacuum pump nameplate or product label instructions on the permit smoking on the high vacuum pump is the inlet of the vacuum on the value of cross-section, and are at one standard atmospheric pressure; the water temperature 20 degrees Celsius, the determination to carry out a test.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵铭牌或产品说明书上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下；水温20摄氏度情况下，进行试验而测定得的。

Based on the N-S equation, standard κ-ε turbulence model, the FLUENT was used to simulate the kind of air inlet of solid ducted rocket.

基于RANS平均的N-S方程、标准κ-ε双方程湍流模型，利用FLUENT软件对某型固体火箭冲压发动机进气道内外流场进行了三维数值模拟。

Don not attempt to do something which you can not to do.

不要企图做那些办不到的事情。

The expression of CTGF and TNF-αweredetected by immunochemistry and the number of Clara Cells was calculated.

光镜下观察肺组织的病理变化，采用免疫组化染色观察肺组织中结缔组织生长因子和肿瘤坏死因子-α的表达和Clara细胞的数量。