转动半径

词组短语

radius of gyration

与转动半径相关的网络例句 [注：此内容来源于网络，仅供参考]

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

Quantity of angular motion in the sagittal and coronal planes is likely to provide protection against adjacent-segment disease. Also important is the quality of motion, including radius of curvature, shear properties, and location of the instantaneous axis of rotation.

在矢状面和冠状面的角活动度的测量可能提供阻止临近节段疾病的方案，通用重要的是活动度的质量，包括曲率半径，剪切力的性质，转动瞬轴的位置。

"Cardioid:a heart-shaped plane curve, the locus of a fixed point on a circle that rolls on the circumference of another circle with the same radius."

心脏线：一种心形的平滑曲线，圆周上一固定点绕另一具有相同半径的圆的圆周转动的轨迹。

In this paper, the theoretical model of CQI is described in an atom-diatom system in the condition of the molecular beam, based on the first-Born approximation of time dependent perturbation theory, taking into accounts the anisotropic Lennard-Jones interaction potentials. The method of observing and measuring correctly the differential interference angle is presented. The relation between differential and parameter, velocity is obtained. The relation of the integral interference angle and temperature is discussed.

文中利用一阶含时波恩近似和L-J相互作用势，建立了原子-双原子分子碰撞系统转动传能的量子干涉模型，描述了观察和测量微分干涉角的方法，得到了微分干涉角与碰撞半径和碰撞速度间的关系，同时也得到了积分干涉角和实验温度的关系。

Structure form adopts converse triangle beam double-hole connection welded by general electric trolley wall plate and steel plate, connection shaft, triangle beam bottom is connected with girder by nut and thrust bearing, triangle beam could rotate 360 degrees horizontally, thus realize whole set electric trolley horizontal rotation, largely reduce curve track curvature radius of electric hoist traveling mechanism.

描述： 结构形式采取通用电动小车墙板与一个钢板和连接轴组焊的倒三角形吊梁双孔连接，三角吊梁下面通过螺母及推力轴承与一个横梁连接，三角吊梁相对横梁可在水平方向做360度旋转，从而实现电动小车的整体水平方向转动，大大减小了电动葫芦运行机构弧形轨道曲率半径。

Rubberand drum at maximum force at A point of RADIUS R1 and minimum mechanical Department b. RADIUS R2 is different, rubber roller compression over C forms the convex hull, the radius of the highlast C is R3, point b is the radius of the lining of the RADIUS rubberand drum after three RADIUS R1 with the size of the change of Center distance drum to determine the ideal pressure: 0.5mm by Feller gauge or flattening of galvanized wire to precise tuning of two drums of hobber pillow gap, so that it is up to the required data.

橡皮滚筒在最大受力处A不面的半径R1和最小受力处B不面的半径R2是差别的，橡皮滚筒受不抬后转动在C处变成凹包，凹包最矮不面C的半径是R3，B不面的半径是包衬后的橡皮滚筒半径不一个半径的巨细的R1 用保留滚筒洋心距来猜测抱负不张力：用塞尺或0.5mm的铅丝不抬扁来大略不天调动二滚筒的滚枕间隙，使之符分规矩的数据。

"The third planet from the sun, having a sidereal period of revolution about the sun of 365.26 days at a mean distance of approximately 149 million kilometers (92.96 million miles), an axial rotation period of 23 hours 56.07 minutes, an average radius of 6,374 kilometers (3,959 miles), and a mass of approximately 29.11 10 kilogram s (13.17 10 pounds)."

"离太阳第三远的行星，绕太阳转动的恒星周期为365.26天，平均距离大约是1.49亿平方公里(9，296万英里)，自转一周的周期为23小时56.07分，平均半径为6，374公里(3，959英里)，质量大约是29.11×10千克(13.17×10英镑)。"

A numerical simulation of this model shows that one of the methods to improve the efficiency of an optical tweezer is to change variant conditions, such as the microrotors speed is in proportion to the lasers power and has a nonlinear relation with the beam's waist.

基于此种模型的分析结果表明改变环境参量是提高光镊工作放率的方法之一，如微转子转动速率与光镊的激光功率成正比，与束腰半径成非线性关系。

Based on the simulation data, the effects of clearances, damping coefficient and the rotation speed on the dynamic behaviors are studied: compared with ideal mechanisms, mechanisms with clearances are less stable; as for mechanisms with clearances, when the crank rotates at the speed of 100rad/s, the actual clearances are always above the radium of clearances, axle pin and axle cover keep contact throught the rotation; when the crank rotates at the speed of 20rad/s, mechanisms are in an unstable state, at an angle of about 300, the actual clearances are below the radium of clearances, pairs lose contact, which results in collision between them; with the speed of 20rad/s, when damping coefficient is assumed 175Ns/m, distinct separation and collision happen between pairs; when damping coefficient is assumed 220Ns/m, separation and collision are controlled.

在含间隙机构中，当曲柄以100rad/s转动时，运动副间隙始终大於半径间隙，轴销与轴套始终保持连续接触；当曲柄以低速20rad/s转动时，系统处於极不稳定的震荡状态，在转至300°左右时，运动副间隙小於半径间隙，脱离接触，发生明显的分离碰撞现象。在含间隙机构中，曲柄以低速20rad/s转动，当取法向阻尼系数为175Ns/m时，副元素发生明显的分离碰撞现象；当取法向阻尼系数为220Ns/m时控制了副元素的分离，副元素一直处於连续接触状态。

Haihe River Bridge opened by the East and West Approach and the main bridge consists of three parts, the main bridge structure is designed to enact rotary steel beam, the net cross 68 meters, turning radius of 35 meters, beam rotation angle of 85 degrees, at the international bridge in the same belong to large-scale, long-span bridges of legislation to open one of the rotor.

海河开启桥由东西引桥和主桥三部分组成，主桥结构设计为立转式钢结构悬臂梁，净跨68米，转动半径为35米，梁端转动角度为85度，在国际同类桥梁中属于大规模、大跨径的立转式开启桥之一。

与转动半径相关的网络解释 [注：此内容来源于网络，仅供参考]

gyration vector：转动矢量

gyration radius 回转半径 | gyration vector 转动矢量 | gyratory motion 陀螺运动

radius of gyration of area：断面二次半径

radius of gyration 转动半径,环动半径,回转半径 | radius of gyration of area 断面二次半径 | radius of inertia 惯量半径,惯性半径

turning saw：旋转锯

转向半径 turning radius | 旋转锯 turning saw | 转动滑阀 turning slide valve