- 更多网络例句与起泡金属相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Among several neutral oils, transformer oil shows the best agglomeration effect. For the complex tailings, in which over 90% of molybdenum distributed in the range of -0.038 mm, the optimal dosage of transformer oil and frother was about 12 kg/t and 0.5 kg/t respectively, and the least agitation time and rate should above 3 min and 400 r/min, respectively.
结果表明，在众多中性油中，变压器油表现出了较好的油团聚浮选效果，对于钼金属分布率高于90%的-0.038mm粒级的浮选尾矿，其合适用量需达到12kg/t左右，与之配合的起泡剂用量在0.5kg/t左右，油团聚时间及搅拌强度分别需达到3min和400r/min以上。
-
Usage 1. Metal surface paint remove method: Brush objects in need of the paint remover on the surface, in a few minutes the old Membrane will be soften, wrinkling, blistering and then fell off, then use water wash off the impurities; for special thick coating, can spray once more before washing, or clear the residue with a piece of sandpaper or a shovel knife.
使用方法金属表面脱漆方法：将本品刷涂于需脱漆层表面，数分钟内旧膜即可软化、起皱、起泡进而脱落，再用水将脱落杂质清洗干净，待其干燥；对于特别厚的涂层，可重复使用一次，再用水冲洗干净，或配以砂纸和铲刀清除局部残留即可。
- 更多网络解释与起泡金属相关的网络解释 [注：此内容来源于网络，仅供参考]
-
blister：起泡
增进对所有金属的附著力、改进耐盐雾阻力、减少起泡(blister)、耐刮. 增加对塑胶、混凝土、橡胶、木器及陶瓷的附著力. 含有胺(Amino)官能基的金属有机锆酸铝密著增进剂. 用於下列:1、接著剂:对大部份的压克力乳胶及类似的乳胶乳液接著剂及水性环氧、水性PU接著剂,
-
non-ferrous metal：非铁金属
non-foaming test 不起泡试验 | non-ferrous metal 非铁金属 | non-ferrous alloy 非铁合金
-
threaded pipe：螺纹管
碳酸引起的低PH会侵蚀金属,尤其在螺纹管(threaded pipe)及受力(stressed)部位最为严重. 因空气泄入或氧气脱氧不良而使蒸汽或凝结水中含溶存氧,会导致全面(general)和局部(localized)腐蚀,其反应如下:起泡(foaming)是水份、油、处理药品、溶解盐类等挟带的基本原因.
-
sparkle metal：起泡金属
sparkle ==> 火花,闪 | sparkle metal ==> 起泡金属 | sparkless commutation ==> 无火花整流=>無火花整流