起始板

词组短语

starting sheet

与起始板相关的网络例句 [注：此内容来源于网络，仅供参考]

It is effective ways of improving iron oxide powder on surface of hot rolled steel sheet to lower strip's initial cooling temperature and reduce strip's inside and outside temperature gradient.

通过调查、统计与对比试验，分析了SN400B钢板表面氧化铁粉的成因及影响因素，指出降低带钢起始冷却温度、减少带钢内外温度梯度是改善热轧板表面氧化铁粉的有效途径。

It can decrease the number of initial connection on interface and the operation of remote procedure call,and satisfy the demand for cross platform and distributed application of streaming media.

该讨论板能够减少对界面的起始连接和调用远处对象的操作，实现了跨平台和分布式流媒体应用的需求。

Methods Twenty-two pieces of temporal bone were taken for this study. The mastoid cavity was opened, scutum removed,"bridge" broken down, posterior wall of external auditory canal abraded and the related anatomic structures were fully exposed. The distance between the origin of facial nerve canal and the anterior border of round window （ OOFNC-ABORW ）, between the highest point of the facial nerve canal and the bottom of posterior mastoid sinus,and between the stapes head and round window niche was measured under operating microscope.

方法取成人颞骨22侧（左右各11侧），用耳科钻磨开乳突腔，去上鼓室盾板、断"桥"，磨低骨性外耳道后壁，充分暴露相关结构，在手术显微镜下测量面神经管垂直段起始部前缘至圆窗龛前缘的距离、面神经管最高点与后鼓室底壁之间的距离、锥隆起的高度（即锥隆起基底到锥隆起顶端的距离）、镫骨头至圆窗龛前缘的距离。

The results demonstrated that, by comparison with un-transgenic Roselle cell or callus, the critical plating cell density and critical initiating cell density of transgenic cell line were cut down 60% and 50%, respectively,the growth cycle of transgenic cell in suspension culture was shortened from 16 days to 12 days, and the specific growth rate of transgenic Roselle callus was raised 75%, the content of flavonoid compounds in transgenic Roselle cell line or callus was hardly altered.

研究结果表明，所获得的转基因玫瑰茄细胞系的临界植板细胞密度和临界起始细胞密度分别降低了60%和50%，悬浮细胞培养周期由16d缩短到12d，转化愈伤组织的比生长速率比对照提高了75%，转基因玫瑰茄细胞和愈伤组织中的花黄素含量与对照相比没有发生明显变化。

Butt Weld and docking and corner combinations Weld, in Weld ends located arc plate and extraction plate in igniting board then leads to the welding seam, joint halfway shall weld joints in front of 2.0 mm Department Firing arc, welding pieces after preheating rod will return to weld the origin, pool filled to the required thickness, before forward welding; Welding speed : Isokinetic welding requirements to ensure weld thickness, width uniform, which masks to look for hot metal and slag bath equidistance (2-3 mm)%; Arc welding rod length : different models and determined that the general requirements of arc length is stable, acid electrode generally 3-4 mm, 2-3 mm normally alkaline electrode%; Welding perspective : According to determine the thickness of two pieces of welding, welding angle has two aspects : First, the angle between the direction of the rod and welding of 60-75 ; The second is the angle between two electrodes and welding around, the same thickness as welding, welding and welding pieces incident angle of 45 ; When the thickness ranging from welding, welding electrode and thick and thin pieces of welding electrode side angle greater than the angle between the side pieces; Arc : admission to the end of each weld should be filled crater, in the direction opposite to the direction of the back-arc welding, arc welding unchanged inside pit in 1974, to prevent the crater bite of meat.

对接焊缝及对接和角接组合焊缝，在焊缝两端设引弧板和引出板，必须在引弧板上引出后再焊到焊缝区，中途接头则应在焊缝接头前方15～20㎜处打火引弧，将焊件预热后再将焊条退回到焊缝起始处，把熔池填满到要求的厚度后，方可向前施焊；焊接速度：要求等速焊接，保证焊缝厚度、宽度均匀一致，从面罩内看熔池中铁水与熔渣保持等距离（2～3㎜）为宜；焊接电弧长度：根据焊条型号不同而确定，一般要求电弧长度稳定不变，酸性焊条一般为3～4㎜，碱性焊条一般为2～3㎜为宜；焊接角度：根据两焊件的厚度确定，焊接角度有两个方面，一是焊条与焊接前进方向的夹角为60～75 ；二是焊条与焊接左右夹角有两种情况，当焊件厚度相等时，焊件与焊件夹角为45 ；当焊件厚度不等时，焊条与较厚焊件一侧夹角应大于焊条与薄焊件一侧夹角；收弧：每条焊缝焊到末尾，应将弧坑填满后，往焊接方向相反的方向带弧，使弧坑甩在焊道貌岸然里边，以防弧坑咬肉。

Methods of ultrasonic C scan, deply, etc were used to measure the damages of the laminates. The CAI strengths of laminates with the quasi static indentation damage were compared with that of laminates after ...

结果表明：在横压过程中存在分层损伤起始门槛压缩载荷值或压入深度值，以及横压载荷极限值；小板试件各界面的分层面积沿厚度方向的分布和继后的压缩破坏形式等与 SACMA的 CAI试验标准的情况相异

Methods Twenty-two pieces of temporal bone were taken for this study. The mastoid cavity was opened, scutum removed,"bridge" broken down, posterior wall of external auditory canal abraded and the related anatomic structures were fully exposed. The distance between the origin of facial nerve canal and the anterior border of round window （ OOFNC-ABORW ）, between the highest point of the facial nerve canal and the bottom of posterior mastoid sinus,and between the stapes head and round window niche was measured under operating microscope.

方法取成人颞骨22侧（左右各11侧），用耳科钻磨开乳突腔，去上鼓室盾板、断&桥&，磨低骨性外耳道后壁，充分暴露相关结构，在手术显微镜下测量面神经管垂直段起始部前缘至圆窗龛前缘的距离、面神经管最高点与后鼓室底壁之间的距离、锥隆起的高度（即锥隆起基底到锥隆起顶端的距离）、镫骨头至圆窗龛前缘的距离。

For lifts in triples battery cabin:straight joint panels or stainless decorated at the choice of MDO cabin and landing doors :stainless with graining of the STB initials of the landing door at the level of GF floor:in granite or in similar colour at the choice of MDO false ceiling:in stainless steel with decorated luminous lattice plaint:in stainless steel on the three sides inside panel:mirror on all the height of the cabin up to current hand fou the management lift cabin:panels in noble woodand moldings colours at the choice of MDO

因为在三倍之数电池中的举起小屋：直的关节嵌板或无瑕疵的在 MDO 的选择装饰小屋和登陆门：无瑕疵的与登陆门的 STB 起始的漆木纹在 GF 的水平地错误的天花板：在不锈钢中以被装饰的发光格子悲叹：在这三边上的不锈钢中在嵌板内：在小屋的所有高度上的镜子决定于现在的手fou 管理举起小屋：在 MDO 的选择的在高贵的木材(acajou 或其他的)和成型颜色的嵌板板：在 MDO 的选择的花冈岩或相似的颜色中

与起始板相关的网络解释 [注：此内容来源于网络，仅供参考]

capillary：毛细管

将一个毛细管(capillary)浸入溶液,取约3mm溶液,布于一薄层色谱板(TLC 板TLC plate). 用同样方法将起始物质布于另一TLC板作为参比物. 用1:6乙酸酯-庚烷(acetate-heptane)洗脱TLC板,洗脱后的TLC板可在UV光(254配合物中氨的分析 用移液管吸取 0.1 M HCl 标准溶液20 mL,

spiral limbus：螺旋缘

骨螺旋板是蜗轴骨组织向外侧延伸而成,其起始部骨膜增厚并突入膜蜗管形成螺旋缘(spiral limbus). 膜螺旋板又称基底膜,内侧与骨螺旋板相连,外侧与螺旋韧带相连. 膜蜗管底壁的上皮增厚形成螺旋器,为听觉感受器.

position sensor：位置传感器

error code)测量系统不能使接收到的信号与数据测量同步.出错号410:接收不到滤光片轮位置传感器(position sensor)信号.出错号411:接收不到滤光片轮起始位置传感器(home sensor)信号.滤光片轮位置传感器(position sensor)坏.光电表板(ph