- 更多网络例句与蒸发管相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The amount of solution elevation, the vapor amount and the maximum height of the elevated solution are related to different heat loads.
得出了浓溶液的提升量、蒸汽发生量、浓溶液最大提升高度对应于不同的加热负荷的关系曲线，实验发现这种蒸发管是一种有效的强化传热管。
-
The variations of vaporization rate of Micro "T"-Vaporizer under various working conditions were studied.
研究了微小尺寸"T"型蒸发管燃油蒸发率在不同工况下的变化规律。
-
82 Times as high as the flow rate at the inlet; the velocity profile in the lower region is relatively uniform, and changes at the exit from a parabolic shape towards a plug flow as Re increases; The strong circulating flow in the upper region is very favourable to evaporization of heated fluid because it not only forces all the heated fluid to flow through the liquid surface and, therefore, to evaporate effectively, but also causes a large part of fluid to recirculate to the liquid surface and, therefore, to get a second opportunity of evaporization. In addition, the uniform velocity profile in the lower region is also favourable to crystallizing process.
轴向进料蒸发室进口管侧上方有强烈的循环流存在，循环流流量为进口流量的1.48～1.82倍；循环流下部流速分布较均匀，出口区流速在低Re时为抛物线分布，高Re时接近活塞流；强烈循环流的存在不仅迫使加热流体全部流经液面及其附近进行充分蒸发，而且之后还使相当部分流体再次循环回到液面及附近进行二次蒸发，对蒸发操作十分有利；蒸发室下部流速的均匀分布亦有利于蒸发结晶过程。
-
In Horizontal Thin Film evaporator, the liquor spray into out surface of horizontal heating tube and part of them veaporates.
在卧管蒸发系统中，料液喷淋在水平管的管外，其中部分产生蒸发，加热蒸汽走管内并发生冷凝。
-
Simulation on the inner flow field of a horizontal tubes of falling film evaporator in a refrigeration system was performed using two-phase flow model VOF in FLUENT,and the influence of different tube arrangements on the flow field was examined.
采用FLUENT两相流VOF模型，对制冷系统中水平管降膜式蒸发器内部流场进行了数值模拟，研究了蒸发器内部蒸发管的不同布管方式对蒸发器内部流场的影响。
-
Anodized aluminum alloy tube and organic TiO2/ coated aluminum alloy tube are used as the heat exchange tube of horizontal tube falling film evaporator in this experiment,and the effect of seawater flow rate and seawater evaporation temperature on heat exchange property is discussed,as well as the properties of anti-corrosion and anti-scale.
选用阳极氧化和TiO2纳米颗粒填充聚氨酯涂层的铝合金管作为水平管降膜蒸发器的换热管，考察了海水喷淋密度、改性方式、海水蒸发温度对水平管降膜蒸发传热特性的影响，分析了铝合金的耐腐蚀性和抗垢性。
-
The direct evaporative internal-melt ice storage air conditioning is a new and promising technology.It is important to master the ice coil heat transfer performance for the project.The paper analysed the dynamic characteristics and established the corresponding mathematical models of the system,and used the model to analyse the performance of caving cooling process changes.The model for direct evaporation in the U-shaped ice-melting ice storage VRV system couldbe helpful to design and optimization theory.
直接蒸发内融式冰盘管是空调蓄冷工程中常用的一种方式，对这种冰盘管的融冰传热性能的掌握对于工程应用非常重要，本文对基于VRV空调系统的内融式U形冰盘管融冰过程的动态特性进行了分析，建立了相应的数理模型，并利用该模型分析了放冷过程的性能变化，该模型可为直接蒸发内融式U形冰蓄冷VRV融冰系统的设计及优化提供理论依据。
-
Water inside vacuum heat- collection tubes; since the hot medium inside vacuum tubes floats up and cold one goes down due to respective specific gravity, hot and cold mediums convections up and down to cause the heat conduction, furthermore transfer the heat to the related working medium in the heat tubes, the working medium sorbs the potential heat and becomes steam to rise up to the condensing section from the tube heat evaporating section; it emits the heat in condensing section to change again into liquid working medium; it flows back to evaporating section under the gravity action, the emitted heat is transferred into the water inside water tank or tube group by means of the heat-conduction through heat tubes condensing section; it makes the cold water in water tank into hot water in the repeated way.
阳光透过全玻璃真空集热管的外玻璃，照射到涂覆在内玻璃管外表面的选择性吸收涂层上，涂层将太阳的辐射能吸收并转化为热能，通过内玻璃管壁导热，传递给真空集热管内其液态传热介质，由于真空集热管内热的介质因比重小而上浮，冷的介质因比重大而下沉，冷热介质上下对流传热和导热，再通过热管的金属壁导热，将热量传递给热管内其相变工质，工质吸收汽化潜热而变成蒸汽，由热管蒸发段上升到冷凝段，在冷凝段放热冷凝，又变成液态工质，在重力作用下流回蒸发段，所放出的热量通过热管冷凝段金属管壁导热，传递给水箱或联集管内的冷水，周而复始，于是便将水箱内的冷水全部加热成热水。
-
For different configuration of the distributor,the flows of R134a outside the horizontal tube under different working conditions were simulated and calculated.
降膜式蒸发器是利用制冷剂管外蒸发达到与管内工质换热的目的，即冷媒介质在蒸发管内流动，与蒸发管外流过的制冷剂液体进行换热，使其蒸发，实现热量的传递。
-
Compressor power consumption was greatly affected by inlet air relative humidity and wet-bulb temperature.
结果显示：冷凝温度和冷凝压力均随着入口空气湿球温度的升高而升高；入口空气相对湿度对压缩机功耗的影响与湿球温度对压缩机功耗的影响均比较大；对基于同一压缩系统的实验比较表明，在冷凝温度为38℃时，板式蒸发式冷凝器的热流密度比管式蒸发式冷凝器平均大30.5%；且在相同的冷凝温度下，入口空气湿球温度越低，板式蒸发式冷凝器的热流密度比管式蒸发式冷凝器大得越多。
- 更多网络解释与蒸发管相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Evaporating：蒸发的
evaporating tube 蒸发管 | evaporating 蒸发的 | evaporation at constant temperature 恒温蒸发
-
evasion maneuver：回避操纵
evaporator tube bank 蒸发管排 | evasion maneuver 回避操纵 | evasive steering 回避操舵法
-
indium oxide：氧化铟
研究人员以固态蒸发(solid-vapour)技术制造出此奈米环,他们将氧化锌、氧化铟(indium oxide)与碳酸锂(lithium carbonate)的粉末放置於水平式热炉管中,并在充入氩气的环境下加热至摄氏1400度,这些材料会沉积在矽基板上,
-
momentum transfer：动量传递
热管的研究 在理论上来说,热管内部的作用是一个与热传递,质量传递(Mass transfer)及动量传递(Momentum transfer)等有关的问题. 这些传递情形随著热管在蒸发部份和冷凝部份之间的导热量而改变. 通常情形下,热管的导热量愈大时,
-
evaporative water cooler：汽化水冷器
evaporative film calorimetric enthalpy probe 蒸发膜量热焓探测器 | evaporative water cooler 汽化水冷器 | evaporator coil 蒸发器盘管
-
wick：芯
热管是高性能的热导体,其基本形式为一封闭容器,内装能蒸发的流体,与有毛细作用,称为芯(wick)的材料或结构. 在基本上是等温的过程. 输入端,即蒸发器的热使流体蒸发;蒸气流过容器中央到达输出端,即凝结器;在那里蒸气凝结,
-
atmo：气,蒸汽
atmidoscope 蒸发计,蒸散计 | atmo- 气,蒸汽 | atmocautery 蒸汽烙管,蒸汽烙管
-
inner capillary water：内毛管水
innate 先天的,遗传的 | inner capillary water 内毛管水 | inner evaporation of soil 土壤内蒸发
-
evaporator pressure regulator：蒸发压力调节器
evaporating coil 蒸发盘管 | evaporator pressure regulator 蒸发压力调节器 | evaporator tube bank 蒸发管排
-
steam-heated evaporator：蒸汽架热蒸发汽
水蒸汽管集箱 steam header | 蒸汽架热蒸发汽 steam heated evaporator | 水蒸汽加热器,水蒸汽暖器 steam heater