- 更多网络例句与磁通密度相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Based on the harmonic algorithm, the conductivity reconstruction method and the corresponding algorithm in oblique slice were proposed. Then the numerical simulation was performed by solving the Neumann boundary problem, Ohm's law and Biot-Savart law to obtain the magnetic flux density used to reconstruct the conductivity.
然后通过数值仿真来实现提出的算法，首先进行了正问题求解，即利用Neumann边界值问题、欧姆定律和毕奥－萨伐尔定律逐步计算出重建电导率分布的磁通密度的一个分量，接着进行了逆问题求解，即根据重建算法得到了横截面和斜位面内的相对电导率分布，并对仿真的结果进行了分析和讨论。
-
Based on the Jiles-Atherton model, the dynamic hysteresis loss model of the transformer core considering the classic eddy current loss and abnormal loss is developed, which is suitable for all the reasonable coefficient of reversible magnetization and adopting the flux density as entry variable.
该文在Jiles-Atherton基本磁滞模型的基础上，从能量平衡原理出发，考虑铁心在交流状态下的涡流损耗和异常损耗，建立了合理可逆磁化系数条件下，以磁通密度作为输入量的铁心动态磁滞损耗模型。
-
Using ANSYS magnetic field finite element analysis module,distributions of magnetic line of force and magnetic flux density of the magnetorheological fluid clutch are analyzed.
利用ANSYS磁场有限元分析模块分析了磁流变液离合器的磁力线与磁通密度的分布，同时对离合器外壳材料的选用和外壳形式对磁通密度大小及分布的影响进行了分析，分析结果可为同类产品的设计提供参考。
-
Intensity of magnetic flux ; curie temperature ; magnetic hysteresis loop ; saturation of magnetism
磁通密度；居里温度；磁滞回线；磁性饱和
-
The vector plot of 3D magnetic flux and the surface plot for the radial component of magnetic flux density were obtained,which could show the feature of the MLF near defect expressly.
利用数学模型对漏磁信号进行了仿真分析，得到了三维磁通密度矢量图和它的径向分量曲面图，直观地显示了缺陷附近漏磁场的特点。
-
Our factory's soft ferrite made from good-quality iron oxide has merits of high permeability, high saturation magnetic flux density and low loss, and id widely used in electric and electronic sets of various kinds.
利用本公司优质氧化铁生产的软磁铁氧体，具有高磁导率，高饱和磁通密度和低损耗的优点，它广泛的用于各类电子电器整机中。
-
Based on the developed iron loss of surface-mounted permanent magnet machine of Slemon and Xian Liu, the expressions of the peak and the time rate change of flux density in the teeth and the yoke are derived, considering the beveling edges of the PM. According to the basic concept of the eddy current loss, the analytic calculations of the average eddy current loss density in the teeth and the yoke are presented respectively. Hence, a calculation method for the iron losses of PM with beveling edges is presented.
在Slemon和Xian Liu表面置磁型永磁电机改进铁耗算法的基础上，分别推导了考虑磁体边缘斜角时定子齿与轭的磁通密度的幅值及其时间变化率的表达式，结合涡流损耗的基本概念，分别提出了永磁电机定子齿与轭的平均涡流损耗密度的解析计算方法，由此建立了永磁电机铁耗的解析模型。
-
E. thickness of the copper wire wall, length of the single conductor wire, height of the solenoid, the exciting current and the current density, the working temperature of the conductor, time of exciting and demagnetizing, the cooling water pressure and flux density, etc..
所建立的数学模型包含3个目标函数（即能耗极小化目标函数、铜耗极小化目标函数和纯铁用量极小化目标函数）、7个设计变量（即铜管规格参数a、b、t，线圈匝数N〓、N〓，铁铠磁通密度B〓和冷却水压p）和8类14个约束条件（即铜管壁厚、单饼导线长度、螺线管高度、激磁电流与电流密度、导体工作温度、激退磁时间，冷却水压和铁铠磁通密度等约束条件）。
-
As a result, the equivalent magnetic flux leakage coefficient and the equivalent air-gap magnetic flux density calculating coefficient, which are important for the motor design, are put forwar.
分别对其气隙磁通密度沿周向和轴向的分布进行了分析研究，提出了该种电动机所特有的等效漏磁系数和等效气隙磁通密度计算系数的概念和计算方法。
-
The magnetic intensity of the applied magnetic force on a ferromagnetic material denoted by the term H measured in oersteds; b. The magnetic inducition or flux density as the flux per unit area normal to the direction of the flux ,denoted by B and measured in gauss; c. The magnetic permeability establishes the relation between magnetic induction and magnetizing force expressed as B/H =u; d.Residual magnetism or remanent magnetism which remains in the casting after the magnetizing force has been removed .
磁场强度的应用磁力就一铁磁材料标注由任期h来衡量， oersteds ；乙磁inducition或磁通密度为通量每单位面积正常的方向通量，标注由B和衡量在高斯；长该磁导建立的关系磁感应强度和磁化力表示的B /为H = u ； d.residual磁性或剩余磁性，这仍然是在铸造后，磁化部队已被删除。
- 更多网络解释与磁通密度相关的网络解释 [注：此内容来源于网络，仅供参考]
-
flux density：磁通密度
flux density 磁通量密度 | flux density 磁通密度 | flux density 通密度
-
magnetic flux density：磁通密度
虽然电线圈本身已能够制造磁场,但如果想要提高马达的效率,就一定要使用转子. 转子以具有高磁通密度的金属造成(磁通密度(Magnetic flux density)是描述一件物件能被磁化的程度. 磁通密度越高,便越容易被磁化. )
-
magnetic flux density：磁通
磁场 Magnetic flux | 磁通 Magnetic flux density | 磁通密度 Magnetic force
-
actual flux density：有效磁感应[强度],实际磁通密度;有效通量密度
actual flow of heat-supply network 热网实际流量 | actual flux density 有效磁感应[强度],实际磁通密度;有效通量密度 | actual gap area 磁极下气隙计算面积,实际气隙面积
-
flux linkage：磁通匝连数
flux density 力线密度 | flux linkage 磁通匝连数 | flux of electric force 电力束
-
residual magnetic flux density：残余磁通密度
residual induction 残余感应 | residual magnetic flux density 残余磁通密度 | residual stress 残余应力
-
saturation magnetic flux density：饱和磁通密度
饱和限度 saturation limiting | 饱和磁通密度 saturation magnetic flux density | 饱和磁化 saturation magnetization
-
Magnetic flux density distribution：磁通密度分布
电流密度分布:current density distribution | 磁通密度分布:Magnetic flux density distribution | 分布函数:distribution function
-
magnetic flux linkage：磁链,磁键,磁通匝数
magnetic flux density 磁通量密度 | magnetic flux linkage 磁链,磁键,磁通匝数 | magnetic force 磁力
-
magnetic flux leakage：磁漏
magnetic flux density 磁通密度 | magnetic flux leakage 磁漏 | magnetic flux line 磁通线