- 更多网络例句与漏电相关的网络例句 [注：此内容来源于网络，仅供参考]
-
With the aid of the Laplace transformation, an analytical solution for the motion of the plane standing wave in the presence of free surface charge is obtained. Moreover, the motion of the cylindrical standing wave in the presence of free surface charge is solved using semi-analytical method.
通过变换的方法，求得了平面驻波漏电介质模型解析形式的初值解，并用半解析半数值的方法求解了柱面驻波漏电介质模型的初值解。
-
In order to prevent the damage to people by the creepage of high-voltage batteries on electric vehicle, a solution of creepage protection based on FPGA was provided according to the relevant national standards.
为解决电动汽车车载高电压电源因漏电而导致的对人体伤害事故，根据国家相关安全标准设计出一种基于现场可编程门阵列核心控制器的电源漏电保护装置。
-
A novel method for monitoring the state of transformer windings by identifying parameter of leakage inductance is presented in this paper, using Least Square techniques based on the equivalent equation of transformer leakage inductance. The mathematical model is derived for on-line identification of winding electrical parameter.
以变压器漏电感方程作为绕组参数在线计算的模型，提出了一种利用最小二乘算法进行绕组漏电感参数实时辨识从而实现绕组变形在线监测的方法，推导了用于变压器漏电感参数辨识的方程，针对参数的不可辨识问题提出了解决方案，分析了辨识结果产生误差的原因。
-
Base on the threshold voltage model presented, an intrinsic drain current model in strong inversion region is developed, which can describe the short-channel effects such as DIBL and charge-sharing effect well, and give special considerations for mobility, velocity saturation, channel length modulation and quantum effect. Based on the front interface surface potential model, a formula of unified inversion charge is derived, and an intrinsic drain current model in middle inversion region is developed.
利用所提出的深亚微米FD器件正、背界面表面势模型，建立了一个能够完整描述深亚微米FD器件本征亚阈漏电流特性的模型，能够准确地描述DIBL效应和背沟道漏电效应；利用所提出的阈值电压模型，建立了深亚微米全耗尽器件的本征强反型电流模型，很好地描述包括DIBL效应、电荷分配效应在内的小尺寸效应，对迁移率、速度饱和效应、沟道长度调制效应和量子效应进行了特别的考虑；利用所提出的深亚微米FD器件正界面表面势模型，推导了统一反型层电荷公式，建立了深亚微米FD器件的本征中反型漏电流模型。
-
On the basis of analyzing and researching the reason of the current leakage with the underground D.
本文分析研究了煤矿井下直流架空线电网产生漏电的原因，总结了漏电保护研究的现状，并在此基础上阐述了基于附加直流电源的煤矿井下直流架空线电网漏电保护的原理。
-
A resistor is connected between the output end of the live wire and the output end of the earth wire, another resistor is connected between the output end of the null line and the input end of the earth wire, a neon lamp in a photoelectric coupling switch is connected at the two ends of the earth wire switch in parallel after being connected with the resistors in series, one end of a light sensitive resistor in the photoelectric coupling switch GR2 is connected with the anode DC+ of an integrated circuit IC power in the creepage protector, the other end of the light sensitive resistor is connected with the anode of a diode D3, the cathode of the diode D3 is connected with the triggering pole of the silicon-controlled rectifier SCR in the creepage protector, the neon lamp and the light sensitive resistor are positioned into a dark box, and a small hole which avoids the light sensitive resistor is formed on the dark box.
一种防止地线触点未导通的全能安全插头，包括各带开关的地、零、相三线接线和由零序互感器、脱扣器、放大器、整流器、试验回路和可控硅组成的漏电保护器，所述的火线输出端、地线输出端间连接电阻，所述的零线输出端、地线输入端间串接电阻，光电耦合开关内的氖灯与电阻串联后并联在地线开关两端，光电耦合开关GR2内光敏电阻的一端与漏电保护器内的集成电路IC电源正极DC＋连接、光敏电阻的另一端与二极管D3的正极连接，二极管D3的负极与漏电保护器内的可控硅SCR触发极连接，氖灯和光敏电阻置于暗箱中，暗箱上开一避开光敏电阻的小孔。
-
After being connected with a resistor in series, the primary input end of a transformer is connected with the output end of the live wire and the output end of the null line in parallel, the secondary output end is connected with the two ends of the earth wire switch in parallel after being connected with another resistor in series, one end of a neon lamp in a photoelectric coupler is connected with the input end of the earth wire E and a secondary end of the transformer, the other end of the neon lamp is connected with the centers of the two resistors, one end of a light sensitive resistor in a photoelectric coupling switch is connected with the anode of an integrated circuit power in the creepage protector, the other end of the light sensitive resistor is connected with the anode of a diode, the cathode of the diode is connected with the triggering pole of the silicon-controlled rectifier in the creepage protector, the neon lamp and the light sensitive resistor are positioned into a dark box, and a small hole which avoids the light sensitive resistor is formed on the dark box.
防止地线触点未导通的全能安全插头，包括各带开关的地、零、相三线接线和由零序互感器、脱扣器、放大器、整流器、试验回路和可控硅组成的漏电保护器，变压器初级输入端串联电阻后并接在火线输出端和零线输出端，次级输出端与电阻串联后并联在地线开关两端，光耦内氖灯的一端与地线E输入端和变压器次级的一端连接，氖灯另一端与二电阻的中心连接，光电耦合开关内光敏电阻的一端与漏电保护器内的集成电路电源正极连接、光敏电阻的另一端与二极管的正极连接，二极管的负极与漏电保护器内的可控硅触发极连接，氖灯和光敏电阻置于暗箱中，暗箱上开一避开光敏电阻的小孔。
-
B DC high voltage power supply circuit short circuit, high voltage filter capacitor should check whether the breakdown leakage current, filament transformers for filament winding of whether the earth leakage, tube bracket fixed capacitor (high-frequency coupling capacitor) whether the breakdown leakage, rectifier diodes have breakdown short-circuit phenomenon
b 直流高压供电回路短路，应检查高压滤波电容是否击穿漏电、灯丝变压器的灯丝绕组是否对地漏电、电子管支架固定电容是否击穿漏电、整流二极管是否有击穿短路现象
-
The feed switch is designed with double-controller of single-chip microcomputer and DSP, so as to separate data collection with fault judgment, which improves running speed and intelligence level. And the feed switch has functions of overload protection、open-phase protection、short circuit protection、unbalance protections、leakage locking protection、leakage protection and selective leakage protection.
该馈电开关采用单片机和DSP双控制器设计，实现了数据采集处理和故障判断功能的分离，大大提高了运行速度和智能化水平，还具有过载、缺相保护、短路保护、不平衡保护、漏电闭锁保护、漏电保护和选择性漏电保护功能。
-
It is called Residucd Current Protective dvdice. This thesis expounds the writer's view on the principle of installing the RCD and how to wire the RCD. By combining with the practical use of RCD in engineering design, the writer also analyzes the using value of RCD in engineering in the thesis.
文章阐述了漏电保护装置的安装原则，结合漏电保护在工程设计中的应用，论述了漏电保护装置的接线的确定，分析了漏电保护装置在实际工程中的应用价值。
- 更多网络解释与漏电相关的网络解释 [注：此内容来源于网络，仅供参考]
-
HAVE LEAK ELETRICITY,LIBRATE,HOT AND ALLOPHONE,STOP：发现漏电、振动、高热和有异声时,立即停止
1、确认安全时方可使用;AFTER CONFIRM SAFE BEGIN WORK | 3、发现漏电、振动、高热和有异声时,立即停止;HAVE LEAK ELETRICITY,LIBRATE,HOT AND ALLOPHONE,STOP | 4、使用完毕,立即切断电源;FINISH WORK,CUT OFF
-
Creepage：漏电
creation 产生 | creepage 漏电 | crest 波峰
-
Creepage：漏电;蠕动
cream solder printer 焊浆印刷机 | creepage 漏电;蠕动 | crest 峰
-
creepage distance：表面漏电距离
Creep 蠕变 | creepage distance 表面漏电距离 | criterion 准则
-
Creepage path：爬电(漏电)距离
Crazed 有细微裂纹 | Creepage path 爬电(漏电)距离 | Creepage surface 潜流表面
-
Creepage path：漏电途径
creepage discharge | 沿面放电,潜流放电 | creepage path | 漏电途径 | creepage surface | 潜流表面
-
creepage current：漏电电流,爬电电流
creepage | 蠕变,蠕动,爬电 | creepage current | 漏电电流,爬电电流 | creepage discharge | 沿面放电,潜流放电
-
leakage current：漏电电流
Y电容分为Y1、Y2电容.Y电容愈大,漏电电流(Leakage current)愈大.Class II产品漏电电流限制值为0.25mA,若Y容总值大於3300pF,则会fail. X,Y电容为非必要元件,若产品本身设计、layout OK, EMI也没有问题则可不使用此类元件(设为Optional).一般安规申请时X,
-
Leakage Current and Dielectric Voltage-Withstand Test (Repeated)：漏电电流和绝缘耐电压测试
29 Leakage Current Following Humidity Tests 潮湿状态下漏电电流测... | 30 Leakage Current and Dielectric Voltage-Withstand Test (Repeated) 漏电电流和绝缘耐电压测试 | 31 Resistance to Moisture Test 防潮测...
-
earth leakage circuit breaker (ELCB)：接地漏电断路器;"水线跳掣
earth leakage 对地漏电 | earth leakage circuit-breaker [ELCB] 接地漏电断路器;"水线跳掣" | earth leakage current 对地漏电电流