气流分离

基本解释 (translations)

overclimb  ·  burbling

词组短语

airflow breakaway · air-blast separation · gas separation

与气流分离相关的网络例句 [注：此内容来源于网络，仅供参考]

In one side, the asymmetry of flow beget vortex and the separation of airflow which is the cause of pressure losses.

首先流动的不均匀性，一方面产生涡流和气流分离现象，引起流动阻力的增加；另一方面，造成温度分布的不均匀。

The central angle of the impingement fluid separated from the target surface became larger with the increase of jet Reynolds. And the separating angle also increased with the increasing ratio of the jet distance to the diameter of the jet hole, while the range of induced vortex became smaller.

试验中发现随着冲击雷诺数的增加，冲击气流与壁面分离处对应的圆心角增大，分离推迟；随着相对冲击间距值的增加，气流与壁面分离处对应的圆心角越来越大，相对于受限空间的大小，诱导涡的范围越来越小。

The air vessel works through twice air releases, solving the problem of inconstant air supply in process of cotton opening and blending. Test and application proves that the multifunctional air vessel can solve the problem of block up caused by the uniaxial cotton opener, keeping smooth operation of the production including effective dust removal, clog and iron seperation, avoiding the disadvantage of the former units including the sporadic cutover, simplifying the blow card flow, thus reinforce quality of the card sliver and the resultant yarn.

该设备通过两次释压，解决从抓棉到开棉、混棉间的气流不平衡问题，通过试验和实际使用，指出多功能气流塔能有效解决单轴流的堵车，保证清梳联的稳定运行；在除尘、重物分离和去铁杂等方面也有着较为理想的效果；能解决原各辅机在输棉管路中分散接入的缺点，简化了清梳联流程；能提高生条、成纱的质量。

To deal with the problem that Electrostatic Separation of waste circuit board is high in purity, whereas relatively low in output/capacity,we developed multi-cylinder electrostatic separator and waste circuit winnower which is developed on the principle that the specific gravities of copper powder/grain and plastics are remarkable different..

另外针静电分离对废旧电路覆铜板的分离纯度高而产量比较小，我公司开发的多滚筒静电分离机和根据粉碎后的电路板中铜粉与环氧树脂粉的密度比重差距比较大的原理研制的废旧电路板气流分选机解决了分离产量问题。

This is based on such concept that the flow separation at any point of blade surfaces could be prevented if separation is prevented at most aggravative pressure diffusion section during wakes sweeping.

本文提出了一种引入非定常因素的设计思想，即这样来设计叶型，使尾迹非定常扫掠过程中出现的最严重的扩压过程不发生气流分离。

Compressed Air circumrotate at a high speed in the vortex tube, divided into two different airstreams after vortex in the vortex room, the air in the center of the tube have low temperature, and the air temperature out of the tube higher, adjust the rate of air in cooled and hot, we can get better refrigeration effect and hot effect.

气流在涡流管内高速旋转时，经过涡流变换后分离成总温不相等的两部分气流，处于中心部位的气流温度低，而处于外层部位的气流温度高，调节冷热流比例，可以得到最佳制冷效应或制热效应。

When we think of the glory days of GM, it's the big, fast and magnificently flashy muscle cars of the 50s and 60s that still roar to mind with the burbling sound of mighty V8 engines throbbing in our ears, and tyre-screeching films starring Steve McQueen in our eyes.

当我们回想通用的光辉日子，它那50、60年代的大型，速度和出色的浮华肌肉车仍然咆哮在脑海，气流分离的声音强大的V8引擎震动我们的双耳，并且史蒂夫麦克奎恩主演的轮胎发动机啸声的电影仍在我们的眼中。

Performance was compared with single rotor and fan with support board, and flow analyzed in support passage. The support board was found to have significant impact on the performance of axial-flow fan, and there were complex flow separate and second flow in the support board passage.

对单叶轮风机性能同有支板的风机性能进行比较，以及对风机动叶及支板通道中的流动情况进行了分析，结果表明支板对风机的性能有着较大的影响，支板通道内存在复杂的气流分离漩涡和二次流动等。

A separation in the boundary layer of fluid about a moving streamlined body, such as the wing of an airplane, causing a breakdown in the smooth flow of fluid and resulting in turbulence.

例句1。气流分离移动的流线型的躯体上流体边界层上的分隔物，如飞机的机翼，在平滑的流体流动中会引起故障和湍流

Induced drag occurs when the air flow separates from the surface of a wing, while friction drag is due to the friction between the air and bird moving through the air.

诱导拖动发生时，气流分离，从表面的一翼，而摩擦拖曳是由于摩擦之间的空气和鸟移动通过空气。

与气流分离相关的网络解释 [注：此内容来源于网络，仅供参考]

burble：气流分离

burble 起泡 | burble 气流分离 | burblezone 气流分离区

burble zone：气流分离区

burberry 一种防雨布雨衣 | burble zone 气流分离区 | burble 起泡

stalling point：气流分离点,失速点,极限负荷

stalling of engine 发动机熄火 | stalling point 气流分离点,失速点,极限负荷 | stalling range 失速范围

burbling：气流分离

burbling cavitation 局部空泡 | burbling 气流分离 | burden pressure 上覆压力

burbling：流体起旋 气流分离

burblepoint 泡流分离角 分离点 | burbling 流体起旋 气流分离 | burblingpoint 汽流分离点

burbling：气流分离, 起泡, 附面层分离

burbling zone || 气流分离区 | burbling || 气流分离, 起泡, 附面层分离 | burbot || 淡水鳕

burbling point：失速点,汽流分离点

burbling 气流分离 | burbling point 失速点,汽流分离点 | burbling zone 气流分离区

burbling point：骚动点,气流分离点

bull point 钢钎 | burbling point 骚动点,气流分离点 | cardinal point [方位]基点

burbling zone：气流分离区

burbling point 失速点,汽流分离点 | burbling zone 气流分离区 | burden 负载,载荷,装载量,(仪用互感器)二次负载,炉料

air-blast saw gin：气流式锯齿打桩机

air-blast nozzle ==> 鼓风喷嘴 | air-blast saw gin ==> 气流式锯齿打桩机 | air-blast separation ==> 气流分离