- 更多网络例句与显示元件相关的网络例句 [注：此内容来源于网络，仅供参考]
-
In one phase, one of a first plurality (31) of analogue drive currents can be driven through EL display element.
在一个阶段中，能驱动第一多个模拟驱动电流(31)中的一个流过EL显示元件。
-
Experimental results reveal that remarkably improved device performance and uniformity can be achieved with appropriate fluorine concentration.
实验结果显示元件的电特性和均匀度可藉由掺杂适量的氟原子达到明显的改善。
-
So, studying the technology of LC molecule arranged, is a necessary technique in LCD element formed.
所以，研究液晶分子的排列定向技术，在液晶显示元件构成技术上具有重要意义。
-
AlN MSM devices were fabricated on AlN epitaxial thin film deposited on GaN/Sapphire substrates using helicon sputtering system at the low temperature of 300°C. The device characteristic was found to be improved by in situ metallization of Al electrodes. The extremely low dark current (1.39pA at 20V), the ideal factor (1.0125) and the Schottky barrier height (0.916eV) are superior compared to those of AlN MSM in the literature. When the device was illuminated by the 150W D2 lamp, the ratio of the induced photocurrent to dark current is more than 2 orders of magnitude. The illumination effect also shows the linear relationship between the radiation power and the photo current for the MSM devices, indicating the potential applicability for deep UV sensors.
氮化铝金属-半导体-金属光侦测器则是用In situ metallization制程，利用低温回旋溅镀法在氮化镓/蓝宝石基板上沉积之氮化铝，再直接溅镀金属铝作为指叉电极，比较目前文献制作出来的氮化铝MSM元件，可得到很好的元件金半接面之理想因子1.0125，算出萧特基能障高度为0.916eV，并有很低的暗电流为1.39 pA，提升了元件的特性，使用150 W氘灯入射，光暗电流差距可到两个order，且元件之光电流与入射光功率呈线性，显示所制作之氮化铝MSM元件，很适合针对深紫外光波段侦测。
-
Provided is a liquid crystal sealant composition in which an aqueous solution obtained by admixing the epoxy resin composition with purified water has an ionic conductivity of 1 mS/m or less; the B stage-reduced product has a viscosity of 50 to 10000 Pa.s at 80 to 100 DEG C; the cured matter of the above composition has a linear expansion coefficient of 10x10-5 mm/mm/ DEG C or less and a glass transition temperature Tg of 100 DEG C or higher; and the above cured matter has a moisture permeability of 200 g/m2.24 hours or less at 80 DEG C and which can meet a liquid crystal display element produced by a single layer press hot bonding system and exhibits high adhesion reliability and makes it possible to produce a homogeneous liquid crystal display element having a high quality.
本发明提供一种液晶密封剂组合物，其中：通过将环氧树脂组合物与相同质量的净化水混合得到的水溶液具有离子电导率为1mS/m或更小；在80～100℃下半溶阶段折合产物的粘度为50～10000Pas；上述组合物的固化物具有线膨胀系数为10×10－5mm/mm/℃或更小，热形变温度Tg为100℃或更高；且上述固化物在80℃时具有透湿率为200g/m224小时或更小，这能够满足通过单层热压粘结体系生产的液晶显示元件，并具有高的粘结可靠性，使得有可能生产出具有高质量的均匀液晶显示元件。
-
In this thesis we mainly report the syntheses, crystal structures ,photoluminescence spectra and triboluminescence spectra of new triboluminescentcomplexes.
由于具有摩擦发光特性的物质可以将机械能转变为光能，用这类物质制成的材料，可以制造感压发光体，如制造压力探测传感器及其它科学仪器的显示元件等。
-
The motor is provided with a thermal motor protector (a protective device that is sensitive to both temperature and current) that prevents the temperature of the motor windings from becoming more than 125°(257°) under the maximum load C F under which the motor runs without causing the protector to cycle, and from becoming more than 150°(302° with the rotor of the motor locked; or C F) 4 The motor complies with the requirements for impedance-protected motors; b Under wiring, unless the wiring complies with the VW-1 (Vertical-Specimen) Flame Test in the Reference Standard for Electrical Wires, Cables, and Flexible Cords, UL 1581; c Under an unenclosed switch, transformer, relay, solenoid, and the like, unless it 7 舞台灯标准 can be shown that malfunction of the component does not result in a fire; or d Under field- and factory-made splices and overload and overcurrent protection devices.
F C F 4 发动机符合阻抗保护发动机的要求； b 配线，除非电线符合VW-1及参考UL 1581标准的有关电线，电缆及线芯灵活性的焰火测试。 c 未封装的开关，变呀器，继电器，螺线管及与其相似的，除非它可显示元件的故障不会引起火灾。 d 在户外和生产工厂接合过载和过流保护装置。
-
The display apparatus with the camera includes a display element in which display pixels are arranged, and an image-taking module which forms a plurality of object images through a plurality of aperture areas formed among the display pixels of the display element and photoelectrically converts the plurality of object images.
具有照相机的显示器装置具有：配置了显示像素的显示元件；通过形成在上述显示元件的上述显示像素之间的多个开口区域形成多个物体像，并对该多个物体像进行光电转换的摄像模块。
-
Furthermore, monitoring the changes in Raman spectra of the electrochromic films with bleach-coloration states enables the discussion of the mechanism of colouration.
此外，本专题制作的影像显示元件，其操作电压范围在-4V至+4V间，可透过调整驱动电压大小来改变颜色的深浅，提高元件的视觉对比。
-
A 130mm flat-faced cathode-ray tube is used to display the discharges which...
用130mm的平面阴极射线管作为放电脉冲信号的显示元件，放电信号叠加在椭圆时基上，观察方便。
- 更多网络解释与显示元件相关的网络解释 [注：此内容来源于网络，仅供参考]
-
advertising means incorporating display members：与显示元件一体的广告方式
advertising means incorporating advertising meanss 广告手段、结合广告手段 | advertising means incorporating display members 与显示元件一体的广告方式 | advertising on articles 在物品上打广告
-
display element：显示元件
display device,显示器;显示设备 | display element,显示元件 | display unit,显示单元
-
display element：显示元件=>表示要素
display drum 显示磁鼓 | display element 显示元件=>表示要素 | display glass 显示屏
-
pneumatic display element：气动显示元件
pneumatic differential pressure transducer 气动压差变送器 | pneumatic display element 气动显示元件 | pneumatic display instrument 气动显示仪表
-
DE Display Element：显示元件
DE Discard Eligibility 弃之合宜,丢弃符合规定 | DE Display Element 显示元件 | DE Display Equipment 显示设备,显示器
-
parts：元件
PADS Logic 有两类栅格(Grid):设计栅格(Design Grid)和显示栅格(Display设计栅格(Design Grid)指的是光标每移过一小格的距离,确定增加元件(Parts)和连线(Connections)的间隔和转角的位置.
-
component positioning：元件安置
队列支撑数据库:queue support database | 元件安置:component positioning | 图形显示:graphics dispaly
-
sensing element：感应元件
记录,显示,控制的要求.通常感测器由感应元件和转换元件组成.其中感应元件(sensing element)是指能直接感测被测物.转换元件(transduction element)是指感测器中能将感应元件之输出量转换为适於传输和测量的电讯号之元件.以血糖计为例,
-
detecting element：探测元件检波元件
detecting cabinet 烟气探测器显示柜 | detecting element 探测元件检波元件 | detecting instrument 检测仪器
-
Esters：自动化元件
ERMA 显示仪表, 信号转换器 | ESTERS 自动化元件 | EXOR 自动化元件