感应电的

基本解释 (translations)

faradic  ·  Far.

与感应电的相关的网络例句 [注：此内容来源于网络，仅供参考]

Another research topic is evaluated lightning induced voltages on nearby overhead-lines. Lightning is a transient, high-current discharge whose path length is measured in kilometers. During flash, neighbor electromagnetic field change violently, that would induce voltages on close-by metal.

另一研究课题为，非直击雷害造成邻近区域内架空线上的感应电压的探讨，雷击闪络可视为长距离的放电暂态现象，过程中会使得雷击周遭的电、磁场剧烈变动，将会在邻近的金属物件上感应出电压造成二次的伤害。

The fluorspar corresponds the sixth turn of - glabella wheel, theposition between two eyebrows third region, the corresponding colorfor not anxiously not Xu's purple blue color (red with blue colorunion, plays water color people all to know, but red representativewarm), third is the spiritual strength and the higher intuitioncenter, by way of a glabella turn of strength, can receive theguidance, and then the conduction sense knows to is higher oneself,lets the person experience the heart 电感应, patrols the universeand to the previous generation cognition.

萤石对应第六轮－眉心轮，位置於两眉之间的第三眼地带，对应色彩为不急不徐的紫蓝色(红色与蓝色的结合，玩过水彩的人都知道，而红色代表温暖)，第三眼是精神力量和更高直觉的中心，经由眉心轮的力量，能接收引导，并进而传导觉知至更高的自我，让人体验心电感应，神游太虚及对前世的认知。

By means of Furrier decomposition the harmonic components in various orders are obtained, and then the induced electromotive force in stator winding is obtained when the air gap eccentricity of turbo-generator is taken into consideration.

通过傅里叶分解得到了各次谐波分量，在考虑气隙偏心的情况下得到了定子感应电势，理论推导证明偏心对定子绕组感应电动势并不产生影响。

The furnace body is made ф2200×1500 the outer covering main body by the 12mm steel plate, lower part the furnace body 45° the installment has the sensor, the sensor orientation silicon steel plate is made the weight 2 ton induction iron cores by Wuhan Steel Corporation Silicon steel plate Factory production top gear's W-151 the cold rolling 0.35m/m, primary is made the water cooling coil by 10×10×2 the copper pipe, and installs the stainless steel water cooling restricting, the power frequency has the core smelting furnace's metal melt fluid namely for the sensor sencondary coil, the entire electric stove is a transformer actually, the necessary 6 grades from the pair regulating transformer, shift gears by the electricity cabinet control, the voltage may from low to high, divide 6 promotions to arrive at 380V, each grade of voltages are different, the output is also different, the furnace temperature along with the files position is also different, but the height is different, adapts smelts colored or the black and so on melting point different metals, and may make the new furnace lining to smelt diamantine drying furnace fireproof.

炉体由12mm钢板制成Ф2200×1500外壳主体，炉体下部45°安装有感应器，感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心，初级由10×10×2铜管制成水冷线圈，并安装不锈钢水冷保护套，工频有芯熔炼炉的金属熔液即为感应器的次级线圈，整个电炉实际就是一个变压器，配套一台6档的自耦调压变压器，由电柜控制换档，电压可由低到高，分6级升到380V，每档电压不同，输出功率也不同，炉温也随档位不同而高低不同，以适应熔炼有色或黑色等熔点不同的金属，并可作新炉衬耐火冶金砂烘炉之用。

The furnace body is made ф2200×1500 theouter covering main body by the 12mm steel plate, lower part the furnace body 45° the installment has the sensor, the sensor orientation silicon steel plate is made the weight 2 ton induction iron cores by Wuhan Steel Corporation Silicon steel plate Factory production top gear's W-151 the cold rolling0.35m/m, primary is made the water cooling coil by 10×10×2 the copper pipe, and installs the stainless steel water cooling restricting, the power frequency has the core smelting furnace's metal melt fluid namely for the sensor sencondary coil, the entire electric stove is a transformer actually, thenecessary 6 grades from the pair regulating transformer, shift gears by the electricity cabinet control, the voltage may from low to high, divide 6 promotions to arrive at 380V, each grade of voltages are different, the output is also different, the furnace temperature along with the files position isalso different, but the height is different, adapts smelts colored or the black and so on melting point different metals, and may make the new furnace lining to smelt diamantine drying furnace fireproof.

炉体由12mm钢板制成Ф2200×1500外壳主体，炉体下部45°安装有感应器，感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心，初级由10×10×2铜管制成水冷线圈，并安装不锈钢水冷保护套，工频有芯熔炼炉的金属熔液即为感应器的次级线圈，整个电炉实际就是一个变压器，配套一台6档的自耦调压变压器，由电柜控制换档，电压可由低到高，分6级升到380V，每档电压不同，输出功率也不同，炉温也随档位不同而高低不同，以适应熔炼有色或黑色等熔点不同的金属，并可作新炉衬耐火冶金砂烘炉之用。

So, it is very difficult to monitor and protect the rotating rectifier. This paper theoretically analyses the armature current and magnetomotive force in AC exciter of brushless synchronous machine with rotating rectifier. Under the normal or fault conditions of rotating rectifier, the mathematical expressions of the armature current, the m.m.f and induced electromotive force are approached.

本文通过对旋转整流器在正常与故障状态下的交流励磁机电枢电流和电枢电势作了初步的理论分析，推导出旋转整流器在正常与故障状态下电枢电流、空间谐波合成磁势及其感应电势的数学表达式。

This paper presents MMF of a five-phase induction motor with concentrated and full-pitch windings by means of fourier analysis and winding function , which indicates theoretically that the five-phase induction motor with concentrated and full-pitch windings can provide more electromagnetic torque and higher torque density than others.

本文运用傅里叶分析和绕组函数的方法，推导了集中整距绕组五相感应电动机的磁动势，得出集中整距绕组五相感应电机能更好地增加电机的电磁转矩、提高转矩密度。

The furnace body's ф2200×1500 outer covering main body is made of 12mm steel plate,installed sensor in the lower part 45°of furnace body, the sensor is weight 2 ton induction iron cores made from top gear's W-151 the cold rolling 0.35m/m made by Wuhan Steel Silicon steel plate Factory, primary manufactured the water cooling coil from 10×10×2 copper pipe, and installed stainless steelwater cooling cover, the power Frequency Induction melting Furnace 's metal melting fluid namely the sensor sencondary loop, the entire electric furnace is a transformer actually, match a 6 grades self regulating transformer, shift gears by the electric tank control, the voltage may from low to high,divide 6 grade to rise to 380V, each grade of voltage is different, the output power is also different, the furnace temperature is also different along with different grade,so can suit smelting colored or black and so on different melting point metals, and may use as new furnace lining fireproof to smeltdiamantine drying furnace.

炉体由12mm钢板制成Ф2200×1500外壳主体，炉体下部45°安装有感应器，感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心，初级由10×10×2铜管制成水冷线圈，并安装不锈钢水冷保护套，工频有芯熔炼炉的金属熔液即为感应器的次级线圈，整个电炉实际就是一个变压器，配套一台6档的自耦调压变压器，由电柜控制换档，电压可由低到高，分6级升到380V，每档电压不同，输出功率也不同，炉温也随档位不同而高低不同，以适应熔炼有色或黑色等熔点不同的金属，并可作新炉衬耐火冶金砂烘炉之用。

The authors give the definition of insertion loss of electric locomotive in inductive communication through trolley wire in a mine tunnel and compute insertion loss and transmission loss. After contrasting the two losses, we know that the insertion loss is very large and it is necessary to use dedicated induction line.

给出了在矿井中利用电机车架空线进行感应通信时，架空线负载引起的插入损耗的定义，计算了插入损耗和无负载时的电磁波传输损耗并对比了这两种损耗，可知插入损耗是非常大的，这说明了使用专用感应线的必要性。

However, the problem depends on majority electromotor is not very effective, resemble induction motor, universal motor and wasteful electromotor instrument drive in that way efficiency is low.

然而，问题在于绝大部门电念头都不长短常有效，就像感应电念头、交直流两用电念头和不经济的电念头械驱动器那样效率低下。

与感应电的相关的网络解释 [注：此内容来源于网络，仅供参考]

faradic：感应电的

Faraday 法拉第 | faradic 感应电的 | faradism 感应电

faradic：感应电的/感应电流的

farad /法拉/ | faradic /感应电的/感应电流的/ | faradimeter /感应电流计/

faradic：感应电的; 感应电流的 (形)

faraday 法拉第 (名) | faradic 感应电的; 感应电流的 (形) | faradism 感应电; 感应电治疗 (名)

faradism：感应电

faradic 感应电的 | faradism 感应电 | faradization 感应电流疗法

faradism：感应电; 感应电治疗 (名)

faradic 感应电的; 感应电流的 (形) | faradism 感应电; 感应电治疗 (名) | faradization 感应电流疗法 (名)

faradization：感应电疗法

第二节 感应电疗法 (faradization) 一、概述 感应电流又称法拉第(faraday)电流,应用这种电流治疗疾病的方法,称为感应电疗法. 这种电流是1831年由法拉第发现,是一种古老的电流疗法. 二、物理特性 感应电流是用电磁应原理产生的一种双相、不对称的低频脉冲电流,

galvanocautery：医用电烙器/电烙术

galvanizing /镀锌/ | galvanocautery /医用电烙器/电烙术/ | galvanofaradic /流电感应电的/

endofaradism：内部感应电疗法

endoergic 收能的 | endofaradism 内部感应电疗法 | endofaxleoutsideofhub 轵

faradocontractility：感应电收缩性

faradism 感应电 | faradocontractility 感应电收缩性 | farcical 滑稽的

galvanofaradization：流电感应电疗法

galvanofaradic 流电感应电的 | galvanofaradization 流电感应电疗法 | galvanograph 电镀版