- 更多网络例句与并联电路相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The dual-band differential LNA use Inductive source degeneration structure, a matching network is used for the LNA to develop dual-band. The micro-mixer use a matching network shunt and parallel LC elements to develop wide-band matching. The biasing method reduces the"voltage headroom" difficulties inherent to the Gilbert cell, and the mixer linearity can be improved using this biasing method "Charge -Injection"by accurate adjustment of the input MOSFET operating point. The complementary VCO based on 2.5GHz, and tuning output buffer to approach 2GHz/5GHz dual-band for dual-band down-converter with MMIC technology.
其中双频差动低杂讯放大器，本电路用Inductive Source Degeneration 架构，在匹配网上设计，使低杂讯放大器工作在个频带上达成双频带的效果；CMOS 微混频器上采用LC串联、并联电路做匹配，达到宽频匹配的效果，并加入了"Charge-Injection"的方法来改善"voltage headroom"的问题，并同时提高线性度的表现；互补式压控振荡器以2.5GHz为基频的振荡器为出发点，透过电路的调整，以期达成2.5/5GHz的双频带需求，能够完整达成双频带接收机系统。
-
On the basis of the above results of detecting methods, the instruction signal calculating circuit is designed according to i〓, i〓 calculating mode. Compensation current generating circuit is also designed and implemented. Its current following circuit is designed according to the instantaneous value comparing mode that used constant time control. The source current detection based control mode and composite control mode and their implementation are firstly introduced in our country. The method and the principle of dc side capacitor voltage control are explained clearly.
根据检测方法的研究成果，采用i〓、i〓运算方式构成并联型电力有源滤波器的指令电流运算电路；对补偿电流发生电路进行了电路设计和实施，其中电流跟踪控制电路采用电流跟随性能好、可靠性高的定时控制瞬时值比较方式；在国内首次研究并实施检测电源电流控制方式和复合控制方式；清楚地阐明了并联型电力有源滤波器直流侧电压控制的原理和方法，并在装置中实施。
-
State that ,for a parallel circuit, the current from the source is larger than the current in each branch
能够说明并联电路里的总电流是大于任一分电路电流的。
-
The elements in the parallel circuit with the lowest resistance will supply more heat energy and therefore operate at a higher temperature.
要使并联电路中的电阻阻值达到最小值应供应更多的热能，这样可以使操作温度更高。
-
Firstly, this paper analyzes and summarizes the research situation of resonant soft-switching technique and main topologies. And it indicates the main advantages and disadvantages. Then it pays more attention to analyze the parallel resonant DC link circuit theory and operating modes. It also analyzes how the resonant circuit realizes the resonant process. This paper also simplifies the control part design of the parallel resonant DC link soft-switching inverter by DSP.
本文首先对谐振软开关技术的研究现状和各种主要的拓扑结构进行了分析、综合、总结，指出了各自的优缺点；着重对并联谐振直流环电路的工作原理、电路工作模式、软开关实现机理及谐振参数的确定等进行了深入详尽的分析；利用DSP的灵活调节特点，有效地简化了并联谐振直流环软开关逆变系统的控制环节设计。
-
In this paper,a new method of measuring the resonant frequency of the RLC parallel resonance circuit was intro- duced,which makes the asymmetric amplitude-frequency curve symmetric.
介绍了用Origin变换坐标，将不对称的RLC并联电路的幅频特性曲线对称变换，从而精确求解其共振频率的方法。
-
By the research of the RLC series circuit, RLC Parallel circuit, and the starat of Fourier Series, get the further understanding and grasp the characteristics of the resonant of RLC circuit. Even more, on the basis of the RLC series resonance, the other circuit structures selected frequency wave frequency analysis of the election.
本实验通过对RLC串联电路、并联电路及方波的傅立叶级数展开的实验现象的测量及研究，进一步了解和掌握RLC谐振电路的特点，并在RLC串联谐振的基础上，搭建选频电路对方波进行选频分析。
-
Secondly,two regulatable current sources for exicitation of magenetic powder dynamic brake are studied respectively with buck and interleaving two-transistor forward topology. In the power supply with interleaving two-transistor forward topology design,simulations are implemented with Saber simulator,thus the best parameters are achieved which ensured the stability and dynamic characteristic.
二、分别用 BUCK 式和交错并联的双管正激式电路拓扑，研制了磁粉制动器的直流励磁电流源，其中对于交错并联双管正激式的电路进行了基于 Saber 的仿真，确保了电路参数的选取能够保证电路稳定性与动态性能要求。
-
This paper then compares three kinds of power conversion circuit applied in it and advances a main circuit which is based on IGBT's power grade nowadays and is applied in high power direct-driven grid-connected wind turbine. It is made up of a six-phase rectifier, two paralleled BOOST chopper circuits and two paralleled SPWM inverters.
文章在比较此种风力发电机的三种类型变流电路拓扑结构的基础上，提出了一种在考虑现有开关器件功率水平的情况下符合大功率直驱并网型风力发电机要求的变流电路拓扑结构，即采用&六相不控整流+两个并联的升压斩波+两个并联的三相SPWM逆变&的电路结构，并对其各部分电路的工作原理进行了分析。
-
If the oxygen sensor heater circuit is wired directly to the control unit, an A/D converter with a basic shunt circuit is used to directly check the current of the circuit Fig.
如果氧传感器加热电路直接连接到控制器，具有一个基本的并联电路的 A/D 转换器可用于直接检查当前的电路(图 6)。
- 更多网络解释与并联电路相关的网络解释 [注：此内容来源于网络，仅供参考]
-
parallel connection：并联
1.定义:把电路元件逐个顺次连接起来的电路叫串联(serizes connection)电路.1.定义:把电路元件并列连接起来的电路叫并联(parallel connection)电路.
-
in parallel with：和...并联
Emitter follower 射极跟随器 | In parallel with 和...并联 | Parallel circuit 并联电路
-
parallel oscillatory circuit：并联振荡电路
parallel oscillation 并联振荡 | parallel oscillatory circuit 并联振荡电路 | parallel padding 并联统调
-
parallel circuit：并联电路
总电压的瞬时值应等于各元件上电压瞬时值之和,即在并联电路(parallel circuit)中,加在各支路上的电压瞬时值是相同的,可用一个共同的复电压 来代表. 总电流的瞬时值应等于各支路上电流瞬时值之和,即上式表示,复阻抗的实部与有功功率(real power)相对应,
-
mechanical parallel circuit：机械并联电路
aftergrass [农]割后再生的草 | mechanical parallel circuit 机械并联电路 | shop condition 车间生产条件
-
simple parallel circuit：单并联电路
simple pan balance 单盘天平 | simple parallel circuit 单并联电路 | simple path 简单路径,简单通路
-
parallel resonance impedance：并联谐振阻抗
parallel resonance frequency 并联共振频率,并联谐振频率 | parallel resonance impedance 并联谐振阻抗 | parallel resonant circuit 并联共振电路,并联谐振电路
-
simple RLC series circuit：简单的RLC串联电路
simple RLC parallel circuit 简单的RLC并联电路 | simple RLC series circuit 简单的RLC串联电路 | simple rolling process 简易轧制过程
-
simple RLC parallel circuit：简单的RLC并联电路
simple ring 简单环形构造,单环 | simple RLC parallel circuit 简单的RLC并联电路 | simple RLC series circuit 简单的RLC串联电路
-
shunt circuit：分路,分流电路,并联电路
shunt characteristic ==> 并励特性 | shunt circuit ==> 分路,分流电路,并联电路 | shunt coil ==> 分流线圈