- 更多网络例句与填料箱相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Stuffing box is integral with agitator housing for positive alignment of shaft.
依据混合器轴的实际安装情况，一个完整的填料箱。
-
Bull; Stuffing box is integral with agitator base for positive alignment of shaft.
依据混合器轴的实际安装情况，设计一个完整的填料箱。
-
With a charge drill to connect φ3-φ4mm long drill bit through the G-clamp drill to drill Ball Valves into the stuffing box stuffing inside.
用充电钻接上φ3-φ4mm的长钻头，通过G型夹具向填料箱钻孔至钻入填料函内。
-
The backside of impeller:due to special design of backside impeller,the pressure on the stuffing box is minimum.
叶轮背部：由于叶轮背面的特殊设计，将填料箱上的残余压力减到最小。
-
Check the stuffing box, the packing gland should be flatted and the tensioning torque should be proper.
检查滑油箱的油位。4。检查填料箱，填料压盖应放平，压紧力要适当。
-
Valve shaft uses thrust bearings and "O" shaped seal ring to reduce friction, and stuffing box's leakage problem is also solved.
阀杆采用止推轴承和"O"型圈密封，减少了开关时的摩擦力，解决了填料箱漏水问题。
-
STUFF BOX DRAIN TK LEVEL HIGH.
填料箱泄放柜液位高
-
Valve shaft uses thrust bearings and "O" shaped seal ring to reduce friction, and stuffing box's leakage problem is also solved.
阀杆采用止推轴承和&O&型圈密封，减少了开关时的摩擦力，解决了填料箱漏水问题。
-
Case cover:wear plate is integral with the stuffing box cover and easily renewable,ensuring low operating costs.
泵盖：后耐磨板与填料箱为一体，便于更换，生产费用低廉。
-
Spiral mandrel injection, injection valve, or two connected with the screw hole injection into the fixture, make it the top tight valve stuffing box.
用注射螺旋顶杆、注射阀或两个接在一起拧入夹具注射孔上，令其顶紧阀门填料箱。
- 更多网络解释与填料箱相关的网络解释 [注：此内容来源于网络，仅供参考]
-
gland：填料压盖
填料箱 Stuffing box | 填料压盖 Gland | 通气阀 breather valve
-
recommission：重新委任 把(已退伍的人员、军舰等) 再编入服役
Silence is gold 沉默是金 | recommission 重新委任 把(已退伍的人员、军舰等) 再编入服役 | gland box 填料箱, 填料函
-
Stuffing box：填料箱
四、开口阀之下游端应装设栓盖 (Cap)、盲法兰 (Blind Flange) 、栓塞(Plug) 或二次阀(Second Valve) 以封止其开口端. 但实际操作中制程流体需自开口阀排出者,不在此限. 1.止漏流体之操作压力恒大于轴封填料箱 (Stuffing Box) 压力.
-
stuffing box gland：填料函压盖
金属填料 metallic stuffing | 填料箱,填料函 packing box, stuffing box | 填料函压盖 stuffing box gland
-
stuffing box cover：填料函压盖 填料箱压盖
quatrimycin 差向四环素, 四-霉素 | stuffing box cover 填料函压盖 填料箱压盖 | selective plating (微生物)选择性平皿培养(法) [冶]选择镀
-
metallic stuffing：金属填料
浸聚四氟乙烯的石棉填料 Teflon impregnated asbestos packing | 金属填料 metallic stuffing | 填料箱,填料函 packing box, stuffing box
-
stuffy room：闷热室
stuffing box 填料箱 ,填料座 | stuffy room 闷热室 | stump 树桩
-
box-type scrapers：箱形括矿机
"box; stuffing","盘根盆 ; 填料函 ; 填料箱" | "box-type scrapers","箱形括矿机" | "Boyle's law","波以耳定律"
-
box sluice：箱式溜洗槽
"box mud","泥浆箱 ; 泥箱" | "box sluice","箱式溜洗槽" | "box; stuffing","盘根盆 ; 填料函 ; 填料箱"
-
Scraper ring for Stuffing box：填料箱刮油环
34.填料箱压缩环 Pressure ring for Stuffing box | 35.填料箱刮油环Scraper ring for Stuffing box | 36.扫气箱 Scavenging receiver