可混和性

基本解释 (translations)

miscibility

与可混和性相关的网络例句 [注：此内容来源于网络，仅供参考]

The high barrier effects are obtained by controlled blending technique conditions and morphology of dispersed phase.

将少量对烃类溶剂具有高效阻隔作用的阻隔性树脂――改性尼龙与高密度聚乙烯共混，通过对共混工艺条件和分散相MPA形态的控制，可获得具有高阻隔性能的HDPE／MPA共混材料。

Supporting type is suggested to be developed into 3-prop to improve adaptability besides 2-prop and 4-prop. The difference of caving difficulty degree of coal seam is the base of caving coal method at high, medium and low position. Caving with small step and open caving flashboard used widely not only cause serious mixture of coal and rock but also hinder the improvement of top coal recovery. So we suggest caving with large step or closing caving door. Four-bar-mechanism of hydraulic support restricts development of new style caving powered support. Stabilization framework of expansion link and all-shield caving tail beam at high, medium and low position are introduced here.

支架支护型式，除了两柱、四柱以外，建议开发三柱支架以改善适应性；煤层冒放性的差异，是高位、中位和低位放煤方法存在和使用的依据；目前广泛采用的小步距放煤和开放式放煤插板不仅造成严重混矸漏矸，也妨碍顶煤回收率的进一步提高，建议采用大步距放煤和可关闭放煤口；液压支架四连杆稳定机构，制约了新型放顶煤液压支架的开发，介绍了液压支架伸缩杆稳定机构及全掩护拖移高位、中位和低位放煤尾梁。

The polycarbonate blend may be used with amine and hydrazone charge transport materials and the charge transport layer may include additional additives which further improve the wear properties of the photoconductor coatings in a laser printer.

该聚碳酸酯共混物可与胺和腙电荷迁移材料一起使用，该电荷迁移层包括可进一步改进激光打印机中光电导体涂层的耐磨性的附加添加剂。

The results show that AREEC liquid crystal enables the flow behavior of PC to change from quasi-Newtonian type to pseudo-plastic type, and it can act as heterogeneous nuclei to accelerate greatly crystallization of PET, and then to improve evidently their injection moldability.

将AREEC液晶与PC、PET熔体共混，研究了共混体系的流变行为、结晶特性和可模塑性，证明AREEC液晶能使PC流变行为由准牛顿型变为假塑性幂律型，能对PET起异相成核和显著加速结晶作用，从而大大改善它们的注塑可塑模性。

In chapter 4, the Newlands harmonic wavelet is improved and a new type of wavelet with better time-frequency characteristic is constructed. Frequency band of signal can be divided arbitrary with the improved harmonic wavelet so that the phenomena of aliasing are reduced. Several typical fault signals in Electromechanical System are analyzed with it. In addition to the improved harmonic wavelet in chapter 4, a new half-complex wavelet is presented to improve the complex wavelet, which is given by Chaari.O. A unilateral recursive algorithm is derived to improve the real-time characteristic. A parameter n is imported to make the time-frequency and filtering characteristics of it better and its ability of extracting fault feature is enhanced.

第四章通过对Newland谐波小波的改进构造频域紧支撑、时域性能良好的新型小波函数，可实现信号频带的任意划分，从而减少频带混叠现象，采用改进的谐波小波对多种典型的机电系统故障信号进行了分析；以Chaari.O复小波为基础构造了一个半复小波，从提高复小波算法的实时性出发，推导了半复小波单向递推算法，通过给原小波设置可调参数的方法，实现了一种能满足小波基本条件的复值小波，可以通过参数的调整调节小波滤波器在Hilbert空间的时频特性和相应的滤波性能，以加强半复小波对故障特征的提取能力。

The measurement system error model analysis is introduced into power system real time network state analysis as an important part for the first time, which can improve on the state estimation quality and provide the capability to monitor the operation of the measurement system; 2. The theory and algorithm of the on-line estimation and update of measurement noise variance based on the relation between the residual variance and noise variance. The statistic properties of the sample variance are discussed and the relation between the estimation precision and sample size under given confidence level is derived; 3. The theory and algorithm of detection and identification of measurement bias are presented, which is based on the relation between residual mean and noise mean. The statistic properties of sample mean are discussed and the relation between estimation precision and sample size is derived; 4. The Givens orthogonal transformation algorithm is selected to be the essential algorithm of state estimation, the fast orthogonal transformation algorithm with damp factor and the algorithm which can handle the zero injection measurements efficiently are presented; 5. The quantity analysis theory of bad data detectivity and identifibility are presented, which describes the relation between the elements in matrix W〓 and bad data amplitude and can provide the theory base for measurement system design and valuation.

一、首次将量测系统误差模型分析做为一个环节引入电力系统实时网络状态分析中，为EMS系统增加了实时监视系统运行、修正量测系统误差模型的新功能，进一步发挥了实时网络状态分析应用软件的潜力；二、首次提出了应用样本方差在线估计与修正量测系统误差方差的基本理论，讨论了样本方差的统计性质和概率分布，推导出了样本容量、估计精度和置信度之间的关系，给出了在线估计与修正量测系统误差方差的算法；三、首次提出了应用样本均值在线检测与辨识量测偏差的基本理论，讨论了样本均值的统计性质，推导了样本容量、估计精度和置信度之间的基本关系，给出了在线检测与辨识量测偏差的算法；四、在状态估计算法设计中，以Givens变换算法做为基本算法，提出了快速正交变换阻尼因子法和可以有效地处理零注入量测的混合法，并对实时应用中的一些问题进行了讨论；五、提出了不良数据可检测性与可辨识性的定量分析理论，揭示了描述量测系统配置、网络结构与参数的残差灵敏度矩阵中的元素与不良数据的幅值在可检测、可辨识能力上的定量关系，为量测系统配置设计与评价提供了理论基础；六、综合国内外最新研究成果，采用自适应自回归预测技术和稀疏矢量技术，构造了较完善的不良数据检测与辨识算法。

, 80g/l HPZ-Ti solution can be stored stably for more than one year at atmospheric temperature (the highest temp. is 35℃), the precipitation point pH of 0.05M HPZ-Ti solution exceeds 4. 6, the stability can meet the tannage need. The tanning power of HPZ-Ti tanning liquor is better than that of any other titaninum tanning liquors which have been researched.

与钛配位能力适中，在革内有较好的渗透性，HPZ—Ti配合物与胶原有较大的反应活性，HPZ与Ti以0.45mol HPZ/mol Ti比例混和，浓度为80g/l时，在室温下（最高温度35℃）可稳定存放一年以上，浑浊点pH值达4.60以上，其鞣性优于其它配体蒙囿的钛溶液和其它方法制备的钛鞣剂。

The specific properties of materials, such as the palate adhesion, dynamic cruor, anti-bacterial and the degradability of lysozyme, were studied, which provide valuable data for further application. The main creative ideas are listed as follows:(1) The water-retention chitosan/poly vinyl alcohol blend fiber was obtained by coagulating in 10％ NaOH/ethanol solution, and the blend and crosslink due to GA can enhance the mechanical properties of fiber;(2) The controlled degradable chitosan/gelatin blend fiber was obtained by solution filature, and the mechanical properties were improved;(3) The N-acylchitosan with the different degree of substitution were successfully prepared, and the relationship between structure and properties was estabilished;(4) By a new solvent system of 6％ NaOH/4％ urea for cellulose, the blood anti-coagulant function films were prepared by blending cellulose with chitin;(5) In the same solvent system above mentioned, the anti-bacterial blend films based on cellulose and carboxymethyl-chitosan were prepared, and the relationship of DS and the anti-bacterial property was concluded;(6) The controlled degradable chitosan films was obtained by the chemical crosslink.

本论文的主要创新点：（1）以NaOH水溶液／无水乙醇为凝固液，采用溶液纺丝法制备出保水性壳聚糖／聚乙烯醇纤维，共混和戊二醛交联极大提高了壳聚糖纤维力学性能；（2）用壳聚糖和明胶共混，以溶液纺丝法制备出可控降解的壳聚糖／明胶纤维，并大幅度提高了壳聚糖共混纤维的干、湿态抗张强度；（3）确立了不同取代度N-酰基壳聚糖的合成方法及其膜的结构与性能的关系；（4）利用纤维素新溶剂6％NaOH／4％尿素制备出抗凝血性纤维素／甲壳素共混膜；（5）利用上述纤维素新溶剂制备出抗菌性纤维素／羧甲基壳聚糖共混膜，揭示了羧甲基壳聚糖取代度与抗菌性能的关系；（6）制备出可控降解壳聚糖交联膜。

In this article are introduced three raw materials in spinning wool on cotton spinning frame, analyzed the spinnable count、length limit and spinnability of thus spun wool yam as well as the spinning technology and described the main product and its properties of thus spun wool yarn on cotton spinning frame. The draft technology of the top is also discussed.

文中介绍了羊毛棉纺工艺常用的细羊毛、毛条和细化毛三种原料；分析了羊毛纺纱的可纺支数、长度限制及可纺性；分工艺研讨了羊毛在棉纺设备上的纺纱工艺，并对毛条牵切拉断工艺的特点和滑溜牵伸的应用作相应的讨论；叙述了当前棉纺设备上纺制的羊毛混纺纱主要产品及其特点。

For the same quantity of module, using well transparent and well-proportional faceplate can acquire high luminous intensity.

在模组数量相同条件下，使用透光性和混色性好的面板可在其表面上获得较高的光照度。

与可混和性相关的网络解释 [注：此内容来源于网络，仅供参考]

plaster：硬膏

9.硬膏(plaster) 药物溶于或混和于粘着性基质中并涂布于裱被材料如布纸上而成. 硬膏粘贴于皮肤表面后,可组阻止水分蒸发,使角质层软化,有利于药物渗透吸收,且作用深入持久. 适用于慢性局限性浸润肥厚性皮肤病,而急性皮炎禁用.

mischoose：误择

mischievously 有害地 | mischoose 误择 | miscibility 可混和性