- 更多网络例句与双低方程相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.
结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。
-
With the support of a major research grant of Zhejiang Province (No. 001101027) and the Plan of Promoting Education of Excellence of Zhejiang University in the 21st Century, this dissertation is devoted to address the above problems and fabricate an L-band EDFA with low cost, high performance and technological innovation.First the mechanism of an erbium doped fiber amplifier is introduced. Various theoretical models based on classical rate propagation equations are summarized and compared for their applications. We use a modified numerical model based on the Giles model, which agrees with the experimental results well. This serves as the theoretical base for the whole thesis and will be used to optimize the characteristics of EDFAs. A novel method based on a map of noise figure and gain is proposed to analyze efficiently the dependence of the noise figure and gain for EDFAs on the EDF length and the pump power. The characteristics of various EDFAs are studied and compared.Secondly, some important parameters are introduced to describe the characteristics of EDFAs. The methods and the experimental setups for measuring the gain and noise figure of an EDFA are emphasized. We introduce how to measure the characteristics of each component of an EDFA, especially the gain and absorption coefficient of an erbium doped fiber.Thirdly, four types of simple and novel L-band EDFA structures with low noise, high gain and low gain ripple are proposed to satisfy the requirement of a DWDM system. They can be classified into two categories. In the first category, a single ASE pumping is served asa secondary pump. This category includes the following three types. Type: a new construction using a fiber Bragg grating in an unpumped EDF section at the input side. Type: a new structure of L-Band EDFA with two-stage pumps, which utilizes the forward ASE as a second pump.
本论文本着科技创新、服务于生产实践的精神，以设计价格低廉，性能优越、结构合理简单的L-band EDFA为目标，依托浙江省科技厅重大科学基金资助项目(001101027)和浙江大学振兴教育计划资助的全光网络的搭建—《光通信技术》课程实验建设项目，展开了如下工作：首先，介绍了掺铒光纤放大器的工作原理，归纳总结了基于速率方程基础的EDFA的各种理论模型，分析比较了各个模型的特点和适用场合，最终选择完善的Giles理论模型作为本论文分析设计EDFA的理论基础；针对实际实验条件提出了修正的EDFA模型的数值计算方法；创新地提出了增益—噪声系数全局分析法，直观有效地分析了EDFA的增益和噪声系数与掺铒光纤长度和泵浦功率的依赖关系，并对各种EDFA的性能作了全面的比较；第二，介绍了掺铒光纤放大器特性参数的定义与测量方法，重点介绍了噪声系数和增益系数的测量方法及实验装置；介绍了组成掺铒光纤放大器各组件的特性测量方法，重点介绍了测量掺铒光纤参数的方法和实验装置；第三，针对WDM系统对L-band EDFA谱平坦、低噪声、高增益的要求，我们创新地提出了四种不同的L-band EDFA结构，按设计思路可以分为两大类：一类是基于单抽运二级泵浦法，这一类包括在未泵浦掺铒光纤的输入端插入一根布拉格光纤光栅的两段L-band的EDFA的新结构；基于前向ASE光作为二级泵浦源推动下一级EDF工作的泵浦分配、两段级联L-band的EDFA的新结构；基于单根光纤光栅、泵浦分配、两段级联的EDFA；另一类则是基于同时应用前后向C-band ASE作二级泵浦源的双抽运法，如基于前后向ASE光作为二级泵浦源的三段级联L-band的EDFA的新结构。
- 更多网络解释与双低方程相关的网络解释 [注：此内容来源于网络，仅供参考]
-
biharmonic equation：双低方程
biharmonic 双低的 | biharmonic equation 双低方程 | biharmonic function 双低函数
-
biharmonic function：双低函数
biharmonic equation 双低方程 | biharmonic function 双低函数 | biholomorphic 双全纯的
-
biharmonic：双低的
bigraded module 双重分次模 | biharmonic 双低的 | biharmonic equation 双低方程