- 更多网络例句与内扭转相关的网络例句 [注：此内容来源于网络，仅供参考]
-
As applications, the 2nd elastic moduli are used to explain the effect of chiral angle on asymmetry behavior of torsion, and finite deformation problems of single-walled carbon nanotubes are successfully simulated by the thin shell model.
作为应用：利用面内的2阶模量解释了纳米管螺旋角相关的力学行为：扭转不对称现象。利用薄壳模型成功模拟了单壁纳米管的大变形弹性失稳行为。
-
The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.
在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。
-
During the experiment, the circular grating with 1200 grating lines was adopted, and the precision of the twist angle (less than 0.001°) was acquired while the rotational speed of the principal axis is within the range of 0～1500r/min.
实验中，测量系统采用1200条刻线的圆光栅，在主轴转速为0～1500r/min的范围内测量其扭矩，扭转角精度小于0.001°。
-
And it was divided into four groups at randomly (n=6),The vertical compression,bending and torsion intensity in without and with reduction of cortical fragment of plate fixated contra side, without and with reduction of cortical fragment of plate fixated sidewere measured.A11 results were analyzed with statistic method.2、animal experiment :The 12 adult goats were divided into two group at randomly,wedged cortical defect with 1 cm of long and conjugate diameter was created in the middle-part of the medial femur and plate was fixed in the defect side and as the experimental side,the other side was control.after operation 4、8、12 weeks,investigation of the fracture healing by means of gross observation,X-ray examination and histology in both sides.
测试各组的垂直压缩、三点弯曲及抗扭转的刚度。2、动物实验：12只健康成年山羊，雌雄不限，体重在20～25kg之间，在同一只羊双侧股骨中段内侧制造楔形骨皮质缺损，分实验组和对照组两组进行钢板内固定并植骨，于术后4、8、12周对实验组及对照组行X线正位片检查，观察骨折愈合过程中不同时间点的影像学特点。于4、8、12周各组处死4只动物行大体标本观察，并取缺损区骨组织行组织学检查。X线检查及组织学检查结果根据LaneX线评分标准及组织学评分标准进行评分。最后采用SPSS13.0进行统计学分析。
-
Methods 40 healthy adult Wistar rats were divided randomly into four groups, sham operation group (group A, n=10), torsion/detorsion group (group B, n=10), single astragalus plus detorsion group (group C, n=10), successive astragalus plus detorsion group (group D, n=10). Testicular torsion/detorsion model was established in terms of turner methods.
将40只健康雄性Wistar大鼠分为4组，分别为假手术对照组，睾丸扭转／复位组，睾丸扭转／复位＋单次腹腔内注射黄芪注射液组及扭转／复位＋连续腹腔内注射黄芪注射液组，每组10只。
-
It's great they now have a way to turn around a fix in 24 hours.
而他们现在有办法在24小时内扭转情况，这是很了不起的。
-
Flexible pneumatic torsion joint is another application of FPA. A torsion joint is mainly composed of two arcual FPAs, which can realize turning movement in a plane.
气动柔性扭转关节是FPA的另一个应用，扭转关节主要由两个弧形的FPA构成，可以在平面内形成旋转运动。
-
In the expariment,18 pieces of moist fresh humeri were used.Results Inpull and compress test,the high level of break load of BLIN was close to that ofboth-ends transverse-interlocking intramedullary nail.
采用18根湿润新鲜肱骨标本进行实验，比较分叉交锁髓内钉与其它三种内固定物固定之肱骨骨折在抗轴向拉伸及压缩、抗弯曲、抗扭转的强度和刚度等方面的差异性。
-
Fix the blades to the plug fixture and tie the cord to the grip with stripped conductors outside on which the crocodile clips clamp.Afterward,hang the weight assembly onto the grip hook to perform the above test.
试 法是将插头片固定于插座内，导线尾端连结冲击锤杆并连结到电线通断指示灯的插座内，设定好试验次数及突拉高度后即可测试突拉，之后吊上砝码进行扭转试验及接地电流试验。
-
In analysis, the whole deformation system is assumed to be composed of the rigid crosssection deformation, the warping deformation produced by torsion, and the deformation in the direction within the cross-section, in which, the torsional deformation effects are well considered.
以平截面假设所确立的变形和扭转所引起的翘曲变形以及截面内方向的附加变形组成截面上材料的整个变形体系，较好地考虑了扭转内力的翘曲及畸变效应。
- 更多网络解释与内扭转相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Inside Out：由内向外
在上挥杆时左肩能够充分向内回旋,但是容易造成由内向外(inside out)的挥杆轨迹,产生旋向左侧的球(hook ball). 相对球的飞行方向左足较右足偏后的站位方式. 在上挥杆时左肩不容易向内扭转,而在完成顺势动作时身体容易打开,
-
intorsion：内扭转 内旋
intomapping 映入的映射 | intorsion 内扭转 内旋 | intort 内扭转 内旋
-
torsional：扭转的,关于[产生,由于]扭转的
torsion 扭力,扭转 | torsional 扭转的,关于[产生,由于]扭转的 | torsional piston ring扭曲环,内切槽活塞环
-
twisting：扭转
山墙、 侧墙体之面内及面外反应,以及整座古迹之扭转(twisting)及对长轴之摇滚(rocking)反应 为. 除 古迹本体外, 座古迹周边适当位置之自由场至
-
gastric volvulus：胃扭转[医]
胃内异物[医]Foreign body in stomach | 胃扭转[医]gastric volvulus | 胃扭转复位术[医]Reduction of volvulus of stomach
-
WipeOut：毁灭
接下来我独自去玩了两个设施-堡礁潜水(reef diver)和终极毁灭(wipeout). 第一项游乐设施会随著轴心向上就越接近垂直,看到的全是蓝色(天空),也渐渐失重了. 第二项游乐设施有两根柱子支撑,只要一旋转,我们也会在车身内扭转. 上到下,
-
intort：内扭转 内旋
intorsion 内扭转 内旋 | intort 内扭转 内旋 | intortor 内旋肌
-
intort：向内弯曲
torsion 扭转,转矩 | intort 向内弯曲 | torch 火炬,火把;手电筒
-
inside-out motor：扭转电枢式同步电念头; 反结构同步电念头
inner tube of pneumatic tyre for motor cycle 摩托车用充气车胎内带 | inside-out motor 扭转电枢式同步电念头; 反结构同步电念头 | instrument motor 仪表电念头
-
Cesarean Section：剖腹产术
这项研究结果 ...剖腹产术(Cesarean Section)适应症麻醉与保定切口定位照片1-8-1图1-8-45适应症视频72);在无菌动物也需剖腹产取出胎儿. 当子宫扭转的动物,在保守疗法整复扭转的子宫无效时,或经腹腔内整复无效时,也需做剖腹产再整复扭转的子宫.