使加热成形

基本解释 (translations)

thermoform  ·  thermoformed

与使加热成形相关的网络例句 [注：此内容来源于网络，仅供参考]

The HA sinter with optimal strength and porosity could be obtained when HA was mixed with 1 of fold sucrose which was used as filler while binder and 1 of fold salt as filler, pressed under 5-45 kgf/cm2 force, dissolved the sucrose at 220°C, and then sintered under 1345°C for 10h.

目前得到，使用砂糖及食盐当作填充剂，以HA比砂糖比食盐为1比1比1，5-45 kgf/cm2的压力压制成形，再以220°C下加热使砂糖溶解，并且在1345°C烧结10小时的烧结物的强度以及孔隙度为最佳。

Fill the piping with stuff, line to define the length and position for heating tube, daub tube, warm-up, make the role touch the piping by pressing the push-bike, heat up the piping to the necessary temperature, cut off power supply, one-off complete the process in the bending model.

在管坯内装填填充物、划线确定管坯加热的长度和位置、涂抹润滑剂、管坯装卡、预热、通过脚踏机构加压使电极与管坯紧密接触、采用二次加热工艺将管坯加热至所需温度、切断电源，在弯曲成形模具上一次性完成管坯的弯曲成形加工。