- 更多网络例句与钳位相关的网络例句 [注：此内容来源于网络，仅供参考]
-
To start things a flat board was set up on my bench and clamped..
开始的东西，一个单位，局设立了我的板凳和钳位。。。
-
Overvoltages are initially clipped by breakdown clamping until the voltage rises to the breakover level, which causes the devices to crowbar into a low-voltage on state.
保护器由一个匀称电压触发型双向交流二极管组成，过电压最初被弱钳位剪除址到电压上升至超过的级别，该级别会造成装置进入一个低电压开启状态。
-
And methods of modification are proposed, which are mainly presented on clamping circuit and method of compensating for the errors of count results. Thus the performance of system can get further improvement.
在测试过程中，发现了现有实现技术的某些不足，并有针对性的提出了改进，主要体现在计时电路中的钳位电路设计和脉宽补偿思想，有利于进一步改善系统性能。
-
For a basic DC circuit with a clamp across the fast acting switch the family of curves shows the clamp energy that must be absorbed versus the available fault current in the circuit.
一个基本的直流横跨快速动作开关曲线家庭钳位电路显示钳位能源，必须与现有的电路故障电流吸收。
-
In the interest of getting good performance of speed and loading capability of the micro motor, at the same time ensuring the high rotary resolution, put forward a kind of new precise rotary motor using piezoelectric stack as actuating element based on inchworm motion.
为了保证微小型电机的速度和承载能力，同时获得较高的运转分辨率，提出一种以压电叠堆为驱动元件基于尺蠖运动原理的新型精密旋转电机方案。电机结构中转子无绕线结构，定子采用柔性铰链双侧对钳方式交替对转子起到钳位作用。
-
A novel hybrid diode-clamp cascade multilevel converter is presented in this paper. The new concept of the converter is based on connection of multiple diode-clamp converter modules with different dc bus voltages. Normally, the voltage blocking capability of faster devices such as IGBT and the switching speed of high voltage devices like GTO are found to be limited.
该文在研究传统的级联多电平、传统混合级联多电平以及二级管钳位级联多电平变换器的基础上提出了一种新型的混合二极管钳位级联多电平变换器，这种新型变换器是将具有不同直流母线电压的多个二极管钳位多电平变换器进行级联，输出电压是将这些变换器的输出电压进行矢量相加而合成的。
-
The clamp gate input at pin 11 accepts a TTL level clamp signal for DC restoration during the back porch segment of the video signal.
在引脚11钳门输入，可在视频信号的后阳台部分为TTL电平直流恢复钳位信号。
-
When the user toggles the switch to Position 3, the pin is grounded, and the pin bit is zero, regardless of the value of the port bit.
当使用者钳位开关到位置3时，管脚接地，管脚位为0，与端口位的值无关。
-
When the user toggles the switch to Position 1, the pin connects to VDD through resistor R5, and the pin bit is one, regardless of the value of the port bit.
当使用者钳位开关到位置1时，管脚通过电阻R5连接到VDD，管脚位为1，不论端口位是什么值。
-
The influence of the leakage inductance of transformer on flyback converter and power device is great, which can be suppressed by RCD clamp method. However, the parameters of RCD clamp are usually achieved by the designers' experience.
反激式电源变压器的原边漏感对电路性能及其功率器件影响很大，通过RCD钳位电路可以很好地抑制由于漏感而产生的电压过冲，但钳位电路参数设计往往是通过经验获得，设计方法不是很明确。
- 更多网络解释与钳位相关的网络解释 [注：此内容来源于网络，仅供参考]
-
clamper：钳位电路
钳位电路(clamper)采样CCD黑像素的数字,然后每个像素的值都减去这个黑电平值. 用户可以通过寄存器设置黑电平像素的位置,用于求黑像素的数量(8个或16个). 另外,也可以将黑电值设置成一个常数.
-
clamper：钳位电路;钳位器
clamp-on current probe 钳式电流探测器 | clamper 钳位电路;钳位器 | clamping 箝位
-
triode clamper：三极管钳位器
triode amplifier 三极管放大器 | triode clamper 三极管钳位器 | triode clipper 三极管削波器
-
switching clamper：开关钳位器
switching and pressure equalizing valve 切换均压阀 | switching clamper 开关钳位器 | switching computer 开关计算机
-
switching clamper：开关钳位电路
switching circuit 开关电路; 开关线路; 转换电路 | switching clamper 开关钳位电路 | switching coefficient 开关系数; 转换系数
-
clamper tube：钳位管
钳位放大器 clamped amplifier | 钳位管 clamper tube | 钳位脉冲 clamp pulse
-
G-CLA M P：绿信号钳位电容器
18 ROU T 红输出 | 19 G-CLA M P 绿信号钳位电容器 | 20 BOUT 蓝输出
-
clamped amplifier：钳位放大器
钳位二极管 catching diode; clamping diode | 钳位放大器 clamped amplifier | 钳位管 clamper tube
-
clamping：钳位
图象处理芯片内置象素采样(down-sampling),钳位(clamping),窗口定位(windowing)电路设计,适用图象处理芯片内置象素采样(down-sampling),钳位(clamping),窗口定位(windowing)电路设计,适用
-
Back clamping：反向钳位
Back 返回 | Back clamping 反向钳位 | Back drop 交流哼声,干扰声