roll finish

roll finish的基本解释

-

滚光

与roll finish相关的网络例句 [注：此内容来源于网络，仅供参考]

This painting fully portrays his run-down illusions, including all of his blurred thoughts and ideals. But he tried to avoid the process in which he couldn' t finish reading the long roll of painting. He was lost again in another lake with drifting auspicious cloud. This painting was clinquant.

这帧画，完完整整地描摹着他荒芜的梦幻景象，包含着他全部迷离的思想和理想，只不过他竭力回避那轴永远不能解读完的长卷过程，但是他又重新走失在另一片祥云飘散的湖淖里。

This research job analysised the extending roll pass system the finish roll pass system and the ultimate roll groove. The mathematical models and experience formulations used for roll pass design are corrected according to the basic theory and the practical experience of the engineerings. The thread steel bar CARD was set up with the visual program tool-VisualBasic6.0, based on the method of the structural program design.

本课题通过对螺纹钢延伸孔型系统、精轧孔型系统及成品孔型的构成和设计方法的分析，结合螺纹钢孔型系统的基本设计理论和工程技术人员的实际生产经验，对以往孔型设计过程中所使用的数学模型、经验公式等进行了修正，以结构化程序设计方法为基础，采用可视化编程工具VisualBasic6.0建立了螺纹钢计算机辅助孔型设计系统。

Polishing machine coated roll and roll and penetrated the metering rollers, directly affects the product iuster is good or bad, such as coating roll and roll of clearance too large, you can Polish paper and coated rolls off the paper bad contact so that the oil absorption corresponding regarding the reduction of roll coating rollers and penetrated the size determines the amount of finish coating the, should be based on the paper--absorption of strong or weak, adjustment and coated roll roll the size of the gap in order to ensure that products on the light intensity.

上光机的涂布辊与衬辊和计量辊之间的间隙是否合适，直接影响到产品上光亮度的好坏，如涂布辊与衬辊的间隙调得太大，就容易使上光的纸面与涂布辊接触不良，使纸面吸油量相应就减少涂布辊与计量辊之间的间隙大小，则决定着上光油涂布量的大小，所以，应根据纸面吸收性的强弱，调整涂布辊与计量辊间隙的大小，才能确保产品上光的亮度。

与roll finish相关的网络解释 [注：此内容来源于网络，仅供参考]

routine maintenance：例行维修

rough-cast finish 粗注面 | routine maintenance 例行维修 | routine roll-forward of the Comprehensive Redevelopment Programme 定期公布的向前推展整体重建计划

starched fabric：上浆织物

"白浆辊筒","starch roll" | "上浆织物","starched fabric" | "上浆加工","starched finish"

rubber-coated roll specified：橡胶涂层

S type finish coater with bottom side coating S型面漆涂布机,带底面涂布头 | rubber-coated roll specified 橡胶涂层 | roundness 圆度