胶

Our company specially produces cold silica gel tube,water tank tube,admitting tube,oilresistant pipe,heat-reslstant pipe,warm braw pipe,high-pressure oil pipe,steel wire bberized tube,printing rubber-covered roll,mine rubber-covered roll,rubber sheath,high strength earthquake resistance cushions and seal cushions for motors vehicles,agricultural vehicles,engineering machineries and plant equipments.

漳州众鑫橡胶有限公司是专业生产汽车、农用车、工程机械、机械设备的中冷气硅胶管、水箱胶管、进气胶管、耐油胶管、耐热胶管、暖风胶管、高压油管、钢丝胶布管、印刷胶辊、矿山胶辊、橡胶护套、高强度抗震胶垫、密封胶垫以及各种耐酸、耐碱、耐热的胶圈、胶条、胶垫等橡胶制品。

We provide honey,bee pollen,royal jelly(quality material, frozen-dry royal jelly powder, royal jelly tablet and royal jelly oral liquid etc.), beeswax, propolisraw material propolis, refined propolis, propolis powder, propolis capsule etc.

公司主要提供蜂蜜、蜂花粉、蜂王浆（优质原料，冻干粉，含片，口服液等）、蜂蜡、蜂胶（原料胶，提纯胶，蜂胶粉，蜂胶胶囊等）和蜂胶系列产品（食品，保健品，日化产品等）。

The interfacial chemistry, synergistic effects and interfacial kinetics of thesynergistic extraction system D_2EHPA-MPA-Fe~(3+) have been studied, where MPA is amono-alkyl phosphate extraction with long carbon chain. D_2EHPA in the mixed extractionsystem strongly exhibits the effect on the thermodynamics of micella formation and interfaceproperties of MPA. Some thermodynamic parameters of micella formation were obtained.The interfacial adsorption behaviour of D_2EHPA is opposite to that of MPA. Theemulsification for single MPA and the mixed system was discussed. The synergistic effectswere found in this mixed extraction system. It is proved that the process of Fe~(3+) extractionfor non-mixed extraction system is controlled by chemical reaction, the controlling reactionoccurs at the interface, and the reaction rate equation is obtained.

本文研究了协同萃取体系D_2EHPA—MPA—Fe~(3+的胶团形成热力学、界面特性、协萃效应和界面动力学(动力学控制机制和反应速率方程)研究发现，混合萃取体系中的D_2EHPA强烈地影响MPA的胶团形成热力学和界面吸附行为，得到了胶团生成常数、胶团形成自由能和临界胶团浓度的热力学参数D_2EHPA和MPA具有相反的界面吸附行为研究发现D_2EHPA—MPA混合萃取剂体系对Fe~(3+)产生了协萃效应动力学和界面化学的研究结果还证实了非胶束混合萃取体系的Fe~(3+)的萃取过程是受化学反应控制的，控制反应发生在界面上

After a reaction time of about 100 min at room temperature, the silica sol was transformed into solgel, which was dried by supercritical drying technique to obtain woodnano-SiO2 aerogel. The chemical structure of wood-nano-SiO2 aerogels were studied by Fourier Transformation Infrared Spectroscopy.

应用FTIR方法对上述溶胶-凝胶法木材-SiO2气凝胶复合材料的结构进行了表征，结果表明，复合材料的FTIR特征基本上是由木材与SiO2气凝胶谱图加合而产生的，没有得到木材与SiO2气凝胶产生化学结合的明确证据，但是观察到气凝胶中Si-OH结构信息（844cm^-1）；部分木材-SiO2气凝胶复合材料试样中1735cm。

The temperature behavior in mats was measured using CopperConstantan Thermocouples, and the core temperature cure during both pressings was simulated by means of a computer under various conditions.Reflected-fluorescence microscopy and image analysis techniques were used to measure the flow and penetration of PF adhesive into the Polar flake under various steam-injection-vacuum-pressing conditions. The paper also studied the effects of adhesive and penetration on flakeboards'mechanical properties.

研究结果表明：采用聚合度较大的水溶性A阶酚醛树脂胶，可以比较有效地克服目前水溶性酚醛树脂胶喷蒸热压大片刨花板中的树脂胶过度稀释、渗透及胶线缺胶的问题；适当选择饱和蒸汽压力、喷蒸时机、喷蒸时间、蒸汽保持时间和抽真空处理程度，是解决目前水溶性A阶酚醛树脂胶在喷蒸热压中所存在的问题的另一个重要途径。

In the early 1970s by the then Beijing business card printing and membership card making Technology Research Institute (for Chinese business card printing and membership card making science and Technology Research Institute), shnagqiu printing machinery factory and Yibin printing machine common development and production of the first generation bookbinder--PRD-1-product line of binding, it can be machined with 16 and 32-64-open single, twin with the maoba book, complete with page, milling back, dehairing, a letter to the core gum floorings、decorative gauze cardboard, plastic, pressure on the cover are formed, you can not book thermalsteam riprapped waste, production speed 3600 ~ 6a this/, while the line with the international advanced bookbinder quite, but to fill our binding line blank, about changes in China's extremely backward collers bookbiding dhlopen has played a very important role.

20世纪70年代初由当时的北京制卡和会员卡制作技术研究所(后改为中国制卡和会员卡制作科学技术研究所)、商丘印机厂、宜宾印机厂共同开发生产了第一代胶订机--PRD-1型无线胶订生产线，它可以加工16开、32开单联、64开双联毛本书，全线完成配页、铣背、打毛、上书芯胶、贴纱布卡纸、上封面胶、加压成型等工序，可以不停机抛废书，生产速度3600～6500本/时，虽然该线与当时国际上先进的胶订机差距甚大，但填补了我国无线胶订生产线的空白，对改变我国书刊装订极其落后的面貌起到了很大的作用。

Locust bean and guar gums enhanced resistant starch content compared to gum arabic due to their glycosidic linkages and viscoelastic properties. The difference between locust bean and guar gums is ascribed to the low average length and frequency of unsubstituted mannose sequence in locust bean gum.

与阿拉伯胶相比，刺槐豆胶和瓜尔豆胶在增加抗性淀粉含量方面效果更显著，这主要归功于他们的糖苷键连接和粘弹性质瓜尔豆胶和刺槐豆胶的效果差异主要是源于刺槐豆胶中未取代的甘露糖链的平均长度以及频率更低一些。

This company mainly produces rubber paste, neoprene, g-neoprene, PU glue, adhesive, plastic decoration, glue silk flowers, white latex, various types of days that water, clean agent, deal with water, hardening agent is also to produce environmentally-friendly products.

本公司主要生产橡胶糊、氯丁胶、接枝氯丁胶、PU胶、喷胶、装修胶、丝花胶、白乳胶、各类天那水、清洁剂、处理水、硬化剂还生产环保系列产品。

Specializing in the production of plaque: hard and soft plastic resin, plastic flow only, AB glue adhesive, all kinds of aluminum high-light sign, crystal Epoxy signs, metal signs and corrosion, electroforming plate, PC, PVC plate, chassis panels, membrane switch, soft and hard Crystal Epoxy, metal paste character cast aluminum signs, laser anti-counterfeit stickers affixed, metal corrosion and a variety of processing incoming screen.

深圳市鑫鸿华五金铭牌制品有限公司专业生产：环氧树脂软硬胶，止流胶，AB胶接着剂，各种铝质高光标牌，水晶滴胶标牌，五金及腐蚀标牌，电铸标牌，PC、PVC标牌，机壳面板，薄膜开关，软硬水晶滴胶，金属贴字，铸铝标牌，激光防伪不干胶贴，金属腐蚀以及各种来料丝印加工。

The morphological structure of cured vinyl-ester resin and the formation of two-phase structures in vinyl-ester resin has been studied by using SEM and differential scanning calorimetry.The results demonstrated the existence of clusters of gel-particles with a size of about 20 μ m,each cluster of gel-particles containing many gel-particles with coral-like structures.The formation of gel-particles resulted in two-phase structure characterized by the two peaks in the rescanned DSC thermographs of the resin. The cure conditions (temperatures,post-cure) affected microstructure in the cured resins.

采用SEM、DSC研究了乙烯基酯树脂固化过程中凝胶粒子的形成过程及两相结构对固化放热的影响，结果表明，凝胶粒子在固化树脂中呈群状分布，每群凝胶粒子的最大尺寸为20μ m左右，每群凝胶粒子由许多独立凝胶粒子组成；凝胶粒子的形成使树脂产生了两相结构，使树脂的恒温DSC残余放热呈双峰分布；树脂的固化条件影响其微观结构。

Next time I see you,I shall give you a black eye.

下次我看见你，我会打你一顿。

In this paper,design scheme of classification system of wood surface color is established.

提出了木质板材颜色分类的系统设计方案。