电流密度

In our experimental results, we have transferred the GaAs solar cells from GaAs substrates onto the mirror-coated copper substrates with the base layer thickness of 1.5 μm. The photovoltaic performance of the orginal GaAs solar cell on a GaAs substrate was also measured. Under AM1.5G and without anti-reflective coatings conditions, it is found that the Jsc can increase from 12.6 mA/cm2 to 13.82 mA/cm2, while the conversion efficiency can improve from 7.91% to 8.53%. As a result, the enhanced Jsc and η data of the GaAs solar cells can be contributed by the AuGe/Au mirror between the GaAs solar cell and copper substrate.

在实验验证方面，本实验室将砷化镓太阳电池由砷化镓基板转移至铜基板上，在基极厚度1.5 μm、AM 1.5G、以及元件未披覆抗反射膜的条件下，短路电流密度可由12.6 mA/cm2提升至13.82 mA/cm2，增加9.7%，而转换效率则可由7.91%提升为8.53%，这结果显示当砷化镓太阳电池基极底部镀有金属反射层时，的确能适度地提升太阳电池的短路电流密度及转换效率。

The factors that affected the degradation rate of methyl red are discussed, including the concentration of methyl red, the kind of electrolyte, the concentration of sodium bromide, the anodic current density, the material of electrode, the cathodic current density and the flow rate of oxygen at the catholyte.

探讨甲基红浓度、电解质种类、电解质浓度、阳极电流密度、电极材料、阴极电流密度与阴极室氧气流量等因表对甲基红电分解的影响。

The results show that the technical parameters and the concentration of sodium molybdate have obvious effect on the composition of the alloy. The crystal grain size is from 6.2 to 12.7 nm and changes with current density, temperature and the pH value of the electrolyte.The crystalline growth of the alloy accords with the model of three-dimensional growth. The surface morphology is mainly determined by the rate competitions between the growing direction of vertical surface and the expanding direction along the surface towards circumambient. The results of the X-ray data show the presence of the multiphase containing solid solution and intermetallic compound in the deposits. The deposit phases alter from the FeNi and FeMo solid solution to the FeNi and MoNi4structure at 3 A/dm2. The deposits internal stress increases linearly with the decrease of the grain size. The lattice parameter of the deposits are slightly distorted

结果表明：工艺条件和钼酸钠浓度对合金组成的影响较大；所得合金晶粒尺寸为6.2~12.7 nm，并随电流密度、温度和电镀液的pH值的改变而变化；合金的晶体生长符合晶核三维生长模型，镀层表面形貌由平行和垂直于基体的生长速度的相对大小决定；镀层物相为固溶体和金属间化合物的多相结构，当电流密度为3 A/dm2时，镀层物相由FeNi和FeMo固溶相转化为FeNi和

The results show that when the cathode humidified temperature increase, the humidification of membrane and fuel cell performance improved at lower current density, while the saturation in diffusion layer increase and the performance decreases at higher current density. Humidification of membrane and fuel cell performance improved when the anode humidified temperature increase, the saturation in diffusion layer decrease and fuel cell performance improved when the fuel cell working temperature increase, the resistance of diffusion layer decrease and the performance improved when the porosity largen. At last, the simulation results are compared with the experimental results and they are basically the same.

结果表明随阴极加湿温度的提高，在低电流密度运行时膜的润湿条件改善，燃料电池性能提高，在高电流密度运行时扩散层中液态饱和度增加，燃料电池性能下降；随阳极加湿温度的提高，膜的润湿条件改善，燃料电池性能提高；随燃料电池运行温度的提高，扩散层中液态饱和度下降，燃料电池性能提高；随气体扩散层孔隙率增加，气体扩散层阻力减小，燃料电池性能提高。

Influence of the magnetic field on the microstructure of AZ91 magnesium alloy;2. The results show that the current density, magnetic field intensity and electromagnetic force in melts are distributed nonuniformly to a great extent.

应用数值方法对直流电弧炉条件下的 Maxwell 方程进行了解析，结果表明，熔体中的电流密度、电磁场强度和电磁力的分布是非常不均匀的，电弧附近的钢水中的电流密度较其它区域高出 1～2 个数量级，电磁力较其它区域高出 2～3 个数量级，该区域的电磁力对熔体搅拌起着决定性的作用，预测了钢水的流形。

Zn-La alloys increase the overpotential ofhydrogen evolution, Tafel slope 〓 and polarization, decrease the corrosion current density, inhibitthe corrosion of zinc electrode in alkaline solution, decrease anode Tafel slope 〓, promotedischarge reaction of zinc electrode, have higher passivation current density, inhibit thepassivation of zinc electrode, avoid the oversaturation of zincate in electrolyte, greatly increase〓 diffusion coefficient, decrease Tafel slope 〓, polarization and the overpotential of deposition,inhibit the dendrites formation and improve the electrodepostion of Zn.

实验结果表明，Zn-La合金电极显著改善了锌电极的各项电化学性能：提高析氢过电位、析氢过程Tafel斜率〓和极化，减小腐蚀电流密度，抑制锌电极在碱液中的腐蚀；降低阳极Tafel斜率〓，促进了锌电极的放电反应；具有较高的维钝电流密度，抑制锌电极的钝化；有效避免了溶液中锌酸盐的过饱和现象：使〓的扩散系数明显增大：降低Zn沉积过程的Tafel斜率〓、极化和沉积过电位，明显抑制锌枝晶的生长，改善了锌的电沉积性能。

It is advisable to decrease the humidifying level of anode gas when operating at high current density to avoid two-phase flow in cathode so as to improve mass transfer.

故PEMFC在小电流密度工作时，应该使阳极气体充分增湿；而在大电流密度工作时，应该适当降低阳极的增湿程度以降低阴极两相流的机会，从而改善阴极的传质状况。

The content of impregnated Ba, Ca aluminates in the bodies can meet the requirements of the conventional impregnated cathode. Emission experiment results show that the space charge limited current density of this kind of cathode has reached more than 30A/cm^2 at 850℃.

发射试验结果表明，这种阴极在850℃的工作温度下空间电荷限制的电流密度超过30A/平方公分，在超过2000h的寿命实验过程中发射仍持续上升，因而在要求高电流密度和一定寿命的微波电子管中具有光明的应用前景。

The density distribution of the ESP plate current plays an important role in evaluating it. It is important to research on the device of steady, fast and convenient measuring the plate current density for the design of ESP and electrode configuration.

电除尘器板电流密度分布是衡量其极配形式优劣的一个重要参数，研究稳定、快速、方便地测出板电流密度的装置对电除尘器的设计和极配形式的开发都很有必要。

After measurement and analysis of the interfering voltage, potential gradient, the point current density, the weight-loss increases with average current density, and the depth of penetration increases with the interfering voltage.

测量和分析了干扰电压、电位梯度、点电流密度、失重量及腐蚀坑深后，可以看出失重量随平均电流密度而增加，腐蚀坑深随干扰电压而加剧。

Do not gum up the work by telling mother what we are going to do .

别告诉母亲我们要干的事，那会把事情搞糟的。

In recent years, application of the partial prestressed concrete beam s is developed.

近年来，随着部分预应力砼梁应用的推广，发现我国规范所采用的名义拉应力法的计算结果不稳定。