测功的

Electric power ergograph is a load or device of absorbing power, which mainly is used of measuring power for middling torque.

电力测功机是常用的负载与吸功设备，主要用来对中等大小的扭矩测功。

Main factor determining the characteristics of a loading vehicle is its dynamometer characteristics. Currently common dynamometers couldn't meet the low speed and high load requirements of a loading vehicle and make the power absorbing system structure complicated and the test procedure complex.

决定负荷车特性的主要因素是测功机特性，目前常见的测功机不能满足负荷车低速大负荷加载要求，并使负荷车功率吸收系统结构复杂，试验操作繁琐。

A set of hardware is designed. The real time control of dynamometer is accomplished by using fuzzy control tactic.

建立了一套传感器的使用和信号处理方法，设计了一套测功机控制单元硬件，并实现了采用模糊控制策略对测功机的实时控制。

A new control method for CJD alternating current electrodynamometer by using fuzzy control strategy based on major dynamics including non-linearities,instabilities and load disturbances is presented.

针对CJD 交流电力测功机实验过程中的非线性、不稳定性和负荷干扰，基于模糊控制策略下给出了CJD 交流电力测功机转速新的控制方法。

Via the work of this paper, it is feasible that the measure and control system can testand control every parameters of ergograph by applying computer measure and control technology.

通过本课题的工作，应用计算机测控技术开发出能对测功机各参数进行测量和控制的测控系统。

On the running theory of electrical power ergograph and the basic control theory basis, this paper expatiate on the mathematic model and modulating speed of ergograph, and expounds the principle and ways of design of hardware and software for measure and control system, and describes the hardware and software with some frames and interfaces, and importantly recommends the way of designing software.

本文根据电力测功机的工作原理和控制理论基础，主要阐述了测功机的数学模型和调速原理以及整个测控系统的硬件和软件设计的原理和方法，并辅助框图和界面对软硬件进行了详细描述，重点介绍了系统软件的设计。

This paper, on base of analyzing and comparing the correlational measure and control product of domestic home and overseas, achieves real-timely inspecting and measuring every parameter of ergograph with more advance technology of computer measure and control and a method that software can achieve the function in substitute of complex hardware circuit.

本文在分析和比较国内外相关的测控产品的基础上，采用了较为先进的计算机测控技术，以软件方法代替以往需要复杂硬件电路才能实现的功能，能够对测功机的各项参数的实时检测。

Based on the torsional oscillation theory of diesel shafting,this article analyses the measured signal values of measuring power by shaft s deformation.

在柴油机轴系扭振理论的基础上对通过轴应变来测功的测量信号量进行分析，并通过实例证明了这种分析在对测量信号量进行数学处理中的重要意义。

The aerostatic bearings of minimum friction are used in two yawing measuring sets of the dynamometer.

该测功机采用摩擦阻力最小的空气静压轴承作为两个测量机构的摆动轴承，能同时分别测出涡轮发出的功和涡轮增压器损失的机械功。

The utility model comprises two steel wire fixing adjustors and a spring ergometer, wherein, each steel wire fixating adjustor comprises front and back adjusting slide blocks, an adjusting support block, a bidirectional vertical adjusting slide block and adjusting bolt and a clip ring; the spring ergometer is connected in series between the steel wire adjustors.

该实用新型包括两个钢丝固定调节器和弹簧测功仪，在那里，每个钢丝固定调节器组成，前台和后台调整滑块，调整支持座，垂直双向调节滑块，调整螺栓，并剪辑环；春天测功仪是连接在一系列之间的钢丝调节器。

He is the most remarkable man that I have ever known.

他是我知道的人中最值得注意的人。

Increased appearance of lymphocele was noticed in patients with diabetic nephropathy, congenital malformations of the urinary tract, and inflammatory diseases, including glomerulopathy and extraglomerular ones, after high-voltage radiotherapy and after removal of the renal graft.

经过高压放射疗法和切除移植肾后，在糖尿病肾病患者、泌尿系统先天性畸形患者和炎症患者身上发现淋巴囊肿有所增加，包括肾小球病和球外疾病等。