模图

The selections of parameters between point-line meshing gear and involuted gear are different while designed.

点线啮合齿轮的封闭图与齿数z1、z2及刀具参数有关，而与中心距a及模数mn无关。

Apparent multimodality of the distribution, or lack of it, is often an artifact of the size and nature of the area mapped

明显的多模态分布的存在或不存在，往往是一种因编图区大小与性质的关系搞成的人为产物。

Too much unsharp mask will give the whole image a hard, pixilated look.

太多锐化掩模将使整个图象硬， pixilated期待。

We run the two meshes through the Unreal Engine 3 preprocessing tool and generate a high-res normal map for the renderable mesh, based on analyzing all of the geometry in the detail mesh.

然后我们将两个模型通过虚幻3引擎所提供的法线贴图处理工具进行映射加工，从而产生出一张用在低模上的高分辨率法线贴土。

The sinogram data used in the study was obtained from simulated phantom data.

研究中使用的正弦图数据来自模拟体模数据。

Overpacking and underpacking An overpacked cavity pressure curve is shown in Figure 10b.

过充填和充填不足图10B显示的是过充填的模腔压力曲线，他的特征就是在充填阶段有个压力峰值。

Figure 5 shows a technique which allows higher common mode input impedance while maintaining a lower differential source imped- ance.

图5显示了一个技术，它允许较高的共模输入阻抗，同时保持较低差源阻抗-安斯。

Three types of base asphalt and six SBS were used to produce SBS modified asphalt. The interaction of SBS modified asphalt was discussed in different states between the base asphalt and SBS based on their compositions. Through the traditional tests, such as penetration, soften point and ductility, and US SHRP tests, the results indicated that influences to affect the temperature susceptibility, high and low temperature performance, aging characteristics are base asphalt, SBS types and their dosages. The functions of penetration to viscosity and complex shear modulus G~* to complex dynamic shear viscosity η~* were set up, and then theviscosity-temperature susceptibility of wide temperature span and the calculation method of low temperature viscosity were obtained."Process" evaluation criterions, high grading critical temperature T_ and low grading criticaltemperature T_ , were suggested according to the high and low temperatureperformances of SBS modified asphalt. Using the experience of Repeated Creep and Recovery Test for Binders, a new high-temperature evaluation index,modification rutting factor G~*~(-9) was obtained. The results after RTFO and PAV aging indicated that traditional tests didnt differentiate base asphalt and SBS modified asphalt, but dynamic mechanics temperature spectrum and G*-5 black chart clearly reflected the influence of aging to the SBS modified asphalt. With the IR and GPC tests, the reason of aging to the SBS modified asphalt were due to asphalt phase oxygenated and SBS phase depredated.

论文选择3种油源的基质沥青和6种SBS改性剂制备改性沥青，通过分析基质沥青和SBS改性剂的组成结构特点，得出了不同状态下SBS改性沥青的SBS与基质沥青的相互作用机理；通过针入度、软化点、延度等常规试验以及美国SHRP试验，分析了基质沥青、SBS改性剂类型与剂量对SBS改性沥青的温度敏感性、高低温特性及老化特性的影响；建立了针入度-粘度、复数模量G~*-复数粘度η~*的换算关系，得出了宽温度域的粘温指数VTS和较低温度下粘度的计算方法；通过高低温性能分析提出了&过程&评价参数高温等级温度T_和低温等级温度T_；借鉴重复恢复与蠕变试验研究成果，得到了SBS改性沥青高温评价指标改进型抗车辙因子G~*~(-9)；RTFO和PAV老化后的性能试验结果表明，常规试验难以区分SBS改性沥青与基质沥青的差异，而动态力学温度谱、G~*-δ黑斑图可以反映老化作用对SBS改性沥青的影响，且通过IR试验和GPC试验得出SBS改性沥青老化是沥青相的氧化和SBS的降解共同引起的；通过不同温度下SBS改性沥青混合料的旋转压实SGC试验，根据粘度与剪变率的关系，提出用剪变率60(1／s)测试SBS改性沥青的粘温曲线，并按照0.17±0.02Pa.s和0.28±0.03Pa.s确定施工温度。

The tubing die,Figure 10,extrudes plastic tubing concentrically around the emerging conductor.

螺纹模头（图10），机械运行时塑料材料是围绕着导体延压出来。

The proposal software has those basic functions, such as the drawing database management, the literature compilation, the selection of scheme and parameters of foundry technology, the casting weight and modulus calculation, and autonomous Learning.

该软件具有图库管理、资料查阅、铸造工艺方案和参数选择、铸件重量和模数计算及自主学习等基本功能。

He knows that he's one of the mostdominant players in the NBA right now.

我知道他现在是联盟里最有统治力的球员之一了。

Using analysis method of BCG , the dissertation analyzed the management of voluntary service organizations .

利用BCG分析方法对我国的志愿服务组织管理进行了分析。