反映体

Except for Tibetan Plateau and its surrounding regions, the results derived from lithospheric isostasy model are closer to observed elevations and consistent with vertical velocities of crustal movement in most tectonic units.

通过对均衡状态分析，我们得到以下主要结论：(1)构造稳定地区均衡程度较高；(2)青藏高原及周边造山带现今地壳运动主要为区域构造过程及深部动力学过程所控制，均衡调整过程不是主要控制因素；(3)现今地壳垂直运动比较明显的块体处于均衡调整阶段，地表垂直运动的大小反映了该区所受的均衡力作用的程度；(4)构造稳定地区基于岩石层均衡的理论计算海拔与观测海拔之差值和现今地壳垂直运动速率有较好的相关性，据此我们可以通过均衡分析研究构造块体的运动趋势和动力学性质；(5)地慢热结构对现今地形、海拔及地壳垂直运动有显著影响，在处理均衡问题时，地慢岩石圈热结构是我们必须考虑的重要因素。

The high levels of Ddimer is related to the severity of vascular damage in KD.

D二聚体在川崎病血管损伤发生、发展中有着密切的关系。D二聚体的升高反映了川崎病存在明显的高凝状态和血栓形成倾向。

As for the species composition and characteristics of a tropical forest community with many rare species, plot methods are better than plotless ones, while multiple neighbour methods better than single ones.

由于许多偶见种的存在，因此就反映热带森林群落的种类组成和真实特征而言，样方法优于无样地法，多邻体法优于单邻体法。

Based on the observation of atomic force microscopy, the etching morphology of faces and sections with different crystallographic significance on α-quartz has been studied. The etching morphology on the natural crystal faces hexagonal prism faces (1010 and 01(average10, rhombohedron positive form face 10(average11, rhombohedron negative form face 01(average11 and the sections between any of the two crystal faces has been observed. It is shown that the etching pit on the same simple form has the same shape, while the orientation of the etching pits can be different. Different simple forms have different shapes of etching pits and the shapes of etching pits on positive form and negative form of the same simple form are also different.

通过对α-石英自然晶面六方柱面10(平均值10和01(平均值10、菱面体正形面10(平均值11与菱面体负形面01(平均值11、以及介于上述自然晶面之间的切面进行腐蚀形貌的观察研究发现，石英晶体同种单形的晶面腐蚀坑形态相同，但方位可以有变化，不同单形的晶面腐蚀坑形态不同；同一单形的正形与负形腐蚀坑形状不同；蚀坑形态能够反映晶体的对称性。

The results showed that the four stereoisomers of soman were well separated under the defined chromatographic conditions. CP-）soman was only detected stereoisomer in the intoxicated rabbit blood and eliminated rapidly, the toxicokinetics could be described by a two-compartment model after rabbits received soman via vein.

结果可见梭曼4个异构体在确定的气相色谱条件下得到了较好地分离；给兔iv梭曼43.2 μg·kg-1后，血中仅测到一对CP梭曼，其消除过程符合二室开放模型， V d=2.1 L·kg-1， t 1/2α=4.5 s， t 1/2β=72 s， AUC(15～300 s)=2.08 mg·s·L-1， CL =21 mL·kg-1·s-1，血中CP梭曼在血中消除过程反映了机体对梭曼毒性异构体的解毒过程。

Whereas the high conductive layer in the northern crust is connected with Asian continent′s resistance against the northward underthrust of India plate and the southward underthrusting of Asian continent.

研究区内的冈底斯及羌塘地体的中、下地壳普遍发育高导层，反映了印度大陆碰撞、俯冲过程的效应与痕迹，而高导层之下的高阻块体则可能是向北俯冲、冷的、刚性的印度大陆地壳。

When bilaminated rock mass is numerical analyzed by conventional finite element method ,that the shortcomings produced is not only the huge modeling workload and maneuverability become more inefficient with layer numbers increasing; but also the method can't reflect the bending deformation of the layered material.

采用一般有限元对互层岩体进行数值分析研究时，要求的单元数量多、建模工作量大；并且难以反映层状岩体的弯曲变形特性。

Because of the arch effect, the local bearing strength and the tributary area of locally bleared masonry under load_bearing wall between windows are different from the common masonry, and the calculation formula is put forward and has been revised.

根据混合结构承重窗间墙窗过梁下的局压砌体的内拱效应、局压强度、受荷面积不同于一般楼盖梁端局压砌体的特点，对其承载力计算公式提出探讨并作修正，较好地反映实际情况，同时需作进一步试验和研

The technique of CAE about injection molding is based on polymer processing rheology and conductive calorifics. It simulates the actual process of melt filling, packing and cooling by setting up mathematic and physical models about melt flowing and heat transmitting in the mold cavity, and working out the results by the theory of numerical value analysis. It can also list the processing parameters quantificationally such as pressure, time, temperature, speed, etc, and reflect the results visually by computer figures.

注塑模CAE技术是根据塑料加工流变学和传热学的基本理论，建立塑料熔体在模具型腔中的流动、传热的数学物理模型，利用数值分析理论构造其求解方法，模拟出实际成型中熔体的动态填充、保压、冷却过程，定量地给出成型过程的状态参数(压力、时间、温度、速度等)，并利用计算机图形学的技术，可形象而直观地反映出分析的结果。

This suggests that they are comagmatic. products. formed under different condi-tions, that is, the shallow--seated inclusions came from the chilled border of theupper magmatic chamber while the deep--seated inclusions from the accumula-tive rocks of the lower magmatic chamber.

反映了它们是同源岩浆在不同岩浆作用阶段的产物，即深源包体来自深位岩浆房中的堆积岩碎块，而浅源包体则来自浅位岩浆房的冷凝边碎块。

Certain types of sockets are ''connectionless'', most commonly

某些类型的套接字是无连接的，大多数是UDP协议。

Take it in to his nibs yourself .

你自己拿进去给头儿吧。