压力不足

Hydraulic structure can be often damaged by ice cover and ice pressure at cold areas,and slop protection construction is easier to be damaged by ice.

在寒冷地区，水工建筑物经常会受到冰盖层冰压力的侵害和威胁，而护坡工程往往首当其冲，由于在设计时对冰压力估计不足，致使某些护坡遭受冰压力的作用而损坏。

This paper introduces two working principles for increasing pressure to solve the insufficient pressure in the fire tank .

介绍了解决消防水箱压力不足常用的2种增压设施的工作原理；通过实例计算，说明了2种增压设施的计算内容与计算方法，对2种增压方式的优缺点进行了比较；提出了设计中选用增压方式的原则

A defective oil-pressure indicator may be recording low.

油压表出问题也可显示出机油压力不足。

A low pressure accumulator accumulator nitrogen standard atmospheric pressure of the 7MP. Its main role is to set up a pre-press to ensure that the fuel tank valve 13 to hydraulic cylinders in the main action, and to ensure that reversing valve and main valve between the rapidly reversing.

蓄能器氮气压力不足蓄能器的标准气压为7MP。，其主要作用是建立一个预压，以保证闸阀油缸13先于主液压缸动作，并保证闸阀换向间和主换向阀迅速换向。

Using bevelled punch and step punch in blanking die, carried on the rational distribution to blanking force, reduced the blanking force well which the press equipment need, and the question of insufficient press equipment pressure was solved.

在冲裁模中结合使用斜刃凸模和阶梯凸模，对冲裁力进行合理分配，很好地降低了冲压设备所需的冲裁力，解决冲压设备压力不足的问题。

Generally, the air leakage in condenser can be attributed to tube and valve imprecision of vacuum system or deficiency or even intermittence of steam seal pressure. Besides, it is probably engendered by low-efficient air ejector, which cannot totally extract the air leakage in condenser.

空气漏入凝汽器的原因，通常是由于真空系统管道阀门不严密或汽封压力不足甚至中断所造成的；也可能由于抽气器效率降低，不能将漏入凝汽器的空气完全抽出而造成的。

Reuse axis sheds the circumstance with insufficient fan total pressure, using inclined current fan is first-rate choice.

再应用轴流转风机压力不足的境況下，应用斜流转风机是最好的选取。

The faster-moving air going over the top of the wing exerts less pressure than the slower-moving air under the wing and, as a result, the wing is pushed upwards by the difference in pressure between the top and the bottom.

快速移动的空气将会超过上方的机翼施加压力不足，比慢移动的空气下，机翼和，因此，联队是向上推，由不同的压力之间的顶部和底部。

Injector fuel supply or pressure is not enough, atomization bad, drip, etc.; plunger rod adjustable arm or teeth protruding ears from the governor lever fork slot prolapse in non-oil position; fuel pump plunger and barrel assembly seriously wear and tear, oil pressure is too low, the oil valve wear serious Mifengbuyan; washer crack and deformation, a broken valve spring, injector wear and tear stuck in the closed position.

喷油器不供油或压力不足、雾化不良、滴油等；柱塞调节臂或齿杆凸耳从调速杠杆叉槽中脱出处于不供油位置；喷油泵柱塞偶件严重磨损，供油压力太低，出油阀磨损严重，密封不严；垫圈开裂变形，出油阀弹簧折断，喷油器磨损卡死在关闭位置。

1 ACRII ACRI 序号产品名称 equipment 技术说明 technical specification submit fabrication of the involved components such as main control valve, filter, pressure control valve, pressure measurement meter, flow control valve, leak detection device, quick shut off valve, pressure regulating valve, protection device for insufficient pressure, piping for ignition nozzle, hand-valve, pressure controller, magnet valve, pressure indicator, complying with EU standard and can only apply after the approval of the contractor

其中包含：主燃料供给和控制管路的天然气主关断阀，天然气过滤器，天然气压力调节阀，压力检测表，天然气流量控制调节阀，天然气泄露检测器，快速关断阀，天然气压力恒压器，天然气压力不足保护器等和点火烧嘴燃料控制管路的天然气手动关断阀，天然气压力控制器，天然气电磁阀和流量计等元器件配置依据欧盟标准。

He is the most remarkable man that I have ever known.

他是我知道的人中最值得注意的人。

Increased appearance of lymphocele was noticed in patients with diabetic nephropathy, congenital malformations of the urinary tract, and inflammatory diseases, including glomerulopathy and extraglomerular ones, after high-voltage radiotherapy and after removal of the renal graft.

经过高压放射疗法和切除移植肾后，在糖尿病肾病患者、泌尿系统先天性畸形患者和炎症患者身上发现淋巴囊肿有所增加，包括肾小球病和球外疾病等。