动量

Newton's laws, concepts of momentum, energy, angular momentum, rigid body motion, and non-inertial systems.

牛顿定律，动量的概念，能量，角动量，刚体运动，以及非惯性系。

The use of the free undamped normal modes is seen to ensure that the linear and angular momenta of the distortional motion vanish.

看来采用自由无阻尼正规模态可保证变形运动的线动量和角动量为零。

The original Slashdot article had to do with the anomalous measurements of the muon magnetic moment that cannot be derived from modern theory, and could be further evidence that the Standard Model is invalid, and that the Lorentz invariance it takes for granted cannot be perfectly accurate.

文章中的斜线和小数点符号来自不规则muon的电磁动量测量，这些结果和现代理论不符！将来可以证明经典的模型是无效的，而被人们所认可的罗伦兹不变性也不是完全准确的。

We did our best to get the optimal methods to make the liquid more atomize, and established a model for gas-liquid mass and heat transfer process of cross-flow RPB.

根据气液两相流在多级离心加速雾化条件下流体的动量与质量方程，分析研究液体的雾化程度、液滴粒径、运动速度与方向、停留时间等，研究液相多级分散的级数、分散方式以及离心力场强度对气液相界面积、传质系数以及气相流阻的影响关系及其规律性，探讨沿旋转床径向使液体均匀雾化的最佳方法，建立旋转床中气液两相的运动与传质数学模型。

Technology relatively complicated many throw projects javelin throw, its intact technologies through holding a javelin the run-up win most heavy speed, Join and throw step and get momentums, act on the end of the breaking out type the axis of ordinates of the javelin hard, Make javelin at suitable angle, throw and produce at shoulder javelin.

掷标枪技术是比较复杂的多轴旋转的投掷项目，其完整技术是通过持枪助跑获得最大的速度，连接投掷步获得动量，通过爆发式的最后用力作用在标枪的纵轴上，使标枪能沿着适宜的角度，将标枪经肩上掷出。

So the total ponderomotive force can restrict the electron near the axis of the symmetry.

平面波所特有的空间均匀性保证了被加速电子的动量、能量的一致性。

Barratt Impulsiveness Scale (BIS-11) and State and Trait Anxiety Inventory were used to measure impulsivity and anxiety.

Barratt冲动量表(BIS-11)和状态一特质焦虑问卷测量冲动和焦虑。

Owing to that the main shaft speed and the beating speed of reed can not attain the normal values at setting - on, the warp tension and the beating force of the reed can neither reach the normal level.

织机开关车时由于主轴转速、钢筘打纬速度达不到正常数值，使经纱张力及钢筘打纬力达不到一定的正常数值，以致打纬过程中经纬纱线相对滑移量比织机正常运转时的数值小、共同移动量比正常运转时的数值大，所形成的织物达不到正常的纬密，在织物上产生横档疵点。

Owi ng to that the main shaft speed and the beating speed of reed can not attain the norma l values at setting-on, the warp tension and the beating force of the reed can neither reach the normal level. Therefore, the relative slippage movement of the weft against the warp du ring beating will be less, while the common movement of the weft together with the wa rp will be bigger than those at normal running. As a result, the setting-on place is the n caused by the normal density not being obtainable in the woven fabrics.

织机开关车时由于主轴转速、钢筘打纬速度达不到正常数值，使经纱张力及钢筘打纬力达不到一定的正常数值，以致打纬过程中经纬纱线相对滑移量比织机正常运转时的数值小、共同移动量比正常运转时的数值大，所形成的织物达不到正常的纬密，在织物上产生横档疵点。

According to the company's actual requirement and processing character, a suit of vapor ejector was designed, which are based on hydromechanical basic theory knowledge, Bernoulli equation and theory of momentum.

该文根据公司的实际需要及生产特点，运用流体力学的基础理论知识，从流体流动的总流伯努利方程、动量定理出发，设计出了一套适合本公司的蒸汽喷射器。

It is also known as one of the most poisonous naturally occurring substances.

它也被称为一个最自然发生的有毒物质。

The greatest stress is found at the location on the cross section where V is the largest.

最大应力出现在横截面上V为最大的地方。