查询词典 tube generator

The method is to move the stoving from inside the pellet producing apparatus to one alone stoving furnace outside the pellet producing apparatus. Inside the stoving furnace, there are waveguide tube connected to microwave generator and conveying belt in the bottom, and the pellet is fed to inside cavity of the stoving furnace on the conveying belt, stoved by microwave quickly and discharged on the conveying belt to vertical pellet furnace for roasting.

该方法是将由人造球团矿加工设备内完成的烘干段工艺移出到设备外完成，在设备外单独设置有一烘干炉体，该烘干炉体内腔有波导管与微波发生器连接，在烘干炉体的底部有输送带，球团通过输送带送入烘干炉体内腔，利用微波发生器产生的微波对球团快速加热烘干，经烘干后的球团，通过输送带送至球团竖炉完成焙烧工艺。

The knowledge base of accident management procedure is studied, and realize the accident management procedure of the steam generator heat transfer tube rupture accident.

本文主要对事故规程知识库的设计做了一些探讨，对蒸汽发生器传热管破裂事故的处理规程进行了编程实现，并在模拟器上得到了验证。

Once through big helical tube steam generator is widely used in nuclearpower plant, power equipment, chemical industry and petroleum engineeringequipment.

大盘管直流蒸汽发生器在核电站以及动力、化工、石油等工程设备中有广泛的应用。

A quantification method of the error probabilities for the human failure events in probability safety assess is provided, and it is applied in the error probability analysis for the human actions in the identification and isolation of the ruptured steam generator tube of nuclear power plants.

提出了用环境影响指数来定量计算情景环境迫使人的认知失误的发生概率，给出了概率安全评价中人误概率的分析方法，并用于诊断核电站蒸汽发生器传热管破裂和蒸汽发生器隔离时的人误概率分析。

The length of section of unsaturated heat absorption of entrance of coolant. These offer evidence to optimising the U-shaped tube steam generator by distributing different

本文对换热过程的分析和结果较好地反映了单根换热管的换热情况，具有较强的参考应用价值。

After detailed analyse the main accident of primary loop of nuclear power plant, and refer to accident operation procedure of the nuclear power plant, the thesis raise the abnormal guide operation of steam generator heat transfer tube rupture accident.

本论文在详细分析了核动力装置一回路系统主要事故的基础上，参照核电厂的事故处理规程，提出了蒸汽发生器传热管破裂事故的处理规程。

Taking Huaneng Dezhou Power Plant as an example, some causes leading to low insulation resistance to ground of the bus tube for QFSN3002 type generator have been analysed, and corresponding treatment methods being put forward.

分析了华能德州电厂QFSN3002型发电机汇流管对地绝缘电阻低的几点原因，并提出了相应的处理方法，应用此方法进行检查处理，有效地防止了这类事故的发生，为处理类似事故积累了经验。

At the same time, comparing with the straight tube type stream generator, it can strengthen the effect of heat exchange. Finally, aim at the demand of the nuclear power equipment, the varied rule of some parameters are gained by designing a reasonable control project with the MATLAB and SIMULINK software. The simulation results provide a good foundation for the father research of the integral nuclear power equipment.

最后，针对核动力装置一回路系统要求，设计出合理的控制方案，并将一回路系统中的堆芯、蒸汽发生器以及其相应的控制系统连成一体，运用MATLAB中的SIMULINK仿真软件对其进行变工况动态仿真，得到了一些参数的变化规律，所得结果为进一步研究一体化核动力装置动态仿真系统提供了依据。

The performances of the elliptic tube heat exchanger with vortex generator increased average 16% heat transfer rate, and decreased 20%~ 40% pressure drop, which indicated 16.8% area reduction.

装置涡漩产生器之椭圆形热交换器的热传性能较未装置涡漩产生器的圆管热交换器平均高16%，但压降却反而较低20%~ 40%，而面积缩减率为16.8%。

Wet steam generator tube crack corrosion corrosion control

湿蒸汽发生器；炉管爆裂；腐蚀；防腐

Do not gum up the work by telling mother what we are going to do .

别告诉母亲我们要干的事，那会把事情搞糟的。

In recent years, application of the partial prestressed concrete beam s is developed.

近年来，随着部分预应力砼梁应用的推广，发现我国规范所采用的名义拉应力法的计算结果不稳定。