查询词典 toe crack

When the crack is small, the two -dimensional tomogram can accurately show the crack's position, but its shape and size are different with the actual ones.4. The velocity increases with the decrease of moisture content.

在检测腐朽和空洞时发现腐朽和空洞难以准确区分，当开裂较小时，断层二维图像能够对开裂部位准确显示，但开裂形状和大小与实际开裂情况存在差异。4。

The direction of crack propagation is victual to the direction of maximum stress if the anisotropy of material is sufficiently weak. Universality of fractal dimension of fractured surface would be easy to appear in this case. On the contrary, the crack propagates along the plane with the lowest surface energy.

当材料结构的各向异性特别显著时，裂纹的扩展沿着比表面能最小的方向扩展，这时，断口分维与材料本身的结构有关，表现为断口分维的特殊性；反之，当材料结构的各向异性特别微弱时，裂纹的扩展垂直于最大应力方向，在这种情况下，材料的断口分维与普适性有关。

Results The tissue of 3 cases of ACC in the esophagus was mainly composed of square shape gland epithelial cell and variant myoepithelial cell, mesh shape cavity crack and the tubular, the entity shape arrangement, the cavity crack content basophilia and acidophilia the secretion. There was transmigration of superficial epidermis in 1 case of ACC; All 3 cases were positive of CK, H-CK, P63, S-100 (endochylema /nucleus), EMA, and Bcl-2. Case 3 was positive of CerbB-2 and P53. Case 2 was CD117, AAT, SMA, PAS/AB.

结果 3例食管腺样囊性癌的癌组织主要由立方形腺上皮细胞和变异的肌上皮细胞组成，呈筛孔状腔隙、管状、实体状排列，腔隙内含嗜碱性和嗜伊红分泌物；3例食管腺样囊性癌中例1表面上皮有移行；免疫组化：3例CK、H-CK、P63、S-100、EMA、Bcl-2均，例3 CerBb-2，P53，例2 CD117，AAT、SMA，PAS/AB。

And it can be turned into surface circumferential crack and surface axial crack.

可分解成表面周向裂纹和表面轴向裂纹问题。

And it can be turned into surface circumferential crack and surface axial crack .

套管裂纹缺陷中最危险的是表面裂纹，可分解成表面周向裂纹和表面轴向裂纹问题。

Simulation path is that the inspired coil moves along length direction of the crack, and moves around the center of crack circumferentially.

仿真路径为激励线圈沿缺陷长度方向、经过缺陷中心点进行周向移动。

Simulation paths were that the inspired coil moved along length direction of the crack, and moved around the center of crack circumferentially.

仿真路径为激励线圈沿缺陷长度方向、经过缺陷中心点进行周向移动。

By means of chemical analysis,rigidity test,metallographic examination and fracture analysis,it was found that the main reason for the backup roll's desquamation was possible crack headspring which was offered by impurity in interior tissue.The crack came into being here and then extended outward gradual...

通过对其进行成分分析、硬度测试、金相检验及断口分析，确定了支撑辊剥落的原因：内部组织中夹杂物等提供了可能的裂纹源，裂纹在此产生并逐渐扩展，起初因摩擦磨损在轧辊表面形成轻微点蚀及小块剥落，受到辊型和载荷等其他外部因素的影响，在应力集中部位产生大面积剥落，从而导致轧辊报废。

It is demonstrated that the pipe meets the conditions that the crack is stable and the leakage is detectible which LBB asks for, and it also satisfies the time request from the beginning of leak to the moment at which the crack is unstable.

经验证，该管道符合LBB技术对于裂纹稳定性及泄漏量可探测性的条件，满足从开始泄漏到裂纹失稳的时间要求。

The big size anvil used wax as plasticizer at dewaxing. The main dewax stage from 270℃ to 400℃. Have gas release summit between 400℃ and 750℃. Setting up rational process date at dewax stage can prevent cemented carbide crack. But the crack will appear and impair the quality of products when the microcrack flaw inner compact.

石蜡工艺大制品顶锤在脱蜡阶段，270℃-400℃为成型剂石蜡的主要脱除阶段，400℃-750℃时有气体释放高峰状态，在脱蜡预烧阶段设置合理工艺参数可以防止合金裂纹，但压坯本身若存在微裂纹缺陷，必然会显露出来影响产品质量。

It's bell can reach over a meter in diameter.

它的身体最大可以达到直径1米多。

Now they are overdue and I shall have to pay a fine.

现在他们过期了，我不得不付罚款。