查询词典 tic-tac-toe

The results show that the composite compound observed is mainly composed of TiC, CaS and CeS; the nucleation sequence of the phases during the solidification of the alloy is CeS→TiC→austenite; the (100) crystal plane of CeS and the (001) plane of TiC, and (100) plane of TiC and (001) plane of austenite match perfectly; CeS can act as the heterogeneous nucleating center of TiC, and TiC can act as the nucleating center of austenite.

结果表明：试样中的复合化合物主要由CaS，CeS和TiC组成；合金凝固时的形核顺序为CeS→TiC→奥氏体；CeS及CaS的(100)晶面与TiC的(001)晶面、TiC的(100)晶面与奥氏体的(001)晶面匹配良好；CeS凝固时可作为TiC的异质形核核心，而TiC又可作为奥氏体的形核核心。

Noughts and Crosses (Tic-Tac-Toe) with P - Example of Noughts and Crosses (Tic-Tac-Toe) game with multiple artificial intelligence algorithms.

具有多种人工智能运算法则的Noughts和Crosses (Tic-Tac-Toe)游戏的示例。

After quenching, the phases of the composite are as same as the as-cast composite, but the morphography of TiC particulate was transformed from square to sphere, some TiC particulates coarsen due to the precipitation of the solid-soluble TiC particulates; the other TiC particulates change into the smaller spherical particulates due to the solution of the sharpangled portion of the quadrate TiC particulates.

热处理后，复合材料的相组成不变，但是TiC颗粒由方形变成球形，固溶析出的TiC颗粒在某些TiC颗粒的表面沉积，使后者粗化；另一些方形颗粒的尖角处溶解形成直径更小的球形TiC颗粒。

For the composites with a low content of TiC particle, the rupture manner was mainly the nucleation of cavity and following ductility splitting fracture. But for the composites with a high content of TiC particle, the cracking and decohesion of TiC particles were the main rupture mechanism. For the composite containing a middle TiC content, the rupture mechanism consisted of the above two styles, but the former was the dominating mechanism and the later was the subordinate mechanism.

对TiC体积分数较低的钢基复合材料，拉伸过程中TiC颗粒界面上的孔洞形核及随后塑性撕开机制是其断裂失效的主要机制；对TiC体积分数较高的钢基复合材料，拉伸过程中TiC颗粒的开裂及脱落是其断裂失效的主要机制：对TiC体积分数介于上述两者之间的钢基复合材料，拉伸过程中TiC颗粒界面上的孔洞形核及随后塑性撕开机制在其断裂失效过程中占主要地位，而TiC颗粒的开裂及脱落占次要地位。

The results under the oil lubricate friction conditions were similar with those under the dry friction conditions. The wear mechanism of 3Cr13 matrix alloy was micro-cutting and distorting wear. For the composites with a low fraction of TiC particle, distorting wear dominated and cutting was partly operating. For the composites with a high fraction of TiC particle, stress fatigue wear and wear of hard phase decohesion has occurred, but the main wear mechanism was still distorting wear. When the wear experiments were performed under the oil lubricate friction conditions, the main wear mechanism has became to abrasive wear and fatigue wear for the composites with the low TiC fraction, and fatigue wear would be to dominate for the composites with the high TiC fraction. There were similar wear mechanisms in H13 and 1Cr18Ni9 matrix composites.

在干摩擦条件下，3Cr13基体合金的磨损机理为显微切削和变形磨损；低体积分数的复合材料磨损机制以变形磨损为主，兼有少量的切削磨损机制；高体积分数的复合材料磨损机制以变形磨损为主，兼有应力疲劳磨损和脆性相剥落磨损；在油润滑摩擦条件下，3Cr13基体合金的磨损以磨粒磨损为主；低体积分数的复合材料磨损为磨粒磨损和疲劳磨损；高体积分数的复合材料磨损以疲劳磨损为主。H13、1Cr18Ni9基体及其复合材料的磨损机制类似于3Cr13基体及其相同体积分数的复合材料。

The analyzed results about the forming mechanism of TiC indicate that the dendritical TiC is the primary TiC which freely grows in a continuous growth way in supercooling liquid metal before the peritectic reaction, and the short bar-like TiC nucleates and grows in β—Ti after peritectic reaction.

在对TiC形成机制的分析中认为，树枝状TiC是包晶反应之前过冷熔体中，以连续生长方式自由生长而成的初生TiC，而短棒状TiC则是包晶反应后在β-Ti的内部生核并长大而成。

The results show that TaC with form of coating enwrap evenly and compactly around with the carbon fiber in C/C-TaC composites and form the cannular microstructure, both the average strength and toughness of C/C-TaC composites sample increase apparently.

结果表明：C/C-TaC复合材料中TaC以涂层形式均匀致密地包覆在炭纤维周围，形成管状微观结构，大大提高C/C-TaC复合材料试样的平均强度和韧性。

By the combination of experimental results with theory of crystal growth, some growth models and growth mechanisms were proposed. Research results confirmed that pillar-shaped TaC whisker with spherical droplet at the end grew via a vapor-liquid-solid mechanism, pillar-shaped whisker with pyramid-like end was formed via a vapor-solid mechanism, awl-shaped TaC whisker with zigzag end formed via a liquid-solid mechanism, awl-shaped TaC whisker with growth step at the end has a growth mechanism of screw dislocation mechanism. The growth mechanism of dumbbell-shaped MgO nanowhisker and NaCl particle-decorated MgO nanowhisker is VS; C and MgO powder-yielded MgO nanowhisker was formed via a VLS mechanism, Mg powder-yielded MgO microwhisker and MgO microsized or nanosized crystal sheet grew via a VS mechanism. In the Si and SiO〓 nanostructures, Si nanowires formed in higher-temperature zone grew via oxide-assistant mechanism, while Si nanowires or nanorods formed in lower-temperature zone have a growth mechanism of VLS, and the growth mechanism of SiO〓 nanowires is VS.

研究确定呈平直柱状且头部带有球形颗粒的TaC晶须是通过气-液-固机制生长；头部呈之字型的锥状TaC晶须则通过液-固机制生长；晶须头部为四棱锥状的粗长TaC晶须的生长机制是VS机制；顶端呈锥状且有生长台阶的TaC晶须通过螺位错机制生长；哑铃状氧化镁晶须和氯化钠颗粒修饰的氧化镁纳米晶须的生长机制是气-固机制：当采用C+MgO粉提Mg源时形成的氧化镁纳米晶须的生长机制是VLS，而采用直接热蒸发Mg粉时得到的氧化镁微米晶须的生长机制为VS，纳米和微米晶片的生长机制均为VS机制；在高温区，硅纳米线的生长机制是助氧化机制，在低温区硅纳米线和纳米棒的生长机制是VLS机制，而氧化硅纳米线的生长中VS机制占主导地位。

Compared with that of 3Cr13 alloy, the oxidation resistance of the composites containing 5 vol.％TiC particle was improved greatly at 850℃, but the improvement was relatively limited at 950℃. But the oxidation resistance of 1Cr18Ni9 composites containing 5 vol.％ TiC particle was obviously improved at 950℃, and at 850℃ the improvement is not large. The TiC particle can improve the oxidation resistance mainly was by developing the oxidation selectiveness of the Cr element as to change the phase constitution of the oxidation film, to alleviate the production of the stress in the oxidation film and to improve the cohesive force of the oxidation film or matrix interface and the chemical combination of the oxidation film.

与3Cr13合金相比，含5％volTiC颗粒的复合材料在850℃的抗氧化性能得到大幅度提高，而在950℃复合材料的抗氧化性能提高作用却是有限的；与1Cr18Ni9合金相比，含5％volTiC颗粒的复合材料在850℃的抗氧化性能略有提高，而950℃复合材料的抗氧化性能提高却是明显的；TiC颗粒可以提高两种基体合金抗氧化性能，主要是通过促进Cr的选择性氧化，进而改变氧化膜的相组成、减缓氧化膜内应力的产生、增加氧化膜/基体界面凝聚力及提高氧化膜化学结合力而实现的。

The results have shown that Ti-6Al-1.8C is composed of Ti and TiC reinforcements that are of two different morphologies: coarse dendritical primary TiC and short bar-shape eutectic TiC.

结果表明：在Ti-6Al-1.8C中主要存在Ti和TiC两种相。

His female bullfighter Lydia gradually Health love, but she was in a vegetative state after the Bulls Zhuangcheng away from her, just because Lydia's ex-boyfriend showed more affectionate than he is like love.

他对女斗牛士莉迪亚渐生爱意，却在她被公牛撞成植物人后离她而去，仅仅因为莉迪亚的前男友表现出好似比他更深情的爱。

I know of none which are not easy to answer, but what I am trying to do now is only by a series of hints to throw some light on the narrow path of legal doctrine, and upon two pitfalls which, as it seems to me, lie perilously near to it.

我不认为有什么难以回答的问题，但我现在要做的仅仅是通过一系列线索，来给法律理论的狭窄路径以及在我看来离它近得危险的两个陷阱提供一些启示。