查询词典 thickness

The results indicated that the strength of corner joints increased with the increase, of thickness, density, moisture content, MOR and IB of the board, and that the measure of coefficient of variability for MOR and IB of the board would play a more important role in the stability and strength of corner Structure in furniture.

本试验中，以木质圆榫不可拆连接角结构抗变形强度和偏心凸轮连接角结构抗破坏变形强度为最高，试验的综合结果表明，可拆型连接的角结构强度总是低于不可拆型连接的角结构；角结构承受拉载的能力明显低于承受压载的能力。

Then the experiment of the thickness and deviation dependent shows the continue networks model is more seemlier, in which the amorphous lattice is the same of a single crystal, but its bond distance and bond angle have a little change.

而我们的池厚与分散度关系的实验已说明了厚池中键长键角不归一，当小球标准差为8.4％时，键长键角的变化可以用连续网络的非晶模型来描述，此模型的非晶结构的骨架与单晶相同，但键长键角有小量的无规性。

According to experimental data, the ultimate bond stress and bonding-slipping constitutive relation are presented based on the thickness of protection layer and effective bond length.

根据试验数据回归出基于相对保护层厚度和相对有效粘结长度的极限粘结应力计算公式和粘结应力与滑移的本构关系式。

You can change the border thickness and set it to a " double " line.

你可以改变边沿的厚度，把它设置为一个"双的"线条。

The thesis is organized as follows:In Chapter 1,a new partial differential equation model for Spontaneous Potential log in heterogeneous formations is introduced.At the same time,the existence and uniqueness of weak solution to the problem are proved,and the problem of resistance identification in SP log is studied.Furthermore,a jump condition capturing finite difference scheme is proposed and applied to solve such elliptic interface problems.The effects of various factors on SP response,which include objective layers resistivity,bed thickness,bore-hole diameter,invasion and water-flooded zones and so on,are investigated quantitatively by the proposed method, and satisfactory results are obtained.

具体安排如下：第一章首先建立复杂地层中自然电位测井的偏微分方程数学模型，证明了该边值问题弱解的存在唯一性，在此基础上研究了自然电位测井电阻率识别问题：然后发展了用于求解椭圆交界面问题的间断捕捉有限差分方法，利用该方法定量分析了目的层电阻率、地层厚度、井径、侵入带和水淹层等因素对自然电位测井响应的影响，取得了满意的结果。

Thickness,and microstructure of the boride layer have been investigated by an Olympus optical microscopy and X-ray diffractorneter.

采用Olympus光学显微镜和X射线衍射分析渗硼层厚度和渗层组织。

The method of orthogonal experiment was used to investigate the effect of parameter of boronizing process on the thickness of the boride layer.

运用正交实验法来确定渗硼工艺的参数(渗硼温度、渗硼时间、稀土加入量和铬加入量)对渗硼层厚度的影响，从而确定合理的渗硼工艺。

The contour diagram of the boride layer thickness of the steel 45 boronized with 5%Nd2O3 addition was built according to experimental data.

根据所得数据建立了45钢在添加w（Nd2O3）=5％稀土渗硼时的渗硼层等厚线图。

Made of finest optical borosilicate glass, with uniform thickness and size

由材质最好的硼硅玻璃制成，厚度和尺寸均一性好

The results indicate that the bottom surfacetemperature increases as current density, thermal conductivity, specific electric resistance and steelmaking temperatureincrease, and decreases as the bottom thickness and the heat change coefficient on boundary between shell and air increase.

揭示出底表面温度随电流密度、材料热导率、电阻率及炼钢温度增加而增加，随传热系数和底厚度增加而降低的关系。

It was just a normal day of school

那只是上学的普通一天

Which is a very good reference in this issue.

这是一个在这个问题上很好的参考。