查询词典 tangential section

Effects of Coriolis force were analyzed with the three dimensional simulations and the following conclusions were drawn: The tangential component of Coriolis force induces cross stream secondary flow in the form of two-cell pattern,while the radial component of Coriolis force decelerates and accelerates the cent...

计算结果表明，切向哥氏力推动了通道截面内的双涡二次流，径向哥氏力则使得近侧壁流体加速和中心流体减速。换热计算结果从定性趋势上吻合公开文献中的实验现象，反映了旋转附加力的基本影响规律。

The larger the handrim, the greater the moment about the wheel axle M could attain. The tangential force F applied to the handrim was similar among three handrim diameters. However, the radial component of force applied to the handrim increased as handrim diameter decreased.

结果发现，轮圈直径越大，最大前进力矩越大；不同轮圈直径，施加在轮圈的切线分力相似；但轮圈直径越小，施加在轮圈的轴向分力却越大；而轮圈直径越大，有效分力比率也越大。

By the definition of Darboux type vector and rectifying Darboux type vector ,we constructed the rectifying type developable surfaces and Darboux type developable surfaces and tangential Darboux type developable surfaces ,and study these three developable surfaces relationship with Minkowski slant helices and Minkowski conical geodesic curves. Bying applying the singularity theoerical knowledge, We give a classification of special developable surfaces under the condition of the existence of such a special curve as geodesic.

通过定义三维Minkowski空间中的达布型向量以及修正达布型向量，构造出三维Minkowski空间中的三类可展曲面，即修正型可展曲面、达布型可展曲面和切达布型可展曲面，研究Minkowski斜螺线和Minkowski锥面测地线这两种特殊曲线和这些曲面的关系，并研究Minkowski斜螺线和Minkowski锥面测地线作为这些曲面的测地线的条件下，运用奇点理论的知识，对这三种可展曲面进行奇点分类。

A trial and error method is suggested, and comparisons with the secant stiffness method and the tangential stiffness method are made in the paper.

本文提出了利用基于一系列线弹性有限元解来获得弹塑性材料结构的极限承载能力的试验误差法，并将它与切线法和割线法进行了比较和讨论。

Three optimal structures were gotten in this paper by the model of elastic modulus along the grain, elastic modulus in tangential direction, in-plane shearing modulus and laminate rigid:①0/90/0/90/0/90/0/90/0, the outside four veneer is modified, the along grain MOE and MOR are 8377MPa, 60.9MPa respectively; The across grain MOR is 35.1 MPa, and TS is 17.2%.

4通过应用杨木单板顺纹弹性模量、横纹弹性模量、面内剪切模量及层合板刚度模型进行杉木胶合板结构设计，经多次修正，得出较好结构有以下几组：①0/90/0/90/0/90/0/90/0，最外四层为杉木改性单板，顺纹弹性模量和静曲强度分别达到了8377MPa，60.9MPa；横纹静曲强度为35.1 MPa，吸水厚度膨胀率为17.2%。

At present, my Department also additional Slitter foil can be divided into tangential 0.006 - 0.03, such as the aluminum foil.

目前，我司还增设铝箔分切机，可分切0.006--0.03的铝箔等。

By using shape analysis,stereoscopy and moment of image,a number of eigenquantumwere extracted,such as radial diameter,tangential diameter,length and area of lumen,complexof cell,comers of edge and convex-concave properties.At the same time,the algorithm ofextraction and statistical analytic methods of pattern features were put forward.

利用形态分析、体视学及图像的矩来提取如早、晚材细胞的径向、弦向直径、管胞长度、面积、密质度及边缘的角、凹凸性等特征量，并提出了这些模式特征的提取算法和统计分析方法。

In addition, these tangential air separators can be supplied with a stainless steel strainer to collect unwanted system separators

我们有完全合格的技术人员可帮助提供切实可靠的解决方案，满足您对水和暖气的需求。

The degree of separation between the posterior dural sac and its subjacent lamina was ealuated within a range defined medially by the point of junction with the lamina and laterally by a tangential line along the medial aspect of the pedicle.

以从内侧的椎板接合处至外侧的椎弓根内面切线定为测定的范围来评价后硬膜囊与邻近椎板之间的分离程度。

This paper deals with the characteristics of tangential shrinkage stresses of Japanese sugi during drying under superheated steam.

本文研究了日本柳杉在高温高压过热蒸汽干燥过程中，所伴随的弦向收缩应力的发生发展特征。

In this new architectural plan the Garden of Golgotha came to be at the centre of the new city.

Aelia 是高举他自己，并在此城内朝拜罗马诸神。

The continuous nature of peat accumulation means that terrestrial coaly rocks may provide a higher resolution and more complete record of base-level change than the time-equivalent shallow-marine strata, thus enabling the identification of highfrequency cycles that are not recorded in themarine strata.

泥炭积累的持续性质的手段，陆地coaly岩石可提供较高的分辨率和更完整的记录基准面变化的影响时，相当于浅海阶层，从而使确定的高频周期，不记录在themarine 阶层。