查询词典 solidification

The measured dynamitic solidification curve shows that the mushy zone become wider with the increase of Al amount and fluidity decreases as the well developed dendrites hinder the flow of the liquid alloy.

合金的液相线温度随Al量的增加而降低，Al含量从24%增至35%时，其过热度约增加1倍。

In order to increase proportion of equiaxed grain of billet and homogeneity of solidification structure,a great many liquid metal nucleation stirred by vibration experiments were carried out with zinc.

为提高铸坯的等轴晶率和凝固组织的均匀性，以金属锌为研究对象进行了大量的振动激发金属液形核实验。

By applying electromagnetic vibration on solidification front of Sn-10Pb alloy,creation of equiaxed grain zone in ...

在低强度电磁振荡条件下，凝固组织细化和等轴晶化的原因是：电磁振荡力对金属初生晶的周期性拉伸、压缩、剪切、折弯、扭转等机械作用，使其出现断裂和剥落，增加形核数量；电磁振荡的局部搅拌作用使固/液界面前沿的温度和成分趋于均匀化，导致梯度降低，抑制了柱状晶的生长。

On the industrial experiments the effect of electromagnetic stirring on central porosity ,equiaxial crystal ratio,shrinkage cavities and surface quality as well as effect of electromagnetic stirring on the solidification of the continuous casting billet have been analyzed and discussed.

根据工业试验结果，分析了结晶器电磁搅拌对马氏体不锈钢连铸坯的中心疏松、等轴晶率、缩孔及表面质量的影响，并对电磁搅拌对铸坯凝固的影响机理进行了探讨。

The microstructure of supercooling solidification is made up by four characteristic regions, from the sample bottom to top are: fine equiaxial dendrites, transition from fine equiaxial dendrites to columnar dendrites, columnar dendrites and coarse equiaxial dendrites.

5深过冷定向凝固的微观组织由四个特征区域组成，从试样底部到顶部依次为：细等轴晶区，细等轴晶→柱状枝晶的过渡区，柱状枝晶区和粗等轴晶区。

Solute diffusion controlled solidification model was employed to simulate the columnar to equiaxial transition of TiAl alloy casting. The simulation results show that solute shock wave occurs when the diffusion fields of columnar and equiaxial dendrites meet.

利用溶质扩散控制模型对TiAl合金柱状晶/等轴晶转变过程进行了数值模拟，结果表明，等轴晶在柱状晶前沿形核及生长过程中，当两个扩散场相遇时，观察到成分冲击波，它可能是导致柱状晶停止生长的一个主要原因。

The Solidification temperature range was defined as 110-200℃ by DSC analysis. More accelerant used can increase the casing samples dynamic performance, but more than enough accelerant can induce a severe solidified reaction that result in a smaller polymeric meshwork and reducing the sample's performance. Normally the Accelerant dosage can be 2 portions; The Epoxy resin CFRP has a obvious better performances than the Vinyl-ester Resin CFRP, i.e. had a Bend Strength of 1516MPa, LSS of 85MPa, also Tg raised to 195~C~ When used the end-carboxyl polyether to reinforce the epoxy resin, the casing sample's SS, BS and Crack Elongation all increased geminately. The CFRP performance also increased a little, that is because the performance of the CFRP mainly contributed by the CF. The reinforced resin improved the interface between the CF and resin that contribute to the little increasing.

通过DSC分析确定了该环氧树脂的固化温度范围为110~200℃，促进剂增加会提高浇注体力学性能，但过多的促进剂会使固化反应剧烈，聚合网络减小，使浇注体性能下降，一般用量为2份左右；以环氧树脂为基体的复合材料性能明显比以乙烯基酯树脂的性能提高，弯曲强度达到1516MPa，层间剪切强度达到85MPa，同时Tg也上升到195℃；用端羧基聚醚增韧环氧树脂后，其浇注体的拉伸强度、弯曲强度及断裂伸长都成倍增加，复合材料的性能也有所提高，但提高幅度不大，因为复合材料的力学性能主要由碳纤维承担，树脂增韧后改善了复合材料的界面性能。

The results show that Si element has an effect on facilitating carbon atoms to solute in Fe-Al-C liquid alloy and to graphitize in the process of solidification, which can solution strengthen the alloy matrix.

结果表明：Si可以促进C原子在Fe-Al-C液态合金中熔入及凝固过程中的石墨化，对Fe3Al基体有固溶强化作用。

Computation was made to investigate the solidification points of three isomers of hexadecane and the mixtures of hexadecane with two different alkyl naphthalenes by molecular dynamics.

利用分子动力学模拟手段对十六烷的3种异构体及添加烷基萘的混合物的凝点进行计算。

Computation was made to investigate the solidification point s of three isomers of hexadecane and the mixtures of hexadecane with two different alkyl naphthalenes by molecular dynamics.

利用分子动力学模拟手段对十六烷的3种异构体及添加烷基萘的混合物的凝点进行计算。

He got into race cars, while my father liked go-karts more, so I didn't really pay attention to what Diego was doing, as I was just racing karts.

叔叔开的是跑车，而我父亲更喜欢越野卡丁车，所以我并不太关注Diego在做什么，我仅仅在跑我的卡丁车而已。

She is at present gone to look for the best nectar and ambrosia to regale me this evening.

她今晚为款待我，现在又去准备美酒佳肴去了。